power pazifik Metal Oxide Surge Arrester with composite polymer insulator Type series SBK-I to IV /10.3

Transcription

1 Manufactured by: Metal Oxide Surge Arrester with composite polymer insulator Type series SBK-I to IV /10.3 BT-A3/8 Surge Arresters housed in polymer housing, developed to protect switchgear, over head lines, transformers and other equipment against atmospheric or a system ianent over Advanced technological metaloxide solutions for all sorts of applications Usage under all climatic conditions Developed and tested pursuant to IEC pazifik power

2 Field of application Protection of transformers, switchgears and plants against atmospheric and switching overs Operating Conditions Ambient temperature: Rated frequency: -60 C to +55 C 48 cps to 62 cps Design Optional Accessories Silicon housing: grey RAL 7040 Fittings: Al alloy Connections: clamps, screws, nut hot dip galv. or stainless steel Selection of Metal Oxide Surge Arresters The selection of the rated and the continuous operating of the arresters is depending on the neutral performance of the networks. Guidelines for selection: see DIN VDE 0675/ part 5 and IEC Monitoring spark gaps, surge counters, diagnostic appliance Technical Parameters Rated Ur: 6 to 150 Nominal discharge current: 10 ka (20 ka) High current impulse (4/10): 100 ka Long duration current impulse: 1000 A / 2000 μs Line discharge class: 3 Rated short circuit current: 40 ka Specific energy withstand acc. to IEC : Double impulse 3000 μs: 6, 7 KJ / ur 12 kj / ur LINE TERMINALS EARTH TERMINALS type A type Y type B type C type X

3 type height ±5% creepage distance weight insulation of arrester housing (applied to 1000m a.s.i.n) installation plan ²) without insulation base p.f withstand (wetted) lightning impulse withstand switching impulse withstand (wetted) h I II III IV SBK-... 6/ SBK-... 9/ SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / ²) For installation please consider national standards m kg PFWL LIWL SIWL LL LE Power frequency versus time characteristic (TOV) (Initial temperature +60 C) without prestress prestressed: two line discharges of class 3 continuous operating Designation of types modified arrester line discharge classes nom. discharge current rated of the arrester I...IV shed distance 90, 82, 62 and 51 polymer arrester

4 type rated continuous operating temporary over TOV ¹) residual at steep, lightning and switching impulse current Ur Uc U1s U10s 10 ka (1/2 μs) 5 ka 10 ka 20 ka 40 ka 250 A 500 A 1000 A 2000 A SBK-... 6/ ,8 6,9 6,5 16,6 14,4 15,2 16,6 17,6 12,2 12,5 12,9 13,3 SBK-... 9/ ,2 10,4 9,7 24,9 21,7 22,8 24,9 26,4 18,2 18,8 19,4 20,0 SBK / ,6 13,8 13,0 33,1 28,9 30,4 33,1 35,3 24,3 25,1 25,8 26,7 SBK / ,0 17,3 16,2 41,4 36,1 38,0 41,4 44,1 30,4 31,3 32,3 33,3 SBK / ,4 20,7 19,4 49,6 43,2 45,5 49,6 52,8 36,4 37,5 38,7 39,9 SBK / ,8 24,2 22,7 57,9 50,4 53,1 57,9 61,6 42,5 43,8 45,1 46,6 SBK / ,2 27,6 25,9 66,2 57,7 60,7 66,8 70,4 48,6 50,0 51,6 53,2 SBK / ,6 31,1 29,2 74,4 64,9 68,3 74,4 79,2 54,6 56,3 58,1 59,9 SBK / ,0 34,5 32,4 78,5 68,4 72,0 78,5 83,5 57,6 59,4 61,2 63,1 SBK / ,4 38,0 35,6 86,3 75,2 79,2 86,3 91,9 63,4 65,3 67,3 69,5 SBK / ,8 41,4 38,9 94,2 82,1 86,4 94,2 100,2 69,1 71,2 73,4 75,8 SBK / ,2 44,9 42,1 102,0 88,9 93,6 102,0 108,6 74,9 77,2 79,6 82,1 SBK / ,6 48,3 45,4 109,9 95,8 100,8 109,9 116,9 80,6 83,1 85,7 88,4 SBK / ,4 55,2 51,8 125,6 109,4 115,2 125,6 133,6 92,2 95,0 97,9 101,0 SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / SBK / ) With a prior energy stress of two line discharges of class 3 Mechanical guarantee data torsional strength maximum permissible service load tensile strength :100Nm :800Nm : 20kN Arrester LE- minimun distance line to earth LL- minimum distance line to line

