Wall Mount with a 7 axis extendable arm and a 75/100mm VESA Biased Screen Pan and Tilt Head PN s 80005, &

Transcription

1 1-of-8 Display screen not included PN shown. Also available: 30 to 36 length - PN to 42 length - PN

2 2-of-8 General Features This wall mount can be used as a universal support system for VESA compatible monitors, touchscreens and terminals for Point of Sale / POS, Kitchen Display Systems / KDS in commercial kitchens, retail, restaurants, offices, industry, shops, medical, maritime, schools, laboratory and many other applications. An innovative set of joint assemblies allow seven axis of position adjustment when attached to a wall or other vertical surface. This assembly is also available in a ceiling mount configuration. See page 5. This hardware and bracket assembly supports up to 25 lbs. Single Position 25lb Mounting Plate Features Attaches directly to a wall or any other flat vertical surface. Can be attached to poles up to 36 in diameter with our optional strapping kit PN or any compatible hose clamps. Includes four integral welded gussets which greatly strengthen the assembly. Includes multiple slots for cable tie points. Multi Adjustable Arm Features The arm can be adjusted side to side and locked in one of many preset positions at the mounting surface by tightening a lock screw so that it indexes into any one of the position locking holes in the stand-off bracket. The downward or upward angle of the arm at the mounting surface can be adjusted with a lock pin clip. The downward or upward angle of the arm at the bottom of the arm section can be adjusted with a lock pin clip The arm length can be adjusted up to 5-1/2 inches by loosening a three point hand knob on the arm. Biased Pan and Tilt Head Features The screen pan position can be easily adjusted side to side and locked in any position with a five point hand knob. The pan position can also be permanently secured by tightening a lock screw in the base of the head into one of the holes in the disk plate on the end of the arm. The screen tilt position can be easily adjusted up and down and locked in any position with two four point hand knobs. The tilt position can also be permanently secured by tightening the lock screws on the sides of the head into one of the holes in the side of the base bracket. Thick nitrile rubber washers provide an adjustable clutching action that secures the up and down tilt and side to side pan position of the head. The biased position (or screen vertical side to side tilt position) of the pan and tilt head can be adjusted as needed by loosening a three point knob on the top rear of the VESA mounting plate, level the top of the screen, and tighten the knob.

3 3-of-8

4 4-of-8 Recommended practice for adjusting the angle of the offset brackets; In most applications you will want the pan and tilt head parallel to the wall or mounting surface. If you want to change the angle of the mount do so equally at both ends to preserve a parallel orientation. Example shown below The upper offset bracket is indexed up two holes and the lower offset bracket is also indexed the same up two holes. Simply tilt the pan and tilt head up or down to perfectly adjust your display screen placement.

5 5-of-8 BIAS PAN AND TILT HEAD DETAIL

6 6-of-8 There are three extension arm assembly sections available. Please specify when ordering:

7 7-of-8 Optional ceiling mount configuration There are three extension arm assembly sections available. Please specify when ordering: PN Includes an 8.63 long lower arm that allows the mount to extend from 8.8 to 14.4 PN Includes a long lower arm that allows the mount to extend from 20.8 to 26.4 PN Includes a long lower arm that allows the mount to extend from 26.8 to 32.4 Custom length arms are available. Please contact our design team.

8 8-of-8 MOUNTING OPTIONS: All of our screen pan and tilt heads can be used with any of the following mounting systems. See our website for more details.