Note: Fuel Tank is an EPA Certified Component. Only Replace with Fuel Tank

Size: px

Start display at page:

Download "Note: Fuel Tank is an EPA Certified Component. Only Replace with Fuel Tank"

Colleen Ray
6 years ago
Views:

1 MODELS C0K, C0H & C0V (See drawings below for additional parts) 0 Blade Bolt, /"-0NF x " $0.9 0 Hex Head Bolt, /" x " Fully Threaded $ Shoulder Bolt, /" x -/" Shoulder Length $.9 00 Worm Drive Hose Clamp (7-7/" to 9-/" Clamping Dia. $ Compression Spring, -/"L x -/" O.D. x." Wire dia. (Belt Tensioner Drawing Below) $ Plastic Wheel, " O.D. x /" I.D. x -/" Wide $ Offset Wheel Assy., /00 x, Ply Turf $9. 00 Centered Wheel Assy., 9/0 x, Flat Proof Urethane Foam $ "V" Belt, B Section, 7" O.C. Dayco B Super II $ Flat Idler, " O.D. x /" Hole (Plastic Replaced with Steel) $. 00 Precision Sealed Wheel Bearings (-/ O.D. x /" I.D.) $ Centrifugal Clutch (See Clutch Drawing Below) ~ 0 Centrifugal Clutch (See Clutch Drawing Below) ~ 00 Spindle Assy. (See Spindle Drawing Below) ~ 0 Spindle Assy. (See Spindle Drawing Below) ~ 00 Spindle Assy. (See Spindle Drawing Below) ~ 900 Offset Mower Blade, " Wide, 0" Long, /" Hole $ Roll-Over / Fuel Vapor Valve (Includes Gromet) $ Solenoid (Models C0K & C0V) (Replaces 00) $ Ignition Switch (C0K & C0H) $ Ignition Switch (C0V) $. 00 Hour/Tack Meter $ Throttle Control, " (C0K) $ Throttle Control, 7" (C0H & C0V) $ Choke Control, " (C0K) $ Choke Control, 7" (C0V) $ Control Panel Decal, Starting Instructions (Models C0K & C0V) $. 700 Warning Decal General $. 700 Danger Decal, Cut Finger $ Warning Decal, Belt Sheild $ Control Panel Decal, Starting Instructions (Model C0H) $.7 70 Throttle Control Decal (Slow, Fast & Choke) (Model C0H) $ Name Decal, Kunz $. 70 Name Decal, AcrEase (Replaces 7000, 7009 & 707) $.9 70 Name Decal, 0" Finish Cut $ Rubber Grommet $ Fuel Tank, -/ Gal. Plastic (Replace with 770 and Use 770) ~ 770 Fuel Tank Grommet (Bottom Petcock Location) $ Gas Cap - Venting Style (For Fuel Tank 7700 and with Fuel Tank 770 Without Vent Hose) $ Fuel Tank, Gal. (Replaces Fuel Tank 7700) $0.9 Note: Fuel Tank 770 is an EPA Certified Component. Only Replace with Fuel Tank Fuel Tank Grommet (Bottom Petcock Location) $ Fuel Tank, Gal., -Layer (Used on 0 Models and Newer) $0.7 Note: Fuel Tank 7700 is an EPA Certified Component. Only Replace with Fuel Tank Fuel Tank Grommet (Bottom Petcock Location) $ Gas Cap - Audible Click/Tethered, Non-Venting (Only Use with Fuel Tanks with Vent Hose) $. Note: Gas Cap 770 is an EPA Certified Component. Only Replace with Gas Cap Carbon Canister - 00cc (California Only) $.00 Note: Canister 770 is an EPA Certified Component. Only Replace with Canister Solenoid Support (Models C0K & C0V) $.

