PARTS MANUAL SERIES PUMPSETS FOR. DYNAPRIMEem SERIES PARTS BOOK. Telephone: (800) Fax: (813)

Transcription

1 DYNAPRIMEem SERIES PARTS MANUAL FOR SERIES PUMPSETS ACME Dynamics, Inc. P. O. Box 1780 Plant City, FL Telephone: (800) Document No:. W72-013E Revision No:... 3 Revision Note No:. R nnnnn Fax: (813) Date Issued. June 2000 Produced at Sterling Fluid Systems, Coleford, England

2 Manual No/Rev W / 3 DYNAPRIMEem Series Pump Sets This parts book is being developed to cover the following pumps: Pump Type Sterling No. Engine Starting Trailer Type DP100/QZL LPW3 Electric Road Trailer DP150/QZL LPW3 Electric Road Trailer DP150/QZL LPWT4 Electric Road Trailer DP200/QZL LPWT4 Electric Road Trailer DP100/QZI 3LB1 Electric Road Trailer DP150/QZI 3LD1 Electric Road Trailer DP200/QZI 4LE1 Electric Road Trailer DP100/QZC DP150/QZC DP200/QZC Associated Publications: W72-008E DYNAPRIMEem Series Operators Handbook Latest copies of this manual and associated publications are available from the ACME Dynamics, Inc. Spares & Service Department by quoting the appropriate reference number. ACME Dynamics, Inc. operate a comprehensive Parts and Service support network, and can be contacted as follows: PARTS & SERVICE Telephone: (800) For spare parts, supply only. For breakdowns, spare parts and, on-site fitting, pump installation and, commissioning, and service contracts. ask for - Parts Dept. ask for - Service Dept. For breakdowns outside office hours. Telephone : (800) Parts & Service Office ACME Dynamics, Inc. General Fax line: (813) P. O. Box 1780 Plant City FLORIDA USA Page 2 of 11

3 DYNAPRIMem Series Pump Sets Manual No/Rev W /3 CONTENTS 1. PUMP ASSEMBLY COALESCER VACUUM PUMP PRIMING TANK AND SOLENOID VALVE PRIMING CONTROL SYSTEM Page 3 of 11

4 Manual No/Rev W / 3 DYNAPRIMEem Series Pump Sets 1. PUMP ASSEMBLY Page 4 of 11

5 DYNAPRIMem Series Pump Sets Manual No/Rev W /3 ITEM DESCRIPTION PART No. QTY 1 Bearing Housing End Cap O Ring Lipseal Screw : M8 x 25 SY Washer: Spring M Washer: Flat M8 SY Spacer/Sleeve Shaft Bearing: DE Bearing: NDE Locknut - M Key: Drive end Key: Impeller Plug - 3/ Washer-Plastic 3/ Grease Nipple-1/8 SY Grease Nipple-1/8 SY Filter Silencer-1/ Screw M6 x Washer-6.2 x Mechanical Seal Washer: Mech/seal Circlip - Ext 45mm Volute Stud:M12 x Nuts:M12 SY Washer:Spring-M12 SY Washer:Flat M12 SY Screw/Cap M12x O Ring Washer:M10 SY Washer:Spring-M10 SY Cable Tie TY Cable Base TY Hose Tail Bolt:M10 x Plastic Tube Bracket:Oil Bottle Spacer Set Oil Bottle Cap:Oil Bottle O Clip Screw - M8 x Hose Clip:7/8-1.1/ Hose ¾ Clear ITEM DESCRIPTION PART No. QTY 47 Valve - 1 BSP Barrel Nipple-1 BSP Elbow M/F 1 BSP SY Valve ½ BSP Nipple ½ BSP Back Wear Plate Screw c/s M10x Stud : 8 x Nut : M8 SY O Ring O Ring Cover : N.R.V Gasket : N.R.V Flapper : N.R.V Stud : M16 x 32 SY Stud : M16 x 60 SY Washer : M16 SY Washer: Spring M16 SY Nut : M16 SY Belt Tensioner Screw : M10 x Pulley Taper Lock Bush Impeller Q# Impeller Q# Impeller Q# Screw Skt M16x Cap: Plastic Front Wear Plate 1 QL Front Wear Plate QL Front Wear Plate 1 QL Shim Pack Stud : M16 x 45 SY O Ring O Ring Nut : M10 SY Mount Flexible Washer Bolt - ½ -20 UNF Nut:Jam-1/2-20UNF Stud M16 x Gasket(s) O Ring Page 5 of 11

