GERINGHOFF PATRIOT / ROTA DISC / NORTHSTAR QD2 TOOLBAR MOUNT STALK STOMPER

Transcription

1 Mount Bracket Left (42120) Toolbar* Mount Bracket Right (42119) Stalk Stomper Assy (43000) Notes: - Illustration shown is for reference purposes only. Quantities and components will vary. Please refer to individual component parts listings for specific information. * Toolbar is not included in all kits. If a kit without Toolbar was ordered, the customer is responsible for providing required Toolbar. PAGE 1 OF 5

2 ASSEMBLY/INSTALLATION INSTRUCTIONS Toolbar Mount Bracket Frame Beam Head Mount Bracket (Left) Head Mount Bracket (Right) Stalk Stomper Assy Assembly/Installation Procedure: - Fasten Head Mount Bracket to mating holes in head frame using supplied Bolts and Lock Nuts - Fasten Toolbar to Head Mount Brackets using supplied U-Bolts, Lock Washers and Nuts Note: Second set of holes in Head Mount Bracket will adjust toolbar height by one inch (1") Note: If kit was purchased with Toolbar included, Toolbar may need to be trimmed to fit - Fasten Mount Brackets to Toolbar using supplied U-Bolts, Lock Washers and Nuts on center of the rows to be stomped. - Lift Stalk Stomper Assy into mating features in the Mount Bracket. Pull Stalk Stomper Assy back until lock pin assembly snaps into place. PAGE 2 OF 5

3 OPTIONAL SETUPS Overlapping Brackets If necessary, Mount Brackets and Head Mount Brackets can be overlapped to allow the Stalk Stomper Assy to be positioned on center of the row. Replace U-Bolt with 1/2"-13 x 4" Hex Bolts as shown. PAGE 3 OF 5

4 TOOLBAR MOUNT STALK STOMPER ASSEMBLY INSTRUCTIONS / PARTS LISTING (OPTIONAL) TOOLBAR SPLICE MOUNT BRACKET RIGHT HEAD MOUNT BRACKET U-BOLT 1/2" WASHER, 1/2" SPRING LOCK NUT, 1/2"-13 HEX BOLT M X 35mm HEX NUT M TOPLOCK MOUNT BRACKET LEFT SPLICE PLATE U-BOLT 1/2" WASHER, 1/2" SPRING LOCK NUT, 1/2"-13 HEX HEAD MOUNT BRACKET U-BOLT 1/2" WASHER, 1/2" SPRING LOCK NUT, 1/2"-13 HEX BOLT M X 35mm HEX NUT M TOPLOCK 2 Items 9 and 10 listed below (but not shown) are not included in all kits, please order individually if needed " TOOLBAR (2" X 2") VARIES " TOOLBAR (2" X 2") VARIES PAGE 4 OF 5

5 ASSEMBLY INSTRUCTIONS / PARTS LISTING Notes: " Stalk Stomper Shoe Assy " Stalk Stomper Shoe W/Poly Install Self-Tapping Grease Fitting into end of Pivot Bolt Torque grease fitting to inch pounds. DO NOT OVERTIGHTEN! QD2 TOOLBAR MOUNT STALK STOMPER ASSEMBLY TOOLBAR MOUNT BRACKET ASSY TOOLBAR MOUNT BRACKET LOCK PLATE U-BOLT 1/2" WASHER, 1/2" SPRING LOCK NUT, 1/2"-13 HEX STALK STOMPER ASSY 9" SHOE BRACKET ASSY STALK STOMPER SHOE W/POLY 9" SPRING PIN, 1/4" X 3" COTTER CHAIN BOLT, CUSTOM (GREASEABLE) GREASE FITTING, 1/4"-28 STRAIGHT NUT, 7/16"-14 HEX TOP LOCK WASHER, 3/8" FLAT BOLT, 3/8"-16 X 1" HEX NUT, 3/8"-16 HEX CHAIN SLEEVE 1 PAGE 5 OF 5