PARTS LIST CONTROL PANEL COMPONENTS

Size: px

Start display at page:

Download "PARTS LIST CONTROL PANEL COMPONENTS"

Kerry Scott
5 years ago
Views:

1 CONTROL PANEL COMPONENTS PARTS LIST -position selector switch Places divert and leak detect valve in proper circuit. "Inspect" puts air on valves to permit dismantling. Uses solenoid valve # and solenoid valve #. "Product" permits valve function only in approved and recognized procedures. Uses solenoid valve #, solenoid valve #, microswitch #, microswitch #, timer #, and timer #. "Clean" Permits CIP of the valve with the HTST unit. Uses solenoid valve #, solenoid valve # and timer # Solenoid Valve # (SV) Controls air supply to the divert valve. Solenoid Valve # (SV) Controls air supply to the leak detect valve. Microswitch # and # (MS and MS) Controls red and green indicating lights, timing pump in divert position and frequency pin. Cam Timer # (CT) Controls valve cycling during clean operation. Returns to start position after CIP cycle is complete. Contains drive motor, cam shaft, three cam actuated switches and three sets of cams, both stationary and adjustable. Cam # is homing cam, cam # is for divert valve and cam # is for leak detector valve. Control Relay with Timer # (CRT) Delays opening of forward flow part of leak detector valve for a predetermined length of time, after divert valve has assumed forward flow position. Adjustable setting from 0 to seconds. Control Relay with Timer # (CRT) Energized when selector switch is placed in "Product" position. It is used to delay valve operation until timing pump is completely stopped. Set at seconds. (Off Delay) Control Relay with Timer # (CRT) Energized when the timing pump circuit is closed. It is used to delay the pump "Dropout" operation. Set at second. Manual Diversion Switch Used to manually position valves in divert position when selector switch is in the "Product" position Terminal Strip (TB) Used to interconnect panel components to external components. Also used for troubleshooting electrical circuits. Low Temperature Limit Switch Located in the STLR controller, not in the Flo-Diversion valve control unit. Timer (CRT) Places Flo-Diversion Valve in divert flow position for ten minutes in the clean position. Seal on Control Box Meets requirements of regulatory agencies.

PARTS LIST PANEL How to order replacement parts All orders for repair parts must contain the following data:. Complete model number (from name plate).. Serial number (from name plate).

All parts list illustrated are indexed to the parts list by key numbers.

2 PARTS LIST PANEL How to order replacement parts All orders for repair parts must contain the following data:. Complete model number (from name plate).. Serial number (from name plate).. Key number and description. The following exploded view and accompanying parts facilitate ordering repair parts from the factory. All parts list illustrated are indexed to the parts list by key numbers. Key # * 9* 0 * Key # * 9* 9A* * A A B C Description Enclosure (stainless steel) Panel Nameplate Air Filter Regulator Regulator Fitting /" NPT Bulkhead Fitting Nameplate Knob Operator with Contact Block Pushbutton (green) with Contact Block Cord Connector Conduit Nut Connector Hose (black) each 0 ft. long Connector Brass Nut Elbow Fitting - /" NPT x /" PL Solenoid Head & Tail Module Set Description Poly-Flo Tubing ( ft.) Solenoid Valve Solenoid Coil Only -Pole Timed Relay ( or 0 VAC) Relay Bracket Pneumatic Timer for Relay -Cam Timer ( or 0 VAC) Cam Timer Gear Rack Cam Timer Motor Only (0 or 0 VAC) Terminal Strip Assembly (complete) Barrier Strip Only Terminal Only End Clamp Only Timer Socket Timer - Solid state plug in ( or 0 VAC) * It is recommended that one spare part be stocked for each item marked Figure 9: Panel

3 --X-Y CONTROL HOUSING CONTROL HOUSING WITH SOLENOID CONTROL HOUSING WITHOUT SOLENOID Blocked Hole In Selector Block (Air Passage To Actuator Located Here) -- Elbow --U Req. -9 Note Selector Block Location -- Air Tube Air Hole At Underside Of Control Housing Plugged With --U O-ring Air Passage (to actuator) -99 Stop Block SC0R-SS Screw - Plug -09 Quick Exhaust -- Reducer -- Elbow - Plug -- Nipple Air Supply Air Supply MS-0- A Vent Plug -9A, -0A or -A Solenoid -- Reducer Air Passage Location --U -09 Quick Exhaust -- Nipple --U --U --U MS-0-A Vent Plug MS-0-A Vent Plug Solenoid to be mounted on top of Selector block as shown SCF-SS Req. X Microswitch 0 VAC X VAC X VDC X Y Solenoid 0 VAC PN# -9A X VAC PN# -0A X VDC PN# -A X No Solenoid X

