Carry out replacement in the following order:

Transcription

1 How to replace front suspension springs on Suzuki Swift 3 Carry out replacement in the following order: 1 Replace the springs on the Suzuki Swift 3 in pairs. 2 Tighten the parking brake lever. 3 Place wedge blocks under the rear wheels. Loosen the wheel mounting bolts. 4 5 Raise the front of the car and secure on supports. Remove the front wheels. 1 10

2 6 Unscrew the stabilizer link upper fastening. 8 Disconnect the brake hose holder from the shock absorber strut Disconnect the ABS sensor cable fastener. 9.1 Unscrew the lower fastener of the shock absorber strut. 10 Disconnect the steering knuckle from the shock absorber strut. 2 10

3 Open the hood Unscrew fixing bolts of the protective cover Remove the protective cover. 3 10

4 Remove the protective cap from the shock absorber strut mount. 15 Unscrew the top fastening of the shock strut mount. 17 Set the shock absorber strut on the spring compressor tool. 16 Remove the suspension strut. AutoDoc recommends: Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides. Ensure the correct position of the spring in the retainer. Make sure that the spring coils tightly entered the lock handles. 4 10

5 18 19 Compress the spring. Unscrew the top fastening of the shock strut mount Remove the top mount, the support bearing and the upper spring cup. Remove the spring. 22 AutoDoc recommends: Examine suspension spring rubber spacers. Replace them if needed. Τhoroughly examine the shock absorber mount, dust boot, bump stop. Replace them if necessary. Install the spring. 5 10

6 23 Compress the spring. 25 Screw the top fastening of the shock strut mount 27 Tighten the shock strut top mount. 24 Install the top mount, the strut mount bearing and the upper spring cup. 26 Install the shock strut into the wheel arch. 28 Install the protective cap onto the shock absorber strut mount. 6 10

7 Install the protective cover Tighten fixing bolts of the protective cover. 7 10

8 31 32 Install the steering knuckle on the shock strut and tighten it. Close the hood Tighten the lower fastening of the shock absorber. 34 Connect the brake hose fastener to the shock absorber strut. 35 Connect the ABS sensor cable fastener. 8 10

9 36 Tighten the stabilizer link upper fastening. 37 Install the wheel. 38 Lower the car and working in a cross order, tighten the wheel bolts Video tutorials Watch our detailed video guides about your Suzuki Swift 31 repair on our youtube channel. Watch video guides. AutoDoc online We hope that this information have been useful for you! Highest quality coil springs for your car Suzuki Swift 31 are available on AutoDoc. Go to the website. 9 10

10 AUTODOC TOP QUALITY AND AFFORDABLE CAR PARTS ONLINE QUALITY AUTO PARTS SUZUKI COIL SPRINGS SUZUKI SWIFT 3 COIL SPRINGS FOR SUZUKI COIL SPRINGS FOR SUZUKI SWIFT 3 Disclaimer: The document contains only general recommendations that may be useful for you when you perform repair or replacement works. AutoDoc shall not be liable for any loss, injury, damage of property, acquired in the repair or replacement process due to incorrect usage or misinterpretation of the provided information. AutoDoc shall not be liable for any possible mistakes and uncertainties in this guide. The information provided is for informative purposes only and cannot replace advice from specialists. AutoDoc shall not be liable for incorrect or hazardous usage of equipment, tools and car parts. AutoDoc strongly recommends to be careful and observe the safety rules when performing repair or replacement works. Remember: usage of low quality auto parts does not guarantee you the appropriate level of road safety. AUTODOC IN SOCIAL MEDIA Powered by TCPDF (