ME Series Fused Sectionalizing Enclosures Style Guide 1VAM SG April 16, 2009 Revision D

Transcription

1 ME eries Fused ectionalizing Enclosures tyle Guide 1VM G pril 16, 2009 Revision D 's dead-front padmount ME series fused sectionalizing enclosures are designed for 200 ampere circuits to protect and sectionalize a system. The single-and three-phase versions are designed for durability and are available in 15 kv through 25 kv to fit your system requirements. hoose between current limiting or power fuses. The ME style guide aids in the proper selection of your style number. When ordering the ME, the style number must be given to the factory. Typical tyle ode M E P R N X M N 2 X X Digit Table 1. ME - urrent Limiting Fuse Models Digits kv ME ME ME ME ME ME

2 Digits kv ME ME kv ME ME ME ME ME ME ME ME Note: onsult factory for alternate circuit configurations Table 2. MEP - Power Fuse Models Digits kv MEP MEP MEP MEP MEP MEP ,075 MEP MEP ,090

3 Digits kv MEP MEP ,155 MEP MEP ,170 MEP MEP ,260 MEP MEP ,275 Note: onsult factory for alternate circuit configurations Table 3. Fuse Mounting Options Digit 8 Notes urrent Limiting ooper NX rc tangler hinge style fuse mounting ode 1 pacing ooper NX rc tangler hinge style fuse mounting ode 2 pacing ooper NX lip tyle fuse mounting with ode 4 spacing D ooper NX lip tyle fuse mounting with ode 5 pacing (standard for 15KV) E ooper NX lip tyle fuse mounting with ode 6 pacing (standard for 25KV) Power Fusing R T U Table 4. Fuse End Fittings/Holders Non-loadbreak mountings to accept & MU-20 power fuses Loadbreak mountings to accept & MU- 20 power fuses Non-loadbreak mountings to accept & M-4 power fuses Loadbreak mountings to accept & M-4 power fuses Maximum fuse rating is 40. rc-trangler switch blades may be used in this application. Fuse mountings accept NX style fuses with 5/8" ferrules. Fuse extenders are available to increase length of fuse from code 4 to code 5 or from code 5 to code 6. lso accept utler Hammer DU style fuses. lso accept utler Hammer DU style fuses. Digit 9 N D E F None MU-20/DU End Fittings & #3097 (15 kv and 25 kv) MU-20/DU End fittings -H #DU-EFID(15 and 25 kv) M-4 Non-Loadbreak Fuse Holders & #86632R2 (15KV) M-4 Non-Loadbreak Fuse Holders & #86633R2 (25KV) M-4 Loadbreak Fuse Holders & #92352 (15KV) M-4 Loadbreak Fuse Holders & #92353 (25KV)

4 Table 5. Inner Door arriers Digit 10 L GPO-3 Inner Door arriers (tandard) lear Polycarbonate Inner Door arriers Table 6. Fuse torage Provisions Digit 11 N F None torage Pocket For pare Fuses on RH Fuse ompartment Door Table 7. Enclosure Material Digit 12 M Material Mild teel luminum tainless teel Table 8. Paint olor Digit 13 olor pecification Green Guardian Green Munsell 7GY3.29/1.5 tandard G Gray NI 70 Gray T* Tan* Tan Munsell 10YR6.0./3.0 * pecial Paint olor* pecify * Requires minimum release of five units. Table 9. ushings Digit mp ushing Wells (tandard) mp ource ushings (luminum) mp ource ushings (opper) Note: 600 bushings equals the no. of source connections times the no. of phases Table 10. ushing Inserts Digit 15 N None 1 15KV 200 Loadbreak Inserts Installed 2 25KV 200 Loadbreak Inserts Installed Note: inserts equals no. of circuit connections times the no. of phases (Elastimold brand furnished unless otherwise specified) Table 11. us Material Digit 16 luminum us (tandard) opper us Table 12. Door ecurity 0 Pentahead locking bolt (doors and barriers) (tandard) H Hexhead locking bolt (doors and barriers) Note: Hexhead bolt does not meet security requirements of NI or R.U..

5 Table 13. Exterior Nameplate 0 Interior vinyl nameplate (tandard) luminum Nameplate on Outside of Doors luminum Nameplate on Inside of Doors Table 14. Ground ccessory Options Full Width 3/8" Round opper Ground ar in ll ompartments Ground Lugs 2/0 in Elbow ompartment Table 15. Label Options Digit 20 0 Label - Danger - Hazardous Voltage - NEM Mr. Ouch (Inside Doors- tandard) Label aution High Voltage Keep Out (Outside Doors) Label Warning Hazardous Voltage- NEM Mr. Ouch (Outside Doors) Label Warning Hazardous Voltage NEM Mr. Ouch ilingual (Outside Doors) D Label Danger Hazardous Voltage NEM Mr. Ouch ilingual (Inside in place of English) E Label Fuses and Elbows Outside on ompartment Doors Label Fuses and Elbows Outside on ompartment Doors and Warning Hazardous F Voltage NEM Mr. Ouch (Outside Doors) Label Warning Hazardous Voltage NEM Mr. Ouch ilingual (Outside Doors) and Label G Danger Hazardous Voltage NEM Mr. Ouch ilingual (Inside in place of English) Note: If there is a "" in any table or for other customer special accessories not listed above, a two-digit number will be assigned to replace digits Table 16. tatic ccessories Part Number ccessory aution Label Label - aution - High Voltage - Keep Out (Outside Doors) "Mr. Ouch" Warning Label Label - Warning - Hazardous Voltage -NEM "Mr. Ouch" "Mr. Ouch" Danger Label Label - Danger Hazardous Voltage - NEM "Mr. Ouch" ilingual "Mr. Ouch" Label - Warning - Hazardous Voltage - NEM "Mr. Warning Label Ouch" (ilingual) ilingual "Mr. Ouch" Label - Danger - Hazardous Voltage - NEM "Mr. Ouch" Danger Label (ilingual) Fuses Label Label - "Fuses" Outside Fuse ompartment Door Elbows Label Label - "Elbow" Outside able ompartment Door Ground Lugs Ground Lugs - 2/0 (Each) lamping racket Hold Down rackets (et of 4) FEXT4-5 Fuse Extender ode 4 to ode 5 (each) FEXT5-6 Fuse Extender ode 5 to ode 6 (each)

6 Inc. 655 entury Point Lake Mary, FL Tel or Fax VM G Rev. D pril 2009 opyright ll rights reserved.