MKT Series AUDIPACK. AUDIPACK Industriestraat GT Moerkapelle The Netherlands

Size: px

Start display at page:

Download "MKT Series AUDIPACK. AUDIPACK Industriestraat GT Moerkapelle The Netherlands"

Ariel Garrison
6 years ago
Views:

1 UDIPCK UDIPCK Industriestraat GT Moerkapelle The Netherlands Tel: +31(0) Fax: +31(0) audipack@audipack.com MKT Series MKT Series

2 MKT Series

3 CHECKLIST 1x Ceiling Finishing Mask Part No. Model P P P P P P3728-MK x OPTIONL 1x 1x 1x or: 1x IR 1x IR RF x 1.5V RF 1x MKT Series

4 SITUTION PRO D UCT : M OD EL: P0992-P3710 M KT ± mm P1592-P1788 (open) P1777 (closed) M KT ± mm P1645-P1788 (open) M KT ± mm P2806 M KT -15 0WS (Wide Sc reen) ± mm P3192 M KT -20 0WS (Wide Sc reen) ± mm P3728 M KT -26 5WS (Wide Sc reen) ± mm MKT Series

5 80mm mm install level 3x CONCRETE ETON ETON ETON DIN M8x... HOUT WOOD OIS HOLZ DIN M8x POWER LED 1 (20x5mm) 24VDC - max.1.88 mp. MKT Series-04a

6 2.2 External control: control by relay. WRNING: The tension on these wires can be VDC and 230 VC! Note: to control the system pulse or constant, and adjust the maximum power, please see 'appendix MOTOR CRD'. Controlled by computer (for example). External cable control box UP DOWN COMMON UP DOWN k1 k2 k2 k1 K1 K2 -K1 and K2 are relays. -k1 and k2 are relays. 2.3 External control: control by wall switch. External cable control box (not the motor control box!) UP DOWN COMMON Wall switch (with neutral position) (not supplied) M - and are potential free contacts. -: up or down. -: down or up. -M: middle position (!). MKT Series-04b

7 UP COMMON DOWN 3. Note: to control the system pulse or constant, and adjust the maximum power, please see 'appendix MOTOR ORD'. OPTIONL Safety stop/ emergency switch. Note: lways insert the green connector in the unit, after installation of the product. See page, 2.2: EXTERNL CONTROL. 4. MKT Series

8 M6x20 (4X) / M5x20 (4X) MKT Series

9 6.2. M6x20 (4X) / M5x20 (4X) 100mm MX. 130mm Max. 15 kg MX. 500mm MKT Series

10 +/ mm +/- - DJUSTMENT FETURES MKT Series

11 9.1. Fine adjustment main mirror in opened position. Detail α Do not remove the red sealed nut! 2. Raw adjustment of the mirror (α). Release the 2 small srews on the rod-nut and slide it to the correct position when the mirror is in aproximate end position. Fasten the 2 small screws after setting Fine adjustment main mirror in opened position. Detail 1. Release to adjust. Do not remove! 2. Fine adjustment (a α). Release the small philips screw to adjust the limit switch of the main mirror in opened position, by turning the Hexbolt left or right. The end switch will set the right position. When tested and approved, fasten the Philips screw again MKT Series

12 10.1.Ceiling frame connected to ceiling Custom finishing Ceiling frame connected to Mirrorkit (Without finishing) MKT Series

13 MX. 15 mm MKT Series

14 M4x12 (6X) + MKT Series

15 MKT Series

16 10-15mm Max. 2 kg mm 5-6mm 5-6mm 5-6mm MKT Series

17 10-15 mm Max. 2 kg (1:2.5)! 5-6mm mm.. MKT Series-14a

18 MX. 15 mm MKT Series_15a_

19 Product Model P0992 MKT mm mm P1592 MKT mm mm P1645 MKT mm mm P2806 MKT-150WS (wide screen) mm mm P3192 MKT-200WS (wide screen) mm mm P3728 MKT-265WS (wide screen) mm mm M4x12 (2X) MKT Series_15b_

20 M4x12 (8X) DETIL VIEW M4x12 (4X) + Handleiding MKT Series_15c_

21 Remote control Handleiding MKT Series_15z_

22 12. Remote Control NOTE: When installing the remote PC, be sure that the powersupply is not plugged in RF-12 IR Yellow -----Red -----lack 868 MHz PROTOCOL RECS Remote Control CHNNELS 1-12 KNLEN 1-12 CNUX 1-12 KNLEN 0x =10 =11 C =12 Dx Ex Fx NR.1 NR.5 NR MKT Series

23 C D TECHNICL DT DIMENSIONS 637 POWER LOD LOD P3728 PRIMIR V C, 47~63Hz / SECUNDIR 24 V DC, 1.05 MX. 15 kg MX. 35 kg MKT Series

