EEA & EEB Series. UL Recognized CSA Certified VDE Approved EEA2 / EEB2

Transcription

1 atalog: Issue ate: 6.11 Including the S/S and H/H Models ost-effective MI Power Inlet Filter UL Recognized S ertified V pproved 2 / 2 1 / 1 P / P Series ompact single stage MI filter with I inlet Two element circuit provides basic attenuation Same performance as the F Series vailable in three terminal configurations Supersedes F Series Series ompact MI filter with I inlet Two element circuit provides extended attenuation xtended differential mode performance vailable in three terminal configurations S & S Models Same performance as and Series Snap in mounting Spade terminals H & H Models Same size as and Minimal leakage current suitable for medical applications Flange mounted Spade terminals Specifications Maximum leakage current each Line to Ground: / S/S 1 V 6 Hz:.22 m 25 V 5 Hz:.38 m 5 Hipot rating (one minute): Line to Ground: 225 V Line to Line: 145 V Rated Voltage (max.): 25 V Operating Frequency: 5/6 Hz Rated urrent: 1 to Operating mbient Temperature Range (at rated current I r ): - to +4 In an ambient temperature (T a ) higher than +4 the maximum operating current (I o ) is calculated as follows: I o = I r (85-Ta)/45 lectrical Schematic LIN Note 1: Not present in H / H versions LO

2 atalog: Issue ate: 6.11 Ordering Information 3 1 vailable Part Numbers Models Models Output Styles 1.25 [6.3] spade terminals (back) 2.25 [6.3] spade terminals (bottom) P P board pins Series asic Inlet Filter S Snap in Filter H Medical Filter xtended MI Performance S Snap-in Filter H Medical Filter P P P 1 2 P S Models P P P 1 2 P S Models 3 ccessories urrent Rating 1, 3, 6, or G4: NM 5-15P to I line cord F61: Insulating Shroud.413 ia ia S1 3S1 6S1 S1 H Models 1H1 3H1 6H1 H1 1S1 3S1 6S1 S1 H Models 1H1 3H1 6H1 H1 Power Inlet Filters & Power ntry Modules S / S

3 atalog: Issue ate: 6.11 ase Styles 1, 1, H1 & H1 ase imensions Part No. 1, 1, H1, H1 2, 2 P, P S1, S1 2 & 2 Recommended Panel utouts,, H, H Front Mount ack Mount Max * 28.96* *±.2 [.51] R. 3.5 Typ Tolerances ±.5 [.13] unless otherwise noted R Typ. P & P S, S G Ref. ± Max R.188 [4.78] (4X) P oard Layout S1 & S Max * 17.4* *±.15 [.38]

4 atalog: Issue ate: 6.11 Performance ata Typical Insertion Loss Measured in closed 5 Ohm system ommon Mode / symmetrical (L-G) ifferential Mode / Symmetrical (L-L), S Models , S Models H Models H Models Power Inlet Filters & Power ntry Modules

5 atalog: Issue ate: 6.11 Performance ata (continued) Minimum Insertion Loss Measured in closed 5 Ohm system ommon Mode / symmetrical (Line to Ground) ifferential Mode / Symmetrical (Line to Line) 152