R182J, R482J, R845A, R847A, R882J, RA89A, RA832A Switching Relays

Transcription

1 RJ, RJ, RA, RA, RJ, RA9A, RAA Switching Relays hese relays provide intermediate or heavy duty service in a wide variety of switching configurations. Relays with V control coils: RlJ, RJ, RA, RA9A, RAA, and RA. Relays with line voltage control coils: RJ. Relays with internal V transformer: RJ, RA9A, RAA, RA, and RA. Heavy duty relays: RJ. RA has flexible internal leads to provide either spst or spdt switching. RAA has contacts for low voltage and millivoltage (Powerpile ) use. Relays for use with an external V supply: RJ. CONENS Specifications... Ordering Information... Installation... Service and Checkout... 6 J.H. Rev. 0-9 Honeywell Inc. 99 Form Number 60-

2 RJ, RJ, RA, RA, RJ, RA9A, RAA SPECIFICAIONS ORDERING INFORMAION Specifications IMPORAN: he specifications given in this publication do not include normal manufacturing tolerances. herefore, this unit may not exactly match the listed specifications Also, this product is tested and calibrated under closely controlled conditions, and some minor differences in performance can be expected if those conditions are changed. RADELINE MODELS RADELINE models are selected and packaged to provide ease of stocking, ease of handling, and maximum ABLE SWICHING RELAY SPECIFICAIONS. replacement value. RADELINE model specifications are the same as those of standard models except as noted below. RADELINE MODELS AVAILABLE: RJ 0 and 0V models. RJ 0 and 0V models. RA 0V models. RA 0 and 0V models. RA9A V controller. RAA 0 and 0V models. ADDIIONAL FEAURES: RADELINE pack with cross reference label and special instructions. SANDARD MODELS: See able. Coil Voltage Relay Coil Contact Voltage Switch Control (Vac at Current Ratings (A) Models Application (0/60 Hz) Action Circuit 0/60 Hz) (A) AFL ALR RJ For V thermostat control 0 Dpdt -wire 0.0 a.. of line voltage devices. 0.. RJ Controlled by a line 0 -wire voltage controller 0/0 0/ RA For hot water zone control systems or spst control of two separate loads. 0 Dpst RA Provides switching for 0 00 high-current loads such as cooling compressors RJ RA9A For use with separate low voltage power source. For switching one line voltage load. Dpdt.. 0 Spst RAA For switching two line 0 Dpst.. voltage loads having a common power source. 0.. a See footnote on page. Ordering Information When purchasing replacement and modernization products from your RADELINE wholesaler or distributor, refer to the radeline Catalog or price sheets for complete ordering number, or specify. Order number.. Accessories, if desired. If you have additional questions, need further information, or would like to comment on our products or services, please write or phone:. Your local Home and Building Control Sales Office (please check the white pages of your phone directory).. Home and Building Control Customer Logistics Honeywell, Inc., Douglas Drive North Minneapolis, Minnesota -6 (6) In Canada Honeywell Limited/Honeywell Limitee, 0 Ellesmere Road, Scarborough, Ontario MPV9. International Sales and Service Offices in all principal cities of the world. Manufacturing in Australia, Canada, Finland, France, Germany, Japan, Mexico, Netherlands, Spain, aiwan, United Kingdom, U.S.A. 60-

3 a IMPORAN: he transformer on the R can overheat when used with a series 0 thermostat if the total resistance of the thermostat (including thermostat wire and thermostat contact resistance) exceeds. ohms, add a 00 ohm, 0 watt resistor between the W and R terminals. able gives maximum thermostat wire runs; if longer runs are necessary, measure the resistance or add a 00 ohm, 0 watt resistor across terminals W and R. See able for the ratings of built-in transformer (all transformers are rated at 0/0V, 0/60 Hz). ABLE RANSFORMER RAINGS. ransformer Rating (watts) RA.0 RA9A.0 RAA RA RJ 6. FINISH: Gray enamel. KNOCKOUS: Case bottom: () RA9A, RAA, RA; () RlJ, RJ, RJ. All models have wiring hole in case top. All knockouts are for / in. [. mm] conduit. APPROVALS: Underwriters Laboratories Inc. Listed: RA9A; RAA, RJ; RA: File no. E6, Guide no. AP. RJ: File no. E0, Guide no. NLDS. RA: File no. SA, Guide no. SDFY. Canadian Standards Association Certified: RJ; RJ; RA: File no. LR60. RJ, RJ, RA, RA, RJ, RA9A, RAA SPECIFICAIONS INSALLAION Fig. Approximate mounting dimensions in in. [mm]. [9] [0] [] DIAMEER [9] [6] DIAMEER MOUNING HOLE [] [] DIAMEER [] DIAMEER KEYHOLE YPE MOUNING HOLE [0] [] [] 6 [] [0] [] [0] KNOCKOU FOR [] / () CONDUI () M Installation WHEN INSALLING HIS PRODUC. Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous condition.. Check the ratings given in the instructions and on the product to make sure the product is suitable for your application.. Installer must be a trained, experienced service technician.. After completing installation, use these instructions to check out product operation. WARNING ELECROCUION HAZARD. CAN CAUSE PROPERY DAMAGE, SEVERE INJURY, OR DEAH. ransformer core not bonded. Disconnect power supply before wring to prevent electrical shock or equipment damage. 60-

