GAS GAS ENDURO THE RENEWED POWER OF THE TWO STROKES

Transcription

1

2 OFF- ROAD PASSION Right from its conception, in 1985, the history of Gas Gas has always been an off-road story. The Gas gas presence in both national and international competitions has produced a long list of victories in the world of Trial, Enduro and Rally. After being purchased by Torrot Electric in early 2016, the company from Girona has undergone a renaissance as a brand, whislt conserving its corporate image as a manufacturer of off-road products. A prestigious collective image, which after three decades of shared history and dreams in the factory in Salt, is alive and well in the eyes of all its off-road fans. Now Gas Gas quality products are present in five continents and over fifty countries.the Catalan brand has a wide range of products to satisfy all the needs of the lovers of off-road in all its varieties. 1

3 2

4 3

5 GAS GAS ENDURO THE RENEWED POWER OF THE TWO STROKES The highly competitive GasGas EC Enduro models are refined once again for the 2019 model year by incorporating improvements in the frame, suspension, engine, and electrical system. The Spanish factory freshens the looks of its enduro while keeping intact the wild, attractive lines of its unmistakable two-stroke off-road models. 4

6 NEW FEATURES FRAME AND SUSPENSION 28.6 mm (1 1/8 ) diameter Neken handlebar without crossbar Neken grips for improved control and rider comfort GasGas-brand handlebar pad Redesigned handlebar mounts for improved strength and rigidity. ENGINE Redesigned cylinder head Updated Exhaust porting 38mm Keihin carburetor ELECTRICAL SYSTEM Optimized electric start system New electrical component installation Dual-map Rain/Sun ignition map switch Improved enduro computer mounting system. BODYWORK New special graphics Frame protector in GasGas red Updated airbox cover 5

7 ENGINE CUBIC CAPACITY BORE AND STROKE STARTER IGNITION GEARBOX CLUTCH 2-stroke Single-cylinder, liquid-cooled 199,4 cc 249,3 cc 299,3 cc 62,5 x 65 mm 66,4 x 72 mm 72 x 72 mm Kick and Electric Electronic - Euro4 CARBURETTOR Keihin PWK 38 6 speed gearbox with foot control Multidisc in oil bath. Rekluse system. Magura clutch pump INTAKE SYSTEM Direct reed valve VForce 4 EXHAUST MUFFLER HANDLEBAR FRAME SUB-FRAME SWINGARM FRONT FORK FORK TRAVEL TRAVEL FRONT RIM AND TYRE REAR RIM AND TYRE FRONT BRAKE REAR BRAKE TANK CAPACITY DRY WEIGHT DIMENSIONS WHEELBASE SEAT HEIGHT FMF PowerCore GASGAS Powered by FMF Neken Variable diameter Center frame in chrome-moly-steelframe Aluminium Aluminium and Linkage system KYB ø48 mm, AOS system, Twin chamber 300 mm 310 mm Excel 1.6 x21-90/90-21 M/C 54R Michelin Enduro Medium F TT Excel 2.15 x / R Michelin Enduro Medium R TT Nissin Front brake caliper ; NG Disk Ø260 mm Nissin Rear brake caliper ; NG Disk Ø220 mm 10L 105kg Length x width x height : 2145 x 810 X 1235 mm mm 960 mm Handlebar mounts for greater rigidity Neken grips and handlebar Sun -Rain Ignition map switch Optimized electric start system 6

8 7

9 GAS GAS ENDURO THE REAL ESSENCE OF THE CROSS-COUNTRY The highly competitive GasGas XC cross-country models renew their image by incorporating improvements in the frame, suspension, engine and electrical system. The brand from Girona updates the looks of its closedcourse race machine while keeping intact the wild, attractive line of its unmistakable two-stroke off-road models. 8

10 NEW FEATURES FRAME AND SUSPENSION 28.6 mm (1 1/8 ) diameter Neken handlebar without crossbar Neken grips for improved control and rider comfort GasGas-brand handlebar pad Redesigned handlebar mounts for improved strength and rigidity. ENGINE Redesigned cylinder head Updated Exhaust porting 38mm Keihin carburetor ELECTRICAL SYSTEM Optimized electric start system New electrical component installation Dual-map Rain/Sun ignition map switch Improved enduro computer mounting system. BODYWORK New special graphics Frame protector in GasGas red Updated airbox cover 9

11 ENGINE CUBIC CAPACITY BORE AND STROKE STARTER IGNITION GEARBOX CLUTCH 2-stroke Single-cylinder, liquid-cooled 199,4 cc 249,3 cc 299,3 cc 62,5 x 65 mm 66,4 x 72 mm 72 x 72 mm Kick and Electric Electronic - Euro4 CARBURETTOR Keihin PWK 38 6 speed gearbox with foot control Multidisc in oil bath. Rekluse system. Magura clutch pump INTAKE SYSTEM Direct reed valve VForce 4 EXHAUST MUFFLER HANDLEBAR FRAME SUB-FRAME SWINGARM FRONT FORK FORK TRAVEL TRAVEL FRONT RIM AND TYRE REAR RIM AND TYRE FRONT BRAKE REAR BRAKE TANK CAPACITY DRY WEIGHT DIMENSIONS WHEELBASE SEAT HEIGHT FMF PowerCore GASGAS Powered by FMF Neken Variable diameter Center frame in chrome-moly-steelframe Aluminium Aluminium and Linkage system KYB ø48 mm, AOS system, Twin chamber 300 mm 310 mm Excel 1.6 x21-90/90-21 M/C 54R Michelin Enduro Medium F TT Excel 2.15 x / R Michelin Enduro Medium R TT Nissin Front brake caliper ; NG Disk Ø260 mm Nissin Rear brake caliper ; NG Disk Ø220 mm 10L 105kg Length x width x height : 2145 x 810 X 1235 mm mm 960 mm GasGas brand mounts and handlebar pad Sun -Rain Ignition map switch Redesigned cylinder head for XC300 Frame protector in GasGas red 10

