Epic Consolidated Operations LLC Contractor Covered Task List Last updated 9/6/2018

Transcription

1 003 Test Breakout Tank Overfill Protective Oral 004 Inspect and Calibrate Breakout Tank Overfill Protective Oral 005 Repair Breakout Tank Overfill Protective Inspection of Breakout Tanks Oral and Certificate 007 Operate Valves 008 Measurement of Wall Thickness with Ultrasonic Device 010 Routine Visual Inspection of Breakout Tanks Inspect, Test and Maintain Computational Pipeline Monitoring (CPM) Sensing 012 Inspect, Test and Maintain Liquid Leak Detection Flow Computers 013 Inspect, maintain and Test Tank Gauges for CPM Hazardous Liquid Leak Detection 014 Maintain/Prove Flow Meters for CPM Hazardous Liquid Leak Detection 015 Inspect, Test and Maintain Gravitometers/Densitometers for CPM Hazardous Liquid Leak Detection Purging - Hazardous Liquids (c)(10) 017 Hazardous Liquid Leak Investigation 018 Inspect Navigable Waterway Crossing (b) 026 Inspect/Test Pump Station Remote Shutdown 201 Abnormal Operating Conditions Related to Welding on Pipelines Monitoring of Welding Process (a) (c) Oral Oral Page 1 Copyright Veriforce, LLC. All rights reserved. Rev. 1

2 203 Visual Inspection of Welds not Non-Destructively Tested (b) (c) 204 Non-Destructive Testing (Dye Penetrant) Non-Destructive Testing (Mag Particle) Non-Destructive Testing (Ultrasonic) Non-Destructive Testing (X-Ray) Joining of Metal Pipe and Components by means other than Welding - Threaded and Flanged Connections Joining of Metal Pipe - Compression Couplings Small Diameter Metal Tubing and Fitting Installation Oral Install Tracer (electrically conductive) Wire (e) NA 401 of Buried Pipelines When Exposed Conduct Test to Determine Cathodic Protection Current Requirements (a) 407 Perform Cathodic Protection Survey (a) (e) (e) Oral Inspect Cathodic Protection Rectifier (b) ( c ) 409 Inspect Interference Bonds (c) ( c ) 410 Clear Shorted Casing (c) (b)(1) (a) 411 Inspect/Test to Assure Electrical Isolation is Adequate (d) Install CP Leads on Pipeline Using Exothermic Weld Inspect for Internal Corrosion Whenever Pipe is Removed (b)(1) 415 Monitoring for Internal Corrosion with Probes and Coupons (d)(5) (c) (b) 417 Atmospheric Corrosion Monitoring Page 2 Copyright Veriforce, LLC. All rights reserved. Rev. 1

3 418 General and Localized Corrosion Measurement (Remedial Measures) (a)(b) 419 Cathodic Protection Potential Measurement (a) (d)(8) (b) Measurement of Depth of Pitting with Pit Gage Perform Direct Current Voltage Gradient (DCVG) Survey Perform AC Current Attenuation (ACCA) Survey (e) 425 Perform Alternating Current Voltage Gradient (ACVG) Survey (h)(3) 426 Inspect Pipe Coating with Holiday Detector (a) (a) Inspection of Above or Below Ground Coatings Oral 428 Pin Brazing to Install CP Leads on Pipeline Installation and Testing of Mechanical Electrical Connections 434 Visual Inspection of Installed Pipe and Components for Mechanical Damage (a) Perform Close Survey (e) (e) & (7) Perform Hot Spot Survey (e) 480 Apply Approved Coating by Hand Application (a) Apply Approved Coatings by Mechanical Spray and Hand Application Methods (a) Apply Approved Coatings by Wrap Application (a) Conduct a Pressure Test (d) 502 Conduct Pressure Test on Pipe that is to be Operated at a Pressure <100 psig (b) Page 3 Copyright Veriforce, LLC. All rights reserved. Rev. 1

4 605 Locate Line/Install Temporary Marking of Buried Pipeline (c)(5) (c)(5) 607 Damage Prevention: Observation of Excavating and Backfilling (c)(6) (b) (c)(6) 608 Damage Prevention for Blasting Near a Pipeline (c)(6) (c)(6) Oral 611 Hot Tap (Steel Pipe) Purge Pipeline Facilities With Gas (a) 614 Purge Pipeline Facilities With Air or Inert Gas (b) 661 Launching and/or Receiving Internal (Pigs) (c) (d)(5)(iv ) (d)(9) 701 Patrolling Pipeline and Leakage Survey without Instrument (d)(4) (c)(10) Oral (a) Oral 702 Leakage Survey with Leak Detection Device Placing/Maintaining Line Markers (a) (c) 704 Permanent Field Repair by Grinding Permanent Field Repair Using Composite Materials (Clockspring) 706 Permanent Field Repair Using Composite Materials (Armor Plate) 707 Permanent Field Repair Using Bolt-On Clamp/Sleeve (a) 708 Permanent Field Repair Using Full Encirclement Weld Sleeve 709 Inspection and Testing of Relief (Compressor Stations, Meter Stations, Regulating Stations) (a) (a) (b) Inspect, Test, and Maintain Systems (c) (b)(1) (b)(1) Oral Test/Maintain Gas Detection and Alarm Systems (c) Yes 1:3 1 Page 4 Copyright Veriforce, LLC. All rights reserved. Rev. 1

5 714 Inspect and Maintain Pressure ing and Regulating 715 Test and Maintain Pressure Switches and Transmitters in Pressure ing and Regulating Service (a) (b) (a) (b) 716 Inspect, Maintain, and Operate Valves 719 Permanent Field Repair Using Composite Materials (Wrapmaster) Aerial Leakage Survey: Transmission Aerial Leakage Survey: Transmission (UV/IR) Valve (Pneumatic) Actuator/Operator Inspection, Testing and Maintenance 737 Valve (Hydraulic) Actuator/Operator Inspection, Testing and Maintenance 738 Valve (Electric) Actuator/Operator Inspection, Testing and Maintenance 907 AC Mitigation (e) (a) Yes 1:3 1 Page 5 Copyright Veriforce, LLC. All rights reserved. Rev. 1