4 RJ, RJ, RA, RA, RJ, RA9A, RAA INSALLAION MOUNING For replacement, mount the relay in the same location as the old control. If this is a new installation, locate the relay vertically on a solid wall or partition as near as possible to the device to be controlled. Select a location that is easily accessible for installation and service. NOE: o reduce possible transformer hum and relay noise that can be amplified by mounting surfaces of sheetmetal, plasterboard, and similar materials, place rubber or felt washers between the case and the mounting surface. l. Position the relay and mark the mounting holes. See Fig... Start a screw for the keyhole type mounting hole in the upper right-hand corner. urn down screw within about l/ in. [. mm] of the surface.. Hang the relay on the screw, position the case, and start the bottom screw.. ighten both screws. IMPORAN: he switching relay terminals are approved for use with copper wires only. All wiring must comply with all applicable electrical codes, ordinances, and regulations. Follow any instructions furnished with the controlled equipment. See Figs through 0 for hookup diagrams for these relays. When two or more devices are to be controlled in parallel, the total current must not exceed the relay load rating. Fig. is an internal view of the RAA, showing terminal locations and barriers. Never connect load terminals to a load that takes more current than the amount listed in the electrical ratings on the relay. See able for wiring length specifications. Fig. Internal schematic and typical hookup for RA9A. ABLE WIRE LENGH SPECIFICAIONS. AWG Wire Size otal Wire Length Length of Run to hermostat ( wires) (Number) Feet Metres Feet Metres Fig. Internal schematic and typical hookup for RAA. LOW VOLAGE (CLASS ) -WIRE HERMOSA L L HO RAA (OPIONAL) AUILIARY O LOW OR MILLIVOLAGE (POWERPILE) POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. M Fig. Internal schematic and typical hookup for RJ. RJ LOW VOLAGE (CLASS ) -WIRE HERMOSA RA9A (SPS) RA9A JUMPER REMOVED W R B OHMS K K K K K L JUMPER L HO O L L HO CONROLLER (IF USED) POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. O COMPLEE WIRING AS SHOWN ABOVE. M9 L L 6 L (HO) L N.O. N.C. N.O. N.C. POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. N.O. CONACS MAKE BEFORE N.C CONACS BREAK, AND N.C. CONACS MAKE BEFORE N.O. CONACS BREAK. M 60-

5 RJ, RJ, RA, RA, RJ, RA9A, RAA INSALLAION Fig. hermostat connections for RJ. HREE-WIRE LOW VOLAGE (SERIES 0) HERMOSA W R HREE-WIRE LOW VOLAGE (SERIES 0) HERMOSA B B W R WO-WIRE LOW VOLAGE (SERIES 0) HERMOSA Fig. Schematic diagram showing RA in multizone, forced hydronic heating system. his arrangement is suitable for any number of additional zones. HYDRONIC HEAING CONROL ERMINALS O ADDIIONAL RA RELAYS FOR OHER ZONES W R RJ B W R B RJ JUMPER MAKES CONAC ON EMPERAURE FALL ONLY. W R B RJ MAKES CONAC ON BOH A EMPERAURE RISE AND FALL. MA HERM. ZC ZP B BURNER B C CIRC. C HERMOSA ZONE BURNER CONROL CIRCULAOR ZONE RAA RELAY 6 HERMOSA ZONE CIRCULAOR ZONE Fig. 6 Internal schematic and typical hookup for RJ. LINE L HO L RJ POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. IF CONROLLING WO S, USE: AND FOR LINE VOLAGE AND 6 FOR LINE OR LOW VOLAGE IF USING LOW VOLAGE, USE A SEPARAE RANSFORMER. M Fig. RA hookup for controlling two loads. CONROLLER 6 LOW VOLAGE (CLASS ) -WIRE HERMOSA L (HO) N.O. N.C. COM. N.O. N.C. COM. L O O RA POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. CONROLLER (IF USED) MUS BE SNAP ACION OR MERCURY SWICH YPE. N.O. CONACS MAKE BEFORE N.C CONACS BREAK, AND N.C. CONACS MAKE BEFORE N.O. CONACS BREAK. M L L HO O POWER 6 O POWER POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. WHEN CONROLLING WO S, USE AND FOR LINE VOLAGE AND AND 6 FOR LINE OR LOW VOLAGE. IF USING LOW VOLAGE, USE A SEPARAE RANSFORMER. M0 60-

6 RJ, RJ, RA, RA, RJ, RA9A, RAA INSALLAION SERVICE AND CHECKOU Fig. 9 Internal schematic and hookup for RA. Fig. Internal view of RAA Switching Relay. LOW VOLAGE (CLASS ) -WIRE HERMOSA RA RELAY L L 6 V RANSFORMER L O L POWER (HO) O POWER POWER SUPPLY. PROVIDE OVER PROECION AND DISCONNEC MEANS AS REQUIRED. WHEN CONROLLING WO S, USE AND FOR LINE VOLAGE AND AND 6 FOR LINE OR LOW VOLAGE. IF USING LOW VOLAGE, USE A SEPARAE RANSFORMER. 0 AMP CONAC RAING OR 0 AMP WHEN POLES ARE CONNECED IN PARALLEL. MB M Fig. 0 Internal schematic and hookup for RJ. LOW VOLAGE SOURCE CONROLLER RJ Service and Checkout. Never use oil on any part of the relay coil or contacts.. Keep the cover on the relay during normal operation and remove only for service and checkout.. Relay contacts require no cleaning; contacts close with a wiping action and are self-cleaning. hey may turn black after being in service for some time; however, this discoloration does not prevent proper operation.. After installation is complete, operate system through at least one cycle from the controller to make certain the relay controls the equipment as intended. 6 N.O. N.C. COM. N.O. N.C. COM. M Home and Building Control Home and Building Control Helping You Control Your World Honeywell Inc. Honeywell Limited Honeywell Limitée 9 Douglas Drive North 0 Ellesmere Road Golden Valley, MN Scarborough, Ontario MP V9 Printed in U.S.A QUALIY IS KEY