24 TECHNICL DT DIMENSIONS PRODUCT: MODEL: C D P1698 MKT-150T 340 mm 380 mm 353 mm 562 mm P1779 MKT-200T 370 mm 420 mm 503 mm 590 mm D C 602 POWER LOD PRIMIR V C, 47~63Hz / SECUNDIR 24 V DC, 1.05 MX. 15 kg MKT Series-17b

25 udipack's general conditions of sales and delivery apply to all of udipack's deliveries. These conditions can be downloaded from udipack's website, or will be sent by post on request. udipack liefert ausschließlich unter die allgemeine Verkauf- und Lieferungsbedingungen von udipack. Diese edingungen sind zum downloaden verfügbar auf die Webseite von udipack, oder werden Ihnen auf nfrage per Post gesendet. lle leveringen geschieden uitsluitend volgens de lgemene Verkoop- en Leveringsvoorwaarden van udipack. Een afschrift hiervan kunt u downloaden van de website van udipack, of wordt u op aanvraag gestuurd per post. Les conditions de vente et de livraison de udipack s'appliquent à tous les livraisons de udipack. Cettes conditions sont disponible sur le site internet de udipack, où seront envoyé par poste sur demande. udipack reserves the right to make changes in specifications and other information contained in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall udipack be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if udipack has been advised of, known, or should have known, the possibility of such damages. UDIPCK UDIPCK Industriestraat GT Moerkapelle the Netherlands Tel: +31(0) Fax: +31(0) audipack@audipack.com MKT Series

Wiring diagram for Mirror-Kit's 261085 13 14 End Switch Mirror Open 261086 21 22 End Switch Mirror Close 260204 260205 24V DC in Up Com Down See MKT manual page 6 (chapter 3) for connection's Power

26 Wiring diagram for Mirror-Kit's End Switch Mirror Open End Switch Mirror Close V DC in Up Com Down See MKT manual page 6 (chapter 3) for connection's Power Supply with Power Cord Model Motor MKT Mirror motor MKT-150WS MKT MKT MKT MKT-200WS MKT-150T MKT-150WST MKT-200T MKT-200WST MKT-250T This diagram is suitable for the models: MKT-150/MKT-150-T/MKT-150WS/MKT-150WS-T MKT200/MKT-200-T/MKT-200WS/MKT-200WS-T MKT-250/MKT-250-T MKT-265

udipack www.audipack.com Industriestraat 2-4 2751 GT Moerkapelle The Netherlands audipack@audipack.

27 udipack Industriestraat GT Moerkapelle The Netherlands Product : Mirror-kit Type : MKT-150, MKT-200, MKT-250, P3192, P1698 D F G E NL S Konformitätserklärung für Maschinen Wir erklären hiermit daß die Produkte konform sind mit den einschlägigen estimmungen der EG-Maschinen richtlinie: Maschinenrichtlinie 89/392/EEG mit 91/368/EEG und 93/44/EEG EMC 89/336/EEG mit EN und EN Niederspannung 73/23/EEC mit EN 60335/1 Declaration CE de Conformite pour les machines Nous declare que les produits sont en conformité avec la Directive pour les machines Machine 89/392/EEG with 91/368/EEG and 93/44/EEG EMC 89/336/EEG with EN and EN (Low voltage 73/23/EEC with EN 60335/1) EC-declaration of conformity for machines We declare that aforesaid product is constructed in compliance with the following directives with the following directives Machine 89/392/EEG with 91/368/EEG and 93/44/EEG EMC 89/336/EEG with EN and EN (Low voltage 73/23/EEC with EN 60335/1) EC-Declaracio'n de la conformidad para las máquinas Declaramos que el producto antedicho está construido en conformidad con los directorios siguientes Machine 89/392/EEG with 91/368/EEG and 93/44/EEG EMC 89/336/EEG with EN and EN (Low voltage 73/23/EEC with EN 60335/1) EG-verklaring van overeenstemming voor machines Wij verklaren dat bovengenoemd produkt volgens de onderstaande normen en richtlijnen is geconstrueerd: Machine 89/392/EEG with 91/368/EEG and 93/44/EEG EMC 89/336/EEG with EN and EN (Low voltage 73/23/EEC with EN 60335/1) EG-försäkran om överensstämmelse Tillverkare försäkrar härmed att produkt är tillverkade i överensstämmelse med EG's Maskindirektiv: Machine 89/392/EEG with 91/368/EEG and 93/44/EEG EMC 89/336/EEG with EN and EN (Low voltage 73/23/EEC with EN 60335/1) Moerkapelle (NL), udipack, R&D subject to change without prior notice. Copyright udipack 2005

SAUTER TVO Version /2014 GB

SAUTER TVO Version /2014 GB Sauter GmbH Tel.: +49-[0]7433-9933-199 Fax: +49-[0]7433-9933-149 Internet: www.sauter.eu Instruction Manual Motorized Vertical Test Stand SAUTER TVO Version 1.3 11/2014 GB PROFESSIONAL MEASURING TVO-BA-e-1413