1016 SERIES INSTALLATION, OPERATION, MAINTENANCE & PARTS

Transcription

1 LIMITED WARRANTY CHEVRON, INC., ("Chevron"), warrants to the original purchaser that each new Chevron product will be free from defects in material and workmanship for a period of twelve (12) months from date placed in service. The purchaser must promptly notify Chevron in writing of any failure in material or workmanship. In no event shall Chevron accept such notification later than twelve (12) months from date placed in service. Chevron's obligation under this warranty, statutory or otherwise, is limited to the repair or replacement at the Chevron factory, or at a point designated by Chevron, of such part or parts as shall appear upon inspection by Chevron to be defective in material or workmanship. New or remanufactured parts will be used for any replacement at Chevron's option. This warranty is not transferable. This warranty does not obligate Chevron to bear the cost of labor or transportation charges in connection with the repair or replacement of any parts found to be defective, nor shall it apply to a product upon which repairs or alterations have been made unless authorized by Chevron. EXCEPT AS EXPRESSLY SET FORTH IN THIS WARRANTY, CHEVRON MAKES NO OTHER WARRANTY, EXPRESS OR IMPLIED, AND HEREBY DISCLAIMS ALL OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Chevron shall in no event be liable for claimed downtime, claimed loss of profits or good will, or any other special, incidental, indirect, or consequential damages concerning or relating to any product or parts, whether based on negligence, strict liability, breach of contract, breach of warranty, misrepresentation or any other legal theory, regardless of whether the loss resulted from any general or particular requirement which Chevron knew or had reason to know about at the time of sale. OWNER'S MANUAL 1016 SERIES INSTALLATION, OPERATION, MAINTENANCE & PARTS NOTE: MANUAL including SPECIFICATIONS, subject to change without notice. All ratings specified are based on structural factors only, not vehicle capacities or capabilities. Carriers & Wreckers 7320 W. Market Street Mercer, PA Phone (724) FAX (724) Toll Free (800) PART NO. OMC0614 CHEVRON MAKES NO WARRANTY, EXPRESS OR IMPLIED, AS TO THE FINISHED PRODUCTS MANUFACTURED OR SUPPLIED BY ANOTHER MANUFACTURER AND SUPPLIED BY CHEVRON TO PURCHASER, including, but not limited to, any vehicle to which a Chevron product may be affixed or any accessories or wire rope, and CHEVRON EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AS TO SUCH EQUIPMENT OR PRODUCTS. This language shall in no way affect or diminish the rights of the purchaser to rely on such warranties as are extended by such manufacturers or suppliers. Chevron shall, to the extend permitted under applicable law, pass on to the purchaser such manufacturer's or seller's warranty. Chevron, whose policy is one of continuous improvement, reserves the right to improve its products through changes in design or materials as it may deem desirable without being obligated to incorporate such changes in products previously sold. This warranty is not intended to cover or include the following items, which are set forth by way of example and not limitation: A. Normal deterioration of trim, paint, lettering, and appearance items due to wear or exposure to weather, road conditions, road treatments, etc. B. Any damage or defect due to accident, misuse, abuse, operation exceeding rated loads, improper or unauthorized repairs, failure to provide reasonable and necessary maintenance, or uses of which the equipment was not designed or intended. C. Alterations or modifications that affect performance, operations or reliability. D. Normal maintenance parts including, but not limited to, wear pads, bushings, wire rope, mudflaps, fenderettes, light bulbs, hydraulic oil, filters, and tow sling belts. IT IS EXPRESSLY UNDERSTOOD THAT CHEVRON MAKES NO IMPLIED WARRANTY THAT CHEVRON PRODUCTS SHALL BE FIT FOR THE PURPOSE OF LIFTING OR MOVING PEOPLE OR FOR ANY OTHER IMPROPER USE.