2 Caster Axle $ Belt Sheild L.H. $ Belt Sheild R.H. (Discharge Side) $ Engine Support Bracket $. 00 Caster Support Stop $ Canister Support (California Only) $ Rear Axle $ Caster Support $ Control Panel (Modes C0K & C0V) $ Control Panel (Model C0H) $ Mower Deck (Call to Order) ~ Battery Box Assy. $.0 00 Battery (V AGM Sealed) $ Depth Gage $ Tank Support $ Idler Arm Assy. (Includes Bronze Bearing)(Replaces 9000)(Belt Tensioner Drawing Below) $ Bronze Bearing, /"I.D. x /" O.D. x -/" Long $.9

3 PARTS DRAWING FOR MODELS C0K, C0H & C0V

4 BELT TENSIONER (IDLER ARM) PARTS Hex Head Bolt /" x -/" Long $ Eye Bolt /" x " Usable Length $. 00 Hex Nut /" $ Hex Nut /" $ Lock Washer /" $ Standard Flat Washer /" $ Standard Flat Washer /" $ Cotter Pin,." x.00" Long $ Compression Spring,.0" Long x -/" O.D. x." Wire dia. $ Flat Idler, " O.D. x /" Hole (Replaced with Steel) $ Tube Spacer - Nylon /" Long $ Idler Arm Assy. (Includes Bronze Bearing) (Replaces 9000) $ Bronze Bearing, /"I.D. x /" O.D. x.0" Long $.9

5 PARTS BREAKDOWN FOR COMMERCIAL SPINDLE ASSY. (PART # 00) Replaces Part # s 00 and 0 (Certain parts are interchangeable between spindles) Spindle Assy. Part # 00 Housing Assy. Part # 9009 Includes Bearings and Bearing Spacer Std. Hex Nut.00" - NF $. 0 Split Lock Washer.00" $0.0 0 Machinery Washer.00" I.D. x GA Thick $ "V" Sheave." Dia. - mm Bore $.9 00 Bearing 0 - RST $ Bearing Spacer $ Spindle Shaft $ Spindle Hub (Not Sold Seperately, Purchase 9009) ~ 9009 Replacement Housing Assy. $ Replacement Spindle Assy. $.

6 PARTS BREAKDOWN FOR COMMERCIAL SPINDLE ASSY. (PART # 0) Upgrade Spindle Assy. Part # 00 (Certain parts are interchangeable between spindles) Spindle Assy. Part # 0 Housing Assy. Part # 9000 Includes Bearings and Bearing Spacer Std. Hex Nut.00" - NF $. 0 Split Lock Washer.00" $0.0 0 Machinery Washer.00" I.D. x GA Thick $0. 00 Spindle Hub (Not Sold Seperately, Purchase 9000 or Upgrade to 9009) ~ 007 "V" Sheave." Dia. - mm Bore $.9 00 Bearing 0 - RST $ Bearing Spacer $ Pulley Spacer $ Spindle Shaft $ Replacement Housing Assy. (Can be Upgraded to 9009) $ Replacement Housing Assy. (Extra Long Bearing Life) $.99 0 Replacement Spindle Assy. (Upgrade to 00) ~ 00 Replacement Spindle Assy. $.

7 PARTS BREAKDOWN FOR CENTRIFUGAL CLUTCH (PART # 007 AND 0) Clutch Part #007 - (For Models C0K, H0T, H0H, C0H & H0K with the following seven digit serial numbers (ignore the first two digits)) (xx90 xx997) or (xx0000 xx0) Clutch Part #0 - (For Models C0K, H0T, H0B, H0H, C0H & C0V with the following seven digit serial numbers (ignore the first two digits)) (xx079 any serial # higher but less than xx90) Centrifugal Clutch Part # 0 00 Spring, 0 RPM Engagement (White) for 007 Clutch $. 00 Spring, 0 RPM Engagement (Blue) for 0 Clutch $. 00 Bearing $.9 00 Clutch Shoe for 007 Clutch N/A 07 Clutch Shoe for 0 Clutch N/A Note: This is a steel-on-steel clutch. If the clutch shoes or worn out the clutch needs to be replaced. 007 Replacement Clutch Assy. (Upgrade to 0 Clutch Assy.) ~ 0 Replacement Clutch Assy. $. 7

