SOLENOID VALVES direct operated core disc 1/4

Transcription

1 SOLENOI VLVES direct operated core disc /4 N U NO / Series 4 FETURES ompact valve intended for single-acting actuator control Epoxy moulded coil for general service applications oils interchangeable without dismantling the valve Valves do not require a minimum operating pressure The solenoid valves satisfy all relevant EU directives GENERL ifferential pressure Maximum viscosity Response time See "SPEIFITIONS" [ bar =00 kpa] 40 cst (mm /s) 8-0 ms fluids ( ) temperature range (TS) seal materials ( ) water, air, inert gas, oil - 5 to + 80 NBR (nitrile) MTERILS IN ONTT WITH FLUI ( ) Ensure that the compatibility of the fluids in contact with the materials is verified Body Brass or ISI 6L (.4404) Internal parts, springs Stainless steel Seat Brass and stainless steel Seals NBR ore guide Shading coil opper BP MP RP LP Not available Not available Not available 0,5W-,W Low Reduced Medium Basic POWER LEVELS - cold electrical holding values (watt) SPEIFITIONS pipe orifice flow coefficient Kv operating pressure differential (bar) level BP prefix optional solenoids basic catalogue number max. (PS) TEX / IEEx min. air/water/oil ( ) - Ex emb Ex mb - IP65 ( ) (mm) (m /h) (l/min) (m /h) (l/min) ~ = ~ = - EM PV - S brass stainless st. N - Normally closed /4,0 0,,8 0,5, ,5, /4, 0,,6 0,5, ,5, /4,8 0, 5, 0,5, ,5, Select B for NPT NSI.0. or select E for ISO (8/ and ISO /) vailable feature - Not available 8009GB-06/R0 PI--40-GB

2 SPEIFITIONS pipe orifice flow coefficient Kv operating pressure differential (bar) level BP prefix optional solenoids basic catalogue number max. (PS) TEX / IEEx IP65 min. air ( ) water/oil ( ) - Ex emb Ex mb - ( ) (mm) (m /h) (l/min) (m /h) (l/min) ~ = ~ = ~ = - EM PV - S brass stainless st. U - Universal /4, 0,,6 0,5, ,5, /4,8 0, 5, 0,5, ,5, NO - Normally open /4,5 0,,6 0,5, ,5, PREFIX TBLE prefix level description LP RP MP BP E M Waterproof IP66/6 - Metal enclosure (EN/IE 6009-,-8 and -)* E T Threaded conduit/hole (M0 x,5) P V Encapsulated epoxy moulded (EN/IE )* S Solenoid with spade plug connector (EN/IE 600) W P Waterproof IP6 - Metal enclosure W S Waterproof IP6-6 SS enclosure W S E M Waterproof IP66/6-6 SS enclosure (EN/IE 6009-,-8 and -)* T Threaded conduit (/" NPT) H T lass H - High temperature X Other special constructions SUFFIX TBLE suffix level description 4 5 LP RP MP BP E EPM (ethylene-propylene) V FPM (fluoroelastomer) N V FPM (fluoroelastomer) and parts cleaned for oxygen service M S Screw type manual operator OPTIONS & ESSOIRES catalogue spare parts kit n () screw type number ~ = manual operator 406/06/ /0/ /04/ / / Select B for NPT NSI.0. or select E for ISO (8/ and /) vailable feature - Not available * TEX/IEEx valves using these solenoids are approved according to EN 46- (non electrical) Power level 0,5/,: vailable feature, see Specifications page () Standard suffixes E and V are also applicable to kits () Basic kit number applies to S coil construction PROUT SELETION GUIE STEP Select basic catalogue number, including pipe thread identification letter. Refer to the specifications tables on pages and. Example: E406 STEP Select prefix (combination). Refer to the specifications table on page and the prefix table on page, respect the indicated level. Example: EM STEP Select suffix (combination) if required. Refer to the suffix table on page, respect the indicated level. Example: MS STEP 4 Select voltage. Refer to standard voltages on page. Example: 0V / 50Hz STEP 5 Final catalogue / ordering number. Example: EME406MS 0 V / 50 Hz ORERING EXMPLES VLVES: S E MS 0V / 50 Hz SHT B V / 50 Hz WS E MS 4V / WP B 4 0 4V / EM B 4 0 MS 0V / 50 Hz prefix pipe thread basic number ORERING EXMPLES KITS: 4008 () 4008 V 400 E SERIES 4 voltage suffix basic number suffix GB-06/R0