5 VARIANTS OF INSTALLATION type L type Q type U without insulation base maximum length of arrester 65 cm for arresters not longer than 65 cm Surge Counter (Optional Accessories) Meter Minimum count current Maximum high current withstand Surge counter type DCC and DCC-M Nominal residual at 100 ka (4/10 µs) 6-digit cyclometer 200 A (8/20 µs) 100 ka (4/10 µs) 5 peak Meter scale (type DCC-M) 0 bis 30 mapeak/ 2 Maximum count rate (type DCC-ML) 0 bis 50 mapeak/ 2 at least 5 counts/ sec. Dimensions (L x W x H) 259 x 145 x 137 Including bushing terminal (L x W x H) 259 x 145 x 258 Line & Ground Termination Mounting terminal M12 nickel plated brass fitted with 2 brass nuts Cast lug at the rear with M12 x 35 bolt * Both counters can be supplied with an auxiliary contact rated 0,5A/250 V for connection to remote signalling equipment. If required suffix RC e.g. DCC/RC. Field of application Our surge counters are fully tested for use with any manufacturers surge arresters to provide a comprehensive monitoring system. These instruments, which require no auxiliary supply, are designed for installation in the earth connection of a single surge arrester or alternatively the DCC may be used with the coon earth of a three phase set. Fully weather proofed and sealed for life they are housed in a one piece casted aluminum case, powder coated to enhance its already high degree of resistance to surface corrosion. The glass viewing window is sealed in place, using a silicon rubber adhesive, a desiccator is enclosed to ensure any residual moisture trapped during sealing is absorbed for the service life of the counter. Mounting is effected by means of an integrally cast lug at the rear of the case providing a single clearance hole for the galvanised steel M12 bolt supplied. A fixing angle can additionally be installed by screws 2x M12x25. DCC and DCC-M use service proven electrical circuits. No special maintenance or service apart from general cleaning of the glass viewing window and of the molded epoxy resin line terminal bushing is necessary.

6 Efficient Electricity Solutions In a span of two decades, PPI Pazifk Power, Inc. successfully supplied the Philippine market a wide range of high quality innovative power and infrastructure equipment from the best manufacturers in Europe and from its own automated design concept to more than 200 customers who are at forefront of the country s engines of industrial growth. Among PPI s most sought after power product lines are: Turnkey projects for Supply of Substations rated of up to 230, Electricity Meters, Transformers, Switchgears, Disconnectors, Fault Indicators, Surge Arresters, Protective Relays, Diagnostic and Testing Equipments, Batteries, Harmonic Filters, UPS and AVR systems. PPI s seasoned Electrical Engineers deliver the unique support tailored fit for each customer needs. PPI s cutting edge is its high product quality with an unparalleled delivery of after- service performance. TRANSMISSION equipment HORSTMANN GmbH Surge Arrester Silicon arrester in cage design Substation Type Arrester Protection against atmospheric overloads rated up to 800 Smart Navigator Fault Indicator with Counication Designed and engineered for Smart Grid Distribution, Automation, Application Power Voltage Transformer 72,5 to 550 Unique design with an open magnetic core ensuring ferroresonance iunity, rated output capacity of A per phase Combined Instrument Transformers Type VAU - 72,5 to 550 High-precision measurement accuracy and protection classes with superior transient response Medium Voltage Switchgears Switchgear contributes to improving electrical distribution in Medium Voltage networks up to 36 with rated current up to 2,500 A High Voltage Disconnectors Rated 69 up to 800 Liona Automatic online PD detection and localization on XLPE cables Circuit Breaker Testing Guaranteed high level of accuracy AFFILIATES 4/F South Park Plaza, Santiago Street Paseo de Magallanes Coercial Center 1232 Makati City, Metro Manila, Philippines Tel. : Fax : info@ppi.ph