4 - Base Cover SC0E-SS Screw ( Req.) --S Thumb Screw ( Req.) - Base -B-E Gasket -0B-E Gasket -9-U-90 ( Req.) SC0R-SS Screw -B Back Cover EL-9-00 Cable Assembly -09-U --0 Nylon Retainer - Pressure Relief SC0H-SS Screw LWA00-SS Lockwasher EL Wire Harness (Yellow, Brown, Orange) -9 Stem Guide EL Micro Switch --S Retaining Ring Req. -0-Spacer Block -00 Mtg. Block Yellow - Switch (COM) Purple Solenoid (either wire) Black Solenoid (either wire) EL Electrical Connector SC0R-SS Screw ( Req.) Brown - Switch N.O. Orange - Switch N.O. Green - Not Used -B Wall Back Cover

5 PARTS LIST -M How to order replacement parts All orders for repair parts must contain the following data:. Complete model number (from name plate).. Serial number (from name plate).. Key number and description. The following exploded view and accompanying parts list facilitate ordering repair parts from the factory. All parts illustrated are indexed to the parts list by key numbers. Key # Description /" " /" " Body -0TM- /-L -0TM--L -0TM- /-L -0TM--L Stem 9-- /-L 9---L 9-- /-L 9---L Gasket -- /-U --/-U -- /-U ---U Clamp MHHVM--S MHHVM--S MHHVM--S MHHM--S Upper Body -0TM- /-L -0TM--L -0TM- /-L -0TM--L --U --U --U --U Bushing Yoke -9-S -9-S -9-S -9-S 9 Screw SC0H-SS SC0H-SS SC0H-SS SC0H-SS 0 Lockwasher LWA00-SS LWA00-SS LWA00-SS LWA00-SS Actuator --S --S --S --S Packing Retainer U --U --U --U Seal Washer --L --L --L --L Vent Plug MS-0-A-CP MS-0-A-CP MS-0-A-CP MS-0-A-CP Gasket 0MP-U- / 0MP-U- 0-MP-U- / 0MP-U- Clamp MHHM- /-S MHHM--S MHHM- /-S MHHM--S

7 PARTS LIST -MRAL How to order replacement parts All orders for repair parts must contain the following data:. Complete model number (from name plate).. Serial number (from name plate).. Key number and description The following exploded view and accompanying parts list facilitate ordering repair parts from the factory. All parts illustrated are indexed to the parts list by key numbers. Key # Description " /" " " Nut --L --L --L --L 0-Ring --U --U --U --U Bonnet --/-L -- /-L ---L --L Gasket --/-U -- /-U ---U -- /-U Clamp MHHM--S MHHM--S MHHM--S HMHHM--S Stem Guard Screw SCH-SS SCH-SS SCH-SS SCH-SS End Cap -9-L -9-L -9-L -9-L 9 R.H.Body -0RM--L -0RM- /-L -0RM--L -0RM--L 0 Lower Stem 9---L 9-- /-L 9---L L U Body -0TM--L -0TM-/-L -0TM--L -0TM--L Gasket 0MP-U- 0MP-U- / 0MP-U- 0MP-U- Clamp MHHM--S MHHM- /-S MHHM--S MHHM--S L.H.Body -0LM--L -0LM- /-L -0LM--L -0LM--L Stem 9---L 9-- /-L 9---L 9-0--L --U --U --U -9-U Bushing Lockwasher LWA00-SS LWA00-SS LWA00-SS LWA00-SS 0 Screw SC0H-SS SC0H-SS SC0H-SS SC0H-SS Yoke -9-S -9-S -9-S --S Packing Retainer --0-MAT L --0-MAT L --0-MAT L --0-MAT'L Packing Seal Retainer MAT'L Actuator --S --S --S U --U --U --U Vent Plug MS-0-A-CP MS-0-A-CP MS-0-A-CP MS-0-A-CP Pin

8 PARTS LIST and and

Tri-Clover Air-Actuated Valves

761VSM Tri-Clover Air-Actuated Valves Series 741, 761, 762, & 771 Service & Installation Manual CONTENTS Thank you for purchasing a Tri-Clover Product! This manual contains disassembly and assembly instructions,