John Deere MODEL: 2950 JD-O-OML39652

Transcription

1 John Deere MODEL: 2950 THIS IS A MANUAL PRODUCED BY JENSALES INC. WITHOUT THE AUTHORIZATION OF JOHN DEERE OR IT'S SUCCESSORS. JOHN DEERE AND IT'S SUCCESSORS ARE NOT RESPONSIBLE FOR THE QUALITY OR ACCURACY OF THIS MANUAL. TRADE MARKS AND TRADE NAMES CONTAINED AND USED HEREIN ARE THOSE OF OTHERS, AND ARE USED HERE IN A DESCRIPTIVE SENSE TO REFER TO THE PRODUCTS OF OTHERS. JD-O-OML39652

2 2950 TRACTOR OPERATORS MANUAL, 2950 TRACTOR OML39652 F5 English JOHN DEERE WERKE MANNHEIM OML39652 F5 LITHO IN THE U.S.A. ENGLISH

3 Identification. Views L35303A L35139A L35303A,L35139A-2950ALE

4 Contents Safety Safety Controls and Instruments Controls Control lights Instruments Break-In Period After the first 4 and 8 hours After the first 50 hours After the first 100 hours Within the first 100 hours Operating the Engine Prestarting check Starting the engine Thermostart aid Ether starting aid Starting with a booster battery Towing the tractor to start Towing the tractor Parking the tractor :... Stopping the engine Operator's Station Lighting system Seats Roll guard Seat belt Windshield wipers Fan, air louvers, heater Air conditioning system Steering wheel adjustment Tre.ads, Tires, Ballast Wheel treads Adjusting front wheel tread Checking front wheel toe-in Adjusting front wheel to~-in Rear wheel tread adjustment Tires Tire pressures Use correct tire combinations Servicing tires Ballast $ - Measuring rear wheel slip Rear wheel weights Installing rear wheel weights Filling tires with liquid ballast Front weights Operating the Tractor Reduce fuel consumption Ground travel speeds At desired engine speed At rated engine speed Operating the tractor Shifting gears Hi-Lo shift unit Creeper transmission Differential lock Foot brakes i Rocks haft, Three-Point Hitch : Rockshaft Control lever Load selector lever Rate-of-implement drop Three-point hitch Draft links Center link Lift links Attaching implements Positioning sway blocks Accessories Selective c_ontrol valves Poppet type valves Breakaway couplers Spool type valves Quick couplers Maximum permissible oil withdrawal Double acting remote hydraulic cylinder Swinging drawbar CONOM-2950ALE

5 Contents Power Take-Off PTO guard Operation of PTO Attaching PTO driven equipment Service-Clutch Adjusting clutch Adding fluid to clutch reservoir Lubricating clutch throw-out bearing Front-Wheel Drive Operation Front wheel steering angle Adjusting front wheel tread Tires Service-Engine Engine oil Engine filter Alternator V-belt Engine speeds Fuel, Lubricants, Coolant Fuel Fuel specifications Fuel storage Lubricants Fluid for hydraulically operated clutch Engine oil Transmission/hydraulic oil Transmission oil for MFWD front axle Multipurpose grease Extreme pressure grease Engine coolant Removing Access Covers Hood Grill.) screens Battery box covers Lubrication and Periodic Service Service intervals Time-table Service-Air Intake System Primary air filter Secondary air filter Dust unloading valve Air intake hoses Service-Cooling System Checking coolant level Replacing coolant Service-Axles and Wheels Lubricating front axle Lubricating drive housings and shafts Lubricating rear axles Checking front axle oil level Changing front axle oil Service-Fuel System Checking fuel filter Replacing fuel filter Bleeding fuel system Service-Transmission/Hydraulic Checking oil level Replacing filter element Changing oil Replacing steering filter Service-Miscellaneous Operator's seat Point hitch SGB-air filter Service-Brakes Bleeding brakes Adjusting hand brake CONOM-2950BLE

6 Contents Service-Electrical System Batteries Checking specific gravity Level of electrolyte Removing batteries Starting motor... : Neutral start system Alternator Lamps Circuit breaker Service-Heater and Air Conditioning System Air conditioning system Heater Troubleshooting Hydraulic system Engine Electrical system Specifications Engine Weights Electrical system Capacities Identification Numbers Identification numbers Tractor Storage Storage Removing tractor from storage Crime Prevention Tips Crime prevention tips Lubrication and Maintenance Records 150~ - Lubrication and maintenance records Index Index CONOM-2950CLE

