SPECIFICATION: OPERATION: (Dimensional drawing on following page)

Transcription

1 Electronic Showers Hardwire Operated (86T) - Push button electronic shower system Model No: 86T7 COMPLIES WITH: SPECIFICATION: ASME A.8. / CSA B. Volume Control lever handle ADA compliant to ICC / ANSI A7./ADA *NOTE: For optimum performance of this product, we recommend a system pressure between and 8 psi static. This product will operate up to a maximum of psi static per ANSI and CSA requirements. However, we do not recommend pressures above 8 psi. Thermal expansion or leaking pressure reducing valves may require use of expansion tanks or relief valves to ensure your system never exceeds its maximum intended pressure setting.* (Contact Delta Representative for State and/or Local Approvals) Handshower back flow protection provided by two integral certified check valves in series, which operate independantly, ASME A.8. and ASME A.8./CSA B. Handshower ADA compliant to ICC / ANSI A7./ADA Control / Sensor Box Option 7, Pressure Balancing Valve, meets ASSE 6. Push button electronic shower system Metal cover