SOLENOID VALVES / DIRECTIONAL CONTROL VALVES

Transcription

1 OM SOLENOID VLVE HD1N SIZE 025 Fetures HD1 N Series (for 7 M) 1. ompct 2. Dust- nd wter-proof of highest level (I67), thnks to use of M12-4 pin connector 3. Since it opertes t low currency, it cn e connected directly to the sequencer nd is comptile with device net. 4. Lmp nd grounding terminl re stndrd equipment. 5. Surge killer is stndrd equipment. lese red the Operting Mnul utions on use crefully to ensure correct usge. he piping must e rrnged so tht the R port is lwys filled with fluid to mke the most of the fetures of the oil-immersed type vlve. When instlling no-spring type vlve, instll it so s to set the spool horizontlly. Finish the mounting fces to the sme qulity s the vlve fces (3.2 mrz). Using vlve with the R port plugged cn cuse opertion filure. When it is retined without energizing the solenoid on detent type, the ck pressure must e 2 M or less. Description of the model designtion 17 Switching function 3W : Spring center type 2WD: No spring detent type 2S : Spring offset type Nominl size 025: onforming to ISO Vlve specifictions Mx. operting pressure Mx. flow rte M L/min 7 30 ermissile port ck pressure M 7 (2) (NOE 1) Opertion frequency (time/s) 2 or less ermissile vrile voltge rnge rotection structure clss Hydrulic fluid contmintion Hydrulic fluid (recommended) V Rted voltge ±10% IE 529 I65 (I67) (NOE 2) omplying with ISO11218lss 12 (NS1638 lss 12) ISO VG22, 32, 46 Viscosity Fluid temperture mient temperture roper tightening torque Mss 2 /s N m 15 to to to 50 6 to 8 3W, 2WD: 1.52S: 1.2 NOE 1: Vlue in ( ) is for the no spring detent type. NOE 2: he protection structure clss (I67) is for M12-4 pin connector type. Optionl function (D type only) For wire-sving type (with M12-4 pin connector) : Lod side OMMON right side : Lod side OMMON left side : Lod side +OMMON right side D: Lod side +OMMON left side With diode S: Lod side -OMMON : Lod side +OMMON Voltge indiction 1: 100V 2: 200V D2: SOLENOID VLVES / DIREIONL ONROL VLVES 21

2 Solenoid specifictions Solenoid model Rted voltge V 100 SLH1N SLH1N SLH1N025D2 D24 Frequency Hz 50/ /60 60 Strting current 0.92/ / Holding current 0.26/ / SOLENOID VLVES / DIREIONL ONROL VLVES erminl ox Size 025 D type Size 025 type Spool types Switching function Model Spool type Solenoid model HD1 N******025D2 HD1 N******025D2 S HD1 N******025D2 HD1 N******025D2 HD1 N******025D2 HD1 N******025D2 HD1 N******025D2 D Vlve performnce Solenoid 1 HD1 N****** W 3WG Spring enter HD1N3W*025* Rted voltge Rted voltge 100V 100V NOE: When model not listed ove is necessry, consult us seprtely. 2WDc Doule Solenoid ype H1N025D1W H1N025D1WS H1N025D1W H3025D1W-M H3025D1W-M H3025D1W-M H3025D1W-MD Doule Solenoid ype H1N0251W No Spring Detent HD1N2WD*025* erminl ox Single Solenoid ype H1N025D1S H1N025D1SS H1N025D1S H3025D1S-M H3025D1S-M H3025D1S-M H3025D1S-MD erminl ox Single Solenoid ype H1N0251S 2Sc Spring Offset HD1N2S*025* Opertion Limit (Dynmic Viscosity: 33 2 /sec) he performnce will vry slightly depending on the circuit conditions nd the opertion conditions (voltge, pressure, flow, viscosity, etc.). he performnce curves show vlues including the surge pressure nd surge flow rte. L/min Flow ressurem Spool ype ircuit 3W 3WG 2WDc 2Sc ylinder circuit port locked D D NOE: Where used out of the operting rnge, consult us. NOE port locked D NOE 22

3 Outside dimensions Stndrd type HD1N**025* HD1N**025D2S HD1N**025D2 HD1N**025D2 4JIS O-ring Wiring hole 2 G1/ Solenoid instlltion/removl dimension M12-4 pin connector type HD1N**025D2 HD1N**025D2 HD1N**025D2 HD1N**025D2D OYOOKI Solenoid instlltion/removl dimension JIS O-ring Solenoid instlltion/removl dimension Wiring connector M Solenoid instlltion/removl dimension SOLENOID VLVES / DIREIONL ONROL VLVES For the su-plte SHD025**1, refer to pge L-2. SHD025**3, refer to pge L-6. 23

4 onnecting method erminl ox M12-4 pin connector rrngement ower supply terminl [SOL ] (M3) ower supply terminl [SOL ] (M3) O Lmp (SOL ) Lmp (SOL ) Doule solenoid Grounding terminl (M3) Short-circuit jumper ower supply common terminl (M3) OOM Right tke-out Left tke-out ower supply terminl [SOL ] (M3) Lmp (SOL ) O SOLENOID VLVES / DIREIONL ONROL VLVES Single solenoid OOM Grounding terminl (M3) ower supply terminl [SOL ] (M3) Electric ircuit D Lmp Lmp With D M12-4 in onnectorlod side OM With D M12-4 in onnectorlod side +OM Output Unit (N) Output Unit (NN) With D DiodeLod side OM With D DiodeLod side +OM Short-circuit jumper side Lmp Short-circuit jumper side Lmp 24

5 Mounting olts Mounting olts re not supplied with vlves nd should e ordered seprtely. Since the mounting olt set height of new type vlves differs from tht of conventionl vlves, plese order the djusting collrs or mounting olts for new type vlve when replcing vlve in circuit where stck vlves re used. Where HD*-*-*-025-WY* is used, it is not necessry to purchse mounting olts. ollr For replcing conventionl vlve ollr model: HH (4 olts) Mounting olts for the HY-EGR System Hexgon socket hed olt No. of Stck Levels olt ype Stud olt No. of Stck Levels olt ype JI 1176 M5 30 HKSN5 65 HKSN HKSN5 71 HKSN HKSN HKSN Use mounting olts of the strength ctegory clss Stud olts re supplied with nuts. 4 5 HKSN5 141 HKSN5 176 SOLENOID VLVES / DIREIONL ONROL VLVES 25