2 LIMITED WARRANTY CHEVRON, INC., ("Chevron"), warrants to the original purchaser that each new Chevron product will be free from defects in material and workmanship for a period of twelve (12) months from date placed in service. The purchaser must promptly notify Chevron in writing of any failure in material or workmanship. In no event shall Chevron accept such notification later than twelve (12) months from date placed in service. Chevron's obligation under this warranty, statutory or otherwise, is limited to the repair or replacement at the Chevron factory, or at a point designated by Chevron, of such part or parts as shall appear upon inspection by Chevron to be defective in material or workmanship. New or remanufactured parts will be used for any replacement at Chevron's option. This warranty is not transferable. This warranty does not obligate Chevron to bear the cost of labor or transportation charges in connection with the repair or replacement of any parts found to be defective, nor shall it apply to a product upon which repairs or alterations have been made unless authorized by Chevron. EXCEPT AS EXPRESSLY SET FORTH IN THIS WARRANTY, CHEVRON MAKES NO OTHER WARRANTY, EXPRESS OR IMPLIED, AND HEREBY DISCLAIMS ALL OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Chevron shall in no event be liable for claimed downtime, claimed loss of profits or good will, or any other special, incidental, indirect, or consequential damages concerning or relating to any product or parts, whether based on negligence, strict liability, breach of contract, breach of warranty, misrepresentation or any other legal theory, regardless of whether the loss resulted from any general or particular requirement which Chevron knew or had reason to know about at the time of sale. OWNER'S MANUAL 1016 SERIES INSTALLATION, OPERATION, MAINTENANCE & PARTS NOTE: MANUAL including SPECIFICATIONS, subject to change without notice. All ratings specified are based on structural factors only, not vehicle capacities or capabilities. Carriers & Wreckers 7320 W. Market Street Mercer, PA Phone (724) FAX (724) Toll Free (800) PART NO. OMC0614 CHEVRON MAKES NO WARRANTY, EXPRESS OR IMPLIED, AS TO THE FINISHED PRODUCTS MANUFACTURED OR SUPPLIED BY ANOTHER MANUFACTURER AND SUPPLIED BY CHEVRON TO PURCHASER, including, but not limited to, any vehicle to which a Chevron product may be affixed or any accessories or wire rope, and CHEVRON EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AS TO SUCH EQUIPMENT OR PRODUCTS. This language shall in no way affect or diminish the rights of the purchaser to rely on such warranties as are extended by such manufacturers or suppliers. Chevron shall, to the extend permitted under applicable law, pass on to the purchaser such manufacturer's or seller's warranty. Chevron, whose policy is one of continuous improvement, reserves the right to improve its products through changes in design or materials as it may deem desirable without being obligated to incorporate such changes in products previously sold. This warranty is not intended to cover or include the following items, which are set forth by way of example and not limitation: A. Normal deterioration of trim, paint, lettering, and appearance items due to wear or exposure to weather, road conditions, road treatments, etc. B. Any damage or defect due to accident, misuse, abuse, operation exceeding rated loads, improper or unauthorized repairs, failure to provide reasonable and necessary maintenance, or uses of which the equipment was not designed or intended. C. Alterations or modifications that affect performance, operations or reliability. D. Normal maintenance parts including, but not limited to, wear pads, bushings, wire rope, mudflaps, fenderettes, light bulbs, hydraulic oil, filters, and tow sling belts. IT IS EXPRESSLY UNDERSTOOD THAT CHEVRON MAKES NO IMPLIED WARRANTY THAT CHEVRON PRODUCTS SHALL BE FIT FOR THE PURPOSE OF LIFTING OR MOVING PEOPLE OR FOR ANY OTHER IMPROPER USE.

3 DIRECT MOUNT TANDEM PUMP TANDEM PUMP 15 GPM x 15 GPM CH0 1-1/4 x 3 NPT NIPPLE C90 1-1/4 x 90 M-F O-RING ADAPTER C91 1 M O-RING x 3/4 MJIC x 90 2 V-1

4 1016 MODULAR BOX COMPONENTS V-2

5 1016 MODULAR BOX COMPONENTS INCH TUNNEL BOX L MODULAR BOX - DRIVER SIDE 120 CA L MODULAR BOX - DRIVER SIDE 108 CA R MODULAR BOX - PASSENGER SIDE 120 CA R MODULAR BOX - PASSENGER SIDE 108 CA MODULAR BOX FRONT CROSSMEMBER L CROSSMEMBER MOUNTING BRACKET - LEFT R CROSSMEMBER MOUNTING BRACKET - RIGHT FRONT DOOR REAR DOOR CA REAR DOOR CA ROTARY PADDLE LATCH DOOR HINGE A0 WHEEL RETAINER STORAGE GUARD L WHEEL RETAINER LOCK PIN - LEFT R WHEEL RETAINER LOCK PIN - RIGHT MARKER LIGHT GROMMET R RED REFLECTIVE MARKER LIGHT A AMBER REFLECTIVE MARKER LIGHT TAIL LIGHT GROMMET R TAIL LIGHT BACKUP LIGHT 2 V-3