3 EXPLNTION OF TEMPERTURE RNGES OF SOLENOI VLVES Valve temperature range Operator ambient temperature range Total temperature range The valve temperature range (TS) is determined by the selected seal material, the temperature range for proper operation of the valve and sometimes by the fluid (e.g. steam) The operator ambient temperature range is determined by the selected level and the safety code The temperature range of the complete solenoid valve is determined by the limitations of both temperature ranges above ELETRIL HRTERISTIS oil insulation class F Electrical safety IE 5 Standard voltages (=) 4V - 48V (~) 4V - 48V - 5V - 0V/50Hz; other voltages and 60Hz are available on request ratings operator ambient electrical replacement coil / kit prefix inrush holding hot/cold temperature enclosure safety code option range (TS) protection type ~ ~ = ~ = (V) (V) (EN 6059) (W) (W) ( ) 0V/50 Hz 4V/ Basic (BP) S 55 0,5 9/, -40 to +5 EN 600 IP65, moulded WP/WS 55 0,5 9/, -40 to +5 EN 600 IP6, steel /SS EM/WSEM 55 0,5 9/, -40 to +40 IIG Ex e mb II Gb T, II Ex tb III b IP66/6, steel /SS PV 55 0,5 9/, -40 to +65 IIG Ex mb II Gb T(~)/T4(=), II Ex mb III b IP65, moulded - () - () Not available Refer to the dimensional drawings on pages 4 to 6 () Multiple coil kits available under TEX, contact us ELETRIL ONNETIONS prefix connection S WP, WS, EM, WSEM PV ITIONL OPTIONS Spade plug connector with cable gland EN (ISO 4400) for cables with an outer diameter from 6 to 0 mm. M0 cable gland for cables with an outer diameter from to mm. With an internal and external facility for an earthing or bonding conductor. Moulded-in cable, standard length m Other pipe threads are available on request Ex mb (prefix "PV") solenoid can be supplied with various cable lengths ompliance with "UL", "S" and other local approvals available on request /" NPT (prefix "T") and M0 x.5 (prefix "ET") conduits (aluminium or 6 SS) available for steel solenoid housing INSTLLTION Multi language installation/maintenance instructions are included with each valve The solenoid valves can be mounted in any position without affecting operation Threaded pipe connection identifier is: B = NPT (NSI.0.); E = (ISO 8/ and ISO /) SERIES GB-06/R0

4 SERIES 4 IMENSIONS (mm), WEIGHT (kg) TYPE 0: Epoxy moulded S: IE 5 / ISO 4400 TYPE 0: Epoxy moulded S: IE 5 / ISO / 40 / / 408 / / 404 / / 4058 / Pressure inlet: Function U = any port Function N = Port Function NO = Port Ports and : /4 Port : = = Pressure inlet: Function U = any port Function N = Port Function NO = Port Ports and : /4 Port : TYPE 0: Metal, epoxy coated / ISI 6 SS WP/WS: IE 5 EM/WSEM: EN/IE TYPE 04: Metal, epoxy coated / ISI 6 SS WP/WS: IE 5 EM/WSEM: EN/IE / 40 / / 408 / / 404 / / 4058 / = = 5 = = TYPE 05: Epoxy encapsulated PV: EN/IE TYPE 06: Epoxy encapsulated PV: EN/IE / 40 / / 408 / / 404 / / 4058 / GB-06/R0

5 SERIES 4 IMENSIONS (mm), WEIGHT (kg) type prefix option level B weight 0 S Basic Power 85, ,50 0 S Basic Power 85, ,560 0 WP / WS / EM / WSEM Basic Power ,60 04 WP / WS / EM / WSEM Basic Power ,80 05 PV Basic Power 5 9,4 45,5 0, PV Basic Power 5 9,4 45,5 0,608 Incl.coil(s) and connector(s) SETIONL RWING Extra length for disassembly, depending on model onnector rotatable by 90 increments (cable Ø 6-0 mm) Mounting ØM4, mm depth 4 Ex d certified cable gland (on request) 5 able gland for unarmoured cable with 6 to mm dia. sheath 6 Three-core cable, length m Screw type manual operator, suffix (MS) Execution: Stainless Steel ISI 6L GB-06/R0

6 SERIES PI GB -- vailability, design and specifications are subject to change without notice. ll rights reserved. 8009GB-06/R0