7 Break-In Period AFTER FIRST 4 AND 8 HOURS OF OPERATION Tighten Rear Wheel Retaining Bolts. (bolt torques vary depending on tractor equipment) A-400 Nm (300 ft-lb) B-250 Nm (185 ft-lb) C-230 Nm (170 ft-lb) L ,L ALE Tighten Front Wheel Retaining Bolts. (bolt torques vary depending on tractor equipment) A-180 Nm (130 ft-lb) B-300 Nm (220 ft-lb) C-250 Nm (185 ft-lb) L ,L ALE Adjustable Front Axle Tighten attaching screws (A) to 400 Nm (300 ft-lb) torque. AFTER FIRST 50 HOURS OF OPERATION Replace transmission oil filter (see Service Section "Transmission"). L ALE

8 Operator's Station WINDSHIELD WIPERS Both windshield wipers can be operated individually by means of two-speed switches. FAN AND AIR LOUVERS Fan speed is controlled by a three-speed switch (A). Desired direction of air flow is obtained by the adjustable air louvers (8) ALE HEATER Heating is adjustable by means of the temperature control switch. To increase heating, turn switch farther to the right. AIR CONDITIONING SYSTEM (Special Equipment) The blower switch must be turned on before switching on the air conditioning system. To increase cooling, turn switch to the right. NOTE: Turning the heater on for a short period will help to control humidity, however under normal conditions the heater switch should be in "OFF" position when the air conditioning system is switched on. L ALE

9 Service - Axle and Wheels LUBRICATING DRIVE HOUSINGS AND DRIVE SHAFTS (FWD every 50 Hours) Lubricate fittings shown every 50 hours. Use specified grease. See section "Fuel, Lubricants and Coolant". Do NOT use Arctic Grease with specification requirements per MIL-G-10924C. When front wheel drive is equipped with anti-wrap guards (A). remove wing nuts (B) and lift off guard. The rear universal joint grease fitting can now be lubricated. l ,L ,L ,l ALE LUBRICATE REAR AXLE BEARINGS (Every 10 or 600 Hours) Lubricate both bearings with 6 to 8 strokes of grease. Use specified grease. See section "Fuel, Lubricants and Coolant". l ALE

10 Index A Adjusting head lamps Aiming head lamps Adjustable front axle Adjusting front wheel toe-in Adjusting front wheel tread Air cleaner Air cleaner indicator light Air conditioning system , Air intake hoses Alternator Alternator indicator light B Ballast Batteries Bleeding brakes Bleeding fuel system Brake pedals Breakaway couplers Break-in period Center link Checking front wheel toe-in Checking wheel retaining bolts Circuit breaker Clutch pedal adjustment Cold weather starting aids Coolant Coolant temperature gauge Cooling system Control lights Controls Covers, access Creeper transmission Crime prevention tips C D Differential lock Dome and console light Draft links Drawbar Double-acting remote hydraulic cylinder E Electrical system Emergency exit Engine coolant Engine oil Engine speeds Engine warm-up period Extreme pressure grease F Fan and air louvers Filling tires with liquid ballast Fluid for hydraulically operated clutch Front axle, adjustment Front weights Front wheel drive Front wheel steering angle Fuel, lubricants and coolant Fuel filter Fuel gauge Fuel system G Gear lubricant, MFWD Grease Ground travel speeds H Hand brake adjustment Heater and air conditioning system Hi-beam indicator light Hi-Lo shift unit Hydraulic cylinder Hydraulic filter Hydraulic foot brakes Hydraulic operated clutch I, L Identification numbers Identification views Instruments Lift links Lighting system Lubricants Lubrication and maintenance records Lubrication and periodic service INDOM-2950ALE

11 Index M,N Maximum permissible oil withdrawal Measuring rear wheel slip Mechanical front wheel drive, oil... ; Neutral start Oil pressure indicator light, engine Oil pressure indicator light, transmission Opening windows Operating the engine Operating the tractor Operator's seats Operator's station p Parking the tractor Periodic service timetable Power take-off Product identification PTO guard R Rack-and-pinion axle Range shift lever positions Rear wheel treads Rear wheel weights Remote hydraulic cylinder Removing tractor from storage Rockshaft Roll guard Reduce fuel consumption Rim positioning s Safety rules Seat Seat belt Selecting gears Selecting travel speeds Selective control valves Service Shifting transmission Specifications starting motor Starting the engine Stopping the engine Storage, tractor Steering wheel adjustment Sway blocks Swinging drawbar T Theft Tire combinations ,55-5 Three-point hitch... ; Tires and tire pressures Toe-in, front wheel Towing the tractor to start Towing the tractor Transmission/hydraulic oil Travel speeds Tread adjustment Troubleshooting v,w Vandalism Warm-up period Weights, front..., Weights, rear wheel Wheel treads Window opening Windshield wipers INOOM-2950BLE