8 LAWN & GARDEN HITCH PARTS (PART # s 9000 & 9000) Hex Head Bolt, /" x " Fully Threaded $ Wire Lock Pin, /" x -/" Opening $ Spacer $ Tongue Pivot Angle $ Hitch Draw Bar $ Hitch Adaptor Plate $ Hitch Stop Angle $ Hitch Extension $ Telescope Hitch $ Short Tongue $ Short Tongue Assy. $ Hitch Assy. - Telescoping $9.00

9 ATV TONGUE PARTS (PART # 9000) 00 Wire Lock Pin." X.0" $. 009 Screw Pin Shackle Clevis $ Hitch Pivot $ Tongue $ ATV Tongue Assy. $0.00 OPTIONAL HITCH PARTS (PART # s & ) 0000 Hitch Flat (/" Mounting Hole) $ Rear Hitch Tube (Replace with Rear Hitch Assy ) ~ Long Tongue Extension (Replace with Long Tongue Assy ) ~ Long Tongue Assy. $ Rear Hitch Assy. $.00 9

10 OPTIONAL FLOATATION KIT PARTS (PART # s 0090 & 0090) Hex Head Bolt (/" x " Fully Threaded) $ Offset Wheel Assy. (/00 x, ply turf) $9. 00 Precision Sealed Wheel Bearings (-/ O.D. x /" I.D.) $.0 00 Centered Wheel Assy. (9/.0 x, Flat Proof Urethane Foam) $. 00 Precision Sealed Wheel Bearings (-/ O.D. x /" I.D.) $ Caster Axle $ Rear Axle $ Wheel Support $ Caster Support $ Rear Floatation Kit $ Front Floatation Kit $0.00 0

11 C0V EXHAUST PARTS HP VANGUARD 70 Muffler - " (Used on & HP Briggs Vanguard and & HP Briggs Intek) $7.0 7 Manifold Elbow (Used on HP Briggs Vanguard) $ Muffler Bracket $ Heat Deflector $. ~ Manifold - Briggs Part #00 (Available Through Briggs & Stratton) ~

12 AIR FILTERS, OIL FILTERS, BATTERY ETC. MISCELLANEOUS PARTS Part # Description Cost 700 Oil Filter, Kohler (-00-0-S) - Used on.hp, HP, HP & HP Kohler Command Engines $0. 70 Air Filter (Includes Foam Pre-Cleaner), Kohler (--0-S) - Used on. - HP Kohler Command Engines $. 70 Oil Filter, Kohler (-00-0-S) - Replace with 700 ~ 707 Air Filter (Filter Only Use 70 Also), Kohler (-0-0-S) - Used on HP Kohler Command Engines $ Pre-Cleaner (Use with 707 Air Filter), Kohler (-0--S) - Used on HP Kohler Command Engines $.0 70 Air Filter (Includes Foam Pre-Cleaner), Honda (7-ZF-V0) - Used on HP Honda Engines $ Oil Filter, Briggs (99S) - All Briggs Models With Oil Filter $9. 7 Air Filter (Filter Only Use 7 Also), Briggs (90S) - Used on HP Briggs Vanguard Engines $.7 7 Pre-Cleaner (Use With 7 Air Filter), Briggs (790S) - Used on HP Briggs Vanguard Engines $ Battery (V AGM Sealed) $. 770 Spare Key for Indak Ignition Switches (Used on 00 & 00) $.9 OPTIONAL STARTER CABLE PARTS (Models Without a Battery Box) Part # Description Cost 00 Starter Terminal (/"- 0 Thread, Male End) $ Starter Cable (' Long, Includes Female Plug) $. 0 Starter Terminal (/" - NF Thread, Male End) $ Starter Cable Assy. (' Long, Includes Wrap Up Strap and Mounting Rivet) $.

Note: Fuel Tank is an EPA Certified Component. Only Replace with Fuel Tank

Note: Fuel Tank is an EPA Certified Component. Only Replace with Fuel Tank MODELS H0T, H0B, H0K & H0H (See drawings below for additional parts) 0 Blade Bolt, /"-NF x /" $0.0 0 Hex Head Bolt, /" x " Fully Threaded $0. 0000 Shoulder Bolt, /" x -/" Shoulder Length $.9 00 Worm Drive