12 11

13 GAS GAS ENDURO THE BEST FORMULA FOR GETTING STARTED IN ENDURO This new model has its own personality within the Gas Gas Enduro 2019 range, with a character focused on recreational use unlike its more competition focused stablemates. With differences in temperament but similarities in terms of the EC model base bike for a new Gas Gas ECRanger that shares the same central spine frame and most of the components, adapting to the needs of the wide range of profiles that make up the world of enduro. A model valid both for hobby riders, as well as for those more daring riders, passionate about extreme enduro, thanks to its versatility and easy handling. 12

14 NEW FEATURES FRAME AND SUSPENSION Brake system, caliper and pistons, developed exclusively for the ECRanger model by Braktec Seat height 40mm lower than in EC range models (940mm from the ground) ENGINE EC model thermodynamic cycle with a new cylinder and cylinder head to give a mild, elastic character to the engine, with increased torque at low revs Incorporation of a new 36mm carburetor in the 300cc version Tecnigas exhaust system ELECTRICAL SYSTEM Electric start system, (kick-start optional extra) Lead-acid battery BODYWORK Special ECRanger colour scheme White frame & frame guards 13

15 ENGINE CUBIC CAPACITY BORE AND STROKE STARTER IGNITION GEARBOX CLUTCH 2-stroke Single-cylinder, liquid-cooled 199,4 cc 299,3 cc 62,5 x 65 mm 72 x 72 mm Electric (Kick Start optional extra) Electronic - Euro4 CARBURETTOR Kehin PWK 36 6 speed gearbox with foot control Multidisc in oil bath. Rekluse system. Magura clutch pump INTAKE SYSTEM Direct reed valve VForce 4 EXHAUST MUFFLER TECNIGAS 2.0 HANDLEBAR FRAME SUB-FRAME SWINGARM FRONT FORK FORK TRAVEL TRAVEL FRONT RIM AND TYRE REAR RIM AND TYRE FRONT BRAKE REAR BRAKE TANK CAPACITY DRY WEIGHT DIMENSIONS WHEELBASE SEAT HEIGHT Variable diameter Center frame in chrome-moly-steelframe Aluminium Aluminium and Linkage system KYB Ø46, Single chamber 270 mm 119mm Excel 1.6 x21-90/90-21 VRM211F T.T. Rear: Excel 2.15 x /90-18 VRM211B T.T Nissin Front brake caliper ; NG Disk Ø260 mm Nissin Rear brake caliper ; NG Disk Ø220 mm 10L 108kg Length x width x height : 2145 x 810 X 1235 mm mm 940 mm Electric start system EC Engine with new thermodynamics KYB fork, AOS system Tecnigas exhaust system 14

16 15

17 GAS GAS ENDURO THE SPECIAL EDITION FOR THE ISDE 2018 The coastal town of Viña del Mar, in beautiful Valparaíso, Chile, is to host this year s edition of the ISDE from 12th to 17th November. On the ninety-third running of the most long-lived event in Enduro racing, GasGas wanted to celebrate with a special edition. Decorated with the colors of the flag of the host country and with adorned with special components, this bike is a highly exclusive model of which only 400 units will be produced worldwide. 16

18 NEW FEATURES FRAME AND SUSPENSION Renthal 997 handlebar, Ø28.6mm (1 1/8 ) diameter with central bar Renthal grips - medium hardness for greater grip and control NG Front brake disc- Full-floating, Ø26mm in diameter. Front wheel axle puller ENGINE Redesigned cylinder head ELECTRICAL SYSTEM Optimized electric start system New electrical component installation Dual-map Rain/Sun ignition map switch Improved enduro computer mounting system. BODYWORK Exclusive Six Days Chile 2018 graphic with Easter Island ethnic motifs and white plastic. Special-edition Six Days Chile 2018 seat cover for extra grip 17

19 ENGINE CUBIC CAPACITY BORE AND STROKE STARTER IGNITION GEARBOX CLUTCH 2-stroke Single-cylinder, liquid-cooled 199,4 cc 249,3 cc 299,3 cc 62,5 x 65 mm 66,4 x 72 mm 72 x 72 mm Kick and Electric Electronic - Euro4 CARBURETTOR Keihin PWK 38 6 speed gearbox with foot control Multidisc in oil bath. Rekluse system. Magura clutch pump INTAKE SYSTEM Direct reed valve VForce 4 EXHAUST MUFFLER HANDLEBAR FRAME SUB-FRAME SWINGARM FRONT FORK FORK TRAVEL TRAVEL FRONT RIM AND TYRE REAR RIM AND TYRE FRONT BRAKE REAR BRAKE TANK CAPACITY DRY WEIGHT DIMENSIONS WHEELBASE SEAT HEIGHT FMF PowerCore GASGAS Powered by FMF Neken Variable diameter Center frame in chrome-moly-steelframe Aluminium Aluminium and Linkage system KYB ø48 mm, AOS system, closed cartridge 300 mm 310 mm Excel 1.6 x21-90/90-21 M/C 54R Michelin Enduro Medium F TT Excel 2.15 x / R Michelin Enduro Medium R TT Nissin Front brake caliper ; NG Disk Ø260 mm Nissin Rear brake caliper ; NG Disk Ø220 mm 10L 105kg Length x width x height : 2145 x 810 X 1235 mm mm 960 mm Floating Disc Six Days Gripper Seat Front wheel axle pull FMF muffler 18

20 @gasgasmotorcycles gasgasmotorcycles.com.au gasgasmotorcycles.co.nz Dealership details: