Carry out replacement in the following order:

Transcription

1 How to replace rear suspension shock absorbers on Honda CR-V III Carry out replacement in the following order: 1 Replace both shock absorbers at the repair of your car Honda CR-V III at the same time. 2 Tighten the parking brake lever. 3 Place wedge blocks under the front wheels. Loosen the wheel mounting bolts. 4 5 Raise the rear of the car and secure on supports. Remove the rear wheels. 1 9

2 6 Unscrew the lower fastener of the shock absorber. 8 7 Open the rear door. 9.1 Lower the rear seat. Move aside the luggage compartment trim in the area of the shock absorber mounting Unscrew the upper fastening of the shock absorber strut. 2 9

3 Unscrew the lower fastener of the stabilizer rod/link Unscrew the rear arm fastening Set the shock absorber strut on the spring compressor tool. Remove the suspension strut. 3 9

4 AutoDoc recommends: Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides. 15 Compress the spring. Ensure the correct position of the spring in the retainer. Make sure that the spring coils tightly entered the lock handles Unscrew the top fastening of the shock strut mount Remove the top mount. Remove the spring. 4 9

5 19 AutoDoc recommends: Τhoroughly examine the shock absorber mount, dust boot, bump stop. Replace them if necessary. Before installing a new shock absorber you should pump it manually 3-5 times. Remove the shock absorber dust cap and the bump stop. 20 Install a new shock absorber on a special fixture for further mounting of the spring Examine suspension spring rubber spacers. Replace them if needed Install the dust boot, bump stop and top mount on the new shock absorber. 5 9

6 22 Install the spring on the shock absorber Compress the spring. 25 Install the top shock strut mount. Screw the top fastening of the shock strut mount Decompress the spring. Place the shock absorber in the wheel arch and fasten it. 6 9

7 Tighten the arm fastening to the subframe Tighten the shock strut top mount Raise the rear seat. Mount the luggage compartment trim panels. 7 9

8 32 Close the rear door Tighten the lower fastening of the shock absorber. 35 Tighten the lower fastener of the stabilizer rod/link Install the wheel. 36 Lower the car and working in a cross order, tighten the wheel bolts Video tutorials Watch our detailed video guides about your Honda CR-V III repair on our youtube channel. Watch video guides. AutoDoc online We hope that this information have been useful for you! Highest quality shock absorbers for your car Honda CR-V III are available on AutoDoc. Go to the website. 8 9

9 AUTODOC TOP QUALITY AND AFFORDABLE CAR PARTS ONLINE QUALITY AUTO PARTS HONDA SHOCK ABSORBERS HONDA CR-V III SHOCK ABSORBERS FOR HONDA SHOCK ABSORBERS FOR HONDA CR-V III Disclaimer: The document contains only general recommendations that may be useful for you when you perform repair or replacement works. AutoDoc shall not be liable for any loss, injury, damage of property, acquired in the repair or replacement process due to incorrect usage or misinterpretation of the provided information. AutoDoc shall not be liable for any possible mistakes and uncertainties in this guide. The information provided is for informative purposes only and cannot replace advice from specialists. AutoDoc shall not be liable for incorrect or hazardous usage of equipment, tools and car parts. AutoDoc strongly recommends to be careful and observe the safety rules when performing repair or replacement works. Remember: usage of low quality auto parts does not guarantee you the appropriate level of road safety. AUTODOC IN SOCIAL MEDIA Powered by TCPDF ( 9 9