6 Manual No/Rev W / 3 DYNAPRIMEem Series Pump Sets 2. Coalescer NEWCOAS Page 6 of 11

7 DYNAPRIMem Series Pump Sets Manual No/Rev W /3 ITEM DESCRIPTION PART No QTY 1 Chamber: Primary Filter Block Nipple - ¾ x 25mm Filter: Oil Bush: Reducing ¾ Plug - ¾ BSP Tubular Piece Valve Dipstick O Ring Stud coupling Tube Stud - M6 x 25 SY Gasket Chamber: Carrier: Filter Stud - M6 x Nut: Self locking - SY Washer: Nylon - M6 SY Sealing Ring ITEM DESCRIPTION PART No QTY 22 Element: Filter Retainer: Filter Stud Coupling Elbow M/F - 1/8 SY Rapid Fitting Tube Seal: Coalescer Mesh Filter Retainer Cover Washer Bolt M8 x Washer Gasket: Bush: Reducing SY Level Switch Plug - 1 BSP Nut - M12 SLFL 8 45 Stud - M12 x 40 SY Screw M6 x VACUUM PUMP Page 7 of 11

8 Manual No/Rev W / 3 DYNAPRIMEem Series Pump Sets ITEM DESCRIPTION PART No QTY 1 Stator Rotor Bearing : NRE Bearing : DE Endplate : NDE Spacer Stud: M10 x 40 SY Stud:M10 x 25 SY Dowel - 6MM x O Ring O Ring Nut : M10 SLFL Vane Lip seal End plate : DE Wave spring washer Key Magnetic clutch assy Plug mal 1/8 Solid SY Grub screw : M10 x Grub screw : M12 x Shim pack Stud : M10 x 35 SY Connection : inlet Gasket Rapid fitting Page 8 of 11

9 DYNAPRIMem Series Pump Sets Manual No/Rev W /3 4. PRIMING TANK AND SOLENOID VALVE FOR THE LEVEL SENSING PROBE DETAIL - REFER TO THE PRIMING CONTROL SYSTEM DIAGRAM PTANK2 42 Page 9 of 11

10 Manual No/Rev W / 3 DYNAPRIMEem Series Pump Sets ITEM DESCRIPTION PART No QTY 1 Housing - Filter Gasket-P/Tank-Filter Stud-M8 x Nut - M8 SLFL Filter Block-Knit mesh Carrier - Filter Stud - M6 x 260 lg Nut - M6 Self Locking SY Stud - M6 x Washer - M6 Flat O Ring I/d x Knob - M6 Scallop Element - Filter Retainer - Filter Cover - Filter O Ring - 87 I/d x Bolt SLFL Adapter - 1 BSP Valve - Solenoid Bush-Red 1 x ¾ BSP Cap - Breather Tank - Priming Elbow-1 BSP x 90 M/F SY Elbow-1 BSP x 45 M/F SY Joint - P/Tank to Duct SY Pipe Adapter SY Superclamp-40/43mm SY Vacuum Hose - 32mm SY Inlet Duct - Q# Inlet Duct - Q# Inlet Duct - Q# Gasket SY Stud M16 x / 8 46 Nut M16 SLFL / 8 Page 10 of 11

11 DYNAPRIMem Series Pump Sets Manual No/Rev W /3 5. PRIMING CONTROL SYSTEM CONTROL1 5 ITEM DESCRIPTION PART No QTY 1 Control Box Probe & Cable Assembly Stud - Probe Retaining F 4 4 Nut O Ring Our policy is one of continuous improvement and we reserve the right to alter specifications at any time Page 11 of 11