6 1016 SUBFRAME COMPONENTS V-4

7 1016 SUBFRAME COMPONENTS Section V - PARTS 1016 AIR VALVES SUBFRAME FRONT ACCESS COVER REAR ACCESS COVER STABILIZER ACCESS COVER 2 5 7A211 CONTROL KNOB A168 CONTROL HANDLE /8 JAM NUT PIN.980 x I RETAINING RING 1.00 INTERNAL G AIR VALVE ASSEMBLY /2 TON SHACKLE AND SCREW PIN UHHW WEAR PAD UHHW WEAR PAD MUDFLAP BRACKET 2 15 A1070 MUDFLAP 24 x INNER STABILIZER TUBE STABILIZER CYLINDER PIN.980 x I RETAINING RING 1.25 EXTERNAL STABILIZER POD PIVOT PIN STABILIZER POD STABILIZER POD POSITION PIN LYNCH PIN CLEAT FRONT MOUNTING BRACKET MIDDLE MOUNTING BRACKET RUBBER GASKET A AIR VALVE MOUNTING PANEL AIR VALVE TOGGLE GUARD 2 3 AA876 AIR VALVE CONTROL PANEL AIR VALVE 4 5 PUSH-ON AIR FITTING-STRAIGHT 04X /8 NPT PLUG 4 7 SCREW x 3/4 8 V-5 V-6

8 1016 RECOVERY BOOM COMPONENTS V-7

9 1016 RECOVERY BOOM COMPONENTS 1 6I6020 INTEGRATED BOOM OUTER 1 2 6I6050 INNER BOOM TUBE 1 3 6I6070 UNDERLIFT OUT TUBE BOOM EXTENSION CYLINDER NYLATRON WEAR PAD 1/2 x 2 x I602G PIN x I RETAINING RING 1.25 INTERNAL BOOM END SWIVEL PULLEY 7 INCH PULLEY BOLT NUT NYLON LOCK CABLE FOLLOWER E RETAINING RING 3.50 EXTERNAL I6330L TRUNNION BRACKET - LEFT I6330R TRUNNION BRACKET - RIGHT BOOM LIFT CYLINDER UNDERLIFT TILT/FOLD CYLINDER D PLANETARY WINCH 15,000 LB A90210 CABLE TENSIONER PLATE 2 20 A90214 SPRING PLATE 2 21 A90215 MANDREL 2 22 TENSIONER TORSION SPRING LH 1 23 TENSIONER TORSION SPRING RH I602F PIN x E RETAINING RING 1.25 EXTERNAL BOOM ANTLER I60370 PIN x PIN x I6048 PIN x I RETAINING RING 2.00 INTERNAL UHMW WEAR PAD 1/2 x 4 x CABLE TENSION SPRING I6049 PIN x 12, I6078 PIN x I6079 PIN x CAP SCREW 5/16 x 7/ FLAT WASHER 5/16 2 V-8

10 1016 UNDERLIFT COMPONENTS V-9

11 1016 UNDERLIFT COMPONENTS 1 6I6080 INNERTUBE WELDMENT WHEEL LIFT EXTENSION CYLINDER 1 3 6I607A GRAVEL GUARD WEAR PAD NYLATRON 1/2 x 2 x CROSSBAR PIVOT PIN I RETAINING RING 2 INCH INTERNAL PIN x 6-5/ I RETAINING RING 1.25 INTERNAL 2 9 6I6090 CROSSBAR I60950 CROSSBAR EXTENSION CROSSBAR EXTENSION PIN L WHEEL GRID - LEFT R WHEEL GRID - RIGHT T-PIN WITH LANYARD 3/4 x L LEFT L-ARM R RIGHT L-ARM REMOVABLE WHEEL PAN /16 SAFETY SNAP PIN A RATCHET WHEEL STRAP SPRING SHACKLE ADAPTOR T-PIN 3/4 x INCH FRAME FORK INCH FRAME FORK OFFSET FORK HOLDER - RIGHT OFFSET FORK HOLDER - LEFT P T-HANDLE FORK HOLDER-ELEVATED A210R CHAIN HOOK ADAPTER-RIGHT A210L CHAIN HOOK ADAPTER-LEFT 1 V-10

12 5TH WHEEL AND PINTLE HITCH GROUP G PINTLE HITCH GROUP W PINTLE HITCH WELDMENT 1 2 A3020 TOW BALL PINTLE HITCH RETAINING PIN A6 3/8 x 5/8 BUTTON HEAD BOLT 4 5 5A220 LANYARD BOLT 1/2-13 x 1.25 GRADE 5 OR /2 LOCK WASHER TH WHEEL ASSEMBLY RETAINING PIN 2 V-11