BlackHawk MMR Air Mask

Size: px

Start display at page:

Download "BlackHawk MMR Air Mask"

Kristian McCormick
5 years ago
Views:

1 BlackHawk MMR Air Mask Low/High Pressure PARTS LIST TAL 04 (L) Rev. MSA 00 Prnt. Spec (A) Mat Doc

2 BLANKS SIZE TYPE MATERIAL COLOR ULTRA ELITE HYCAR BLACK ULTRA ELITE SILICONE BLACK ULTRA ELITE FACEPIECE BLANK S M L (SMALL) (MEDIUM) (LARGE)

3 BlackHawk pressure demand facepiece Facepiece Components a b a 16b a 16e 16c 16d Upper Lens Ring SpeedOn Harness Assembly (Firehawk) a 109 SpeeD-ON Harness Assembly (with buckles) b 10 SpeeD-ON Harness Assembly (less buckles) Screw ( Req d) a 0406 Screw Kit ( Req d) 4 16 Rubber Harness Black (less Buckles) Lens Lower Lens Ring 4949 Buckles ( Req d) 040 Buckle Ass y with D-Ring ( Req d) 9 See Chart Facepiece Blank Valve Seat ( Req d) Valve Disc ( Req d) Component Housing Ring Screw 1a 041 Screw Kit Push-To-Connect Component Housing Cover Component Housing Assembly (Complete) 16a 041 Inlet Disc 16b Valve Spider (Firehawk) 16c 040 Speaking Diaphragm Retainer 16d 0409 Speaking Diaphragm 16e Component Housing with Exhalation valve 1 Nosecup Assembly (with valves) 1a 4951 Medium, Black 1b Large, Black Screws ( Req d) NightFighter Bracket Spectacle Kit

4 FireHawk Mask Mounted Regulator Reg. Assy Component 1 Oring, Silicone, Red 6945 Oring, Fluro., Blue Diaphragm, Silicone U-Clip Retainer, Spring Knob, Bypass Spring, Button Body, Bypass Insert, Bypass Hose, Threaded Screen, Bypass Spring, Diaphragm Oring, Viton, Black Oring, Buna-N, Black Button, PTC Button, STC Button, PTC Valve Assembly Housing, Regulator Cover, Purge Cover, Non-Purge Seal Ring * Lubricant * Lubricant must be applied to components marked with an asterick. Refer to the maintenance manual for instructions. Second stage critical repair parts contained within the black outlined box must be installed by CARE technicians and tested with an MSA approved dynamic flow tester. 4

5 FireHawk Mask Mounted Regulator Reg Component 1 Oring, Silicone, Red 6945 Oring, Fluro., Blue Diaphragm, CBRN U-Clip Retainer, Spring Knob, Bypass Spring, Button Body, Bypass Insert, Bypass Hose, Threaded Screen, Bypass Spring, Diaphragm Oring, Viton, Black Oring, Buna-N, Black Button, PTC Button, STC Button, PTC Valve Assembly Housing, Regulator Cover, Purge Cover, Non-Purge Seal Ring Cap, Spring Shield, CBRN * Lubricant * Lubricant must be applied to components marked with an asterick. Refer to the maintenance manual for instructions. Second stage critical repair parts contained within the black outlined box must be installed by CARE technicians and tested with an MSA approved dynamic flow tester. 5

6 BlackHawk First Stage Regulator Assembly part number 1001 (4500 psig) part number 1000 (16 psig) a O-Ring Nipple (4500 psig) a Nipple (16 psig) 650 O-Ring Washer Handwheel (4500 psig) 5a Handwheel (16 psig) O-Ring Filter 66 O-Ring Adapter Relief Valve a 1 6

7 Cylinder and Valve Assembly 494 Cylinder Valve Assembly for 16 PSIG Cylinder 499 Cylinder Valve Assembly for 4500 PSIG Cylinder a * a 5 5a 6 4 4a Warning Label 0416 Cylinder Valve Inlet Tube 654 O-Ring (16 psig) a 6096 O-Ring (4500 psig) Safety Plug (16 psig) 4a 454 Safety Plug (4500 psig) 5 45 Disc and Gasket Kit (16 psig) 5a 46 Disc and Gasket Kit (4500 psig) 6 45 Valve Insert Assembly 459 Valve Stem 460 Valve Stem Washer O-Ring Packing Gland 11 1 Spring 1 1 Locknut 1 91 Handwheel Protector Cap 15 4 Valve Body (16 psig) 15a 41 Valve Body (4500 psig) Air Pressure Gauge (16 psig) 16a 450 Air Pressure Gauge (4500 psig) Gauge Guard 16 16a

8 BlackHawk Carrier and Harness Assembly Kevlar part number Kevlar Cylinder Band Cylinder Band Buckle Grommet ( Req d) Buckle Slide, Buckle Loop, Buckle Check Strap Nylon Kit (optional) Kevlar Left/Right Shoulder Strap Grommet Lumbar Pad (use only with Vulcan)(optional) Retaining Ring Hose Strap Kevlar Bracket Bushing ( Req d) Right Pull Strap Kevlar Pin Rivet ( Req d) Washers ( Req d) Bumper ( Req d) Left Pull Strap Kevlar Backplate I.D. Label Kevlar Belt Clip O-Ring Male Buckle Female Buckle 1005 Shoulder Pads (not shown, option)

9 NightFighter System Receiver part number BlackHawk NightFighter System Transmitter Transmitter (15 psig) 1a Transmitter (4500 psig) Orifice (16 psig) a Orifice (4500 psig) Hose Ass y Plug O-Ring 6 65 Back-up Ring Rapid Vent Orifice Ass y a a 6 BlackHawk NightFighter System w/std. Gauge Transmitter (15 psig) 1a Transmitter (4500 psig) Orifice (16 psig) a Orifice (4500 psig) Gauge (16 psig) a Gauge (4500 psig) Hose Assembly O-Ring 6 65 Back-up Ring Air Spool Orifice Gauge Guard Rapid Vent Orifice Ass y BlackHawk NightFighter Transmitter w/quick Fill Transmitter (4500 psig) Hose Assembly Dust Cover Quick Fill Coupling Quick Fill Filter Plug 616 O-Ring 65 Back-up Ring

10 BlackHawk NightFighter System Transmitter w/gauge w/quick Fill Transmitter (4500 psig) Gauge (4500 psig) Dust Cover Quick Fill Coupling Quick Fill Filter O-Ring 65 Back-up Ringup Air Spool Orifice Gauge Guard Hose Assembly BlackHawk Cylinder Shroud Assembly part number (16 psig, 0 minute, carbon) part number (4500 psig, 0 minute, carbon) part number (4500 psig, 45 minute low profile, carbon) part number (4500 psig, 60 minute, carbon) 10

11 BlackHawk Transmitter Shroud part number BlackHawk Transmitter w/quick Fill Shroud part number Hard Case Assembly part number 4945 Soft Case Assembly part number

AirHawk MMR Air Mask. Low/High Pressure PARTS LIST. TAL 804 (L) Rev. 4 MSA 2008 Prnt. Spec (A) Mat Doc.

AirHawk MMR Air Mask. Low/High Pressure PARTS LIST. TAL 804 (L) Rev. 4 MSA 2008 Prnt. Spec (A) Mat Doc. AirHawk MMR Air Mask Low/High Pressure PARTS LIST TAL 04 (L) Rev. 4 MSA 200 Prnt. Spec. 100000059 (A) Mat. 1004159 Doc. 100000146 BLANKS SIZE TYPE MATERIAL COLOR ULTRA ELITE HYCAR BLACK ULTRA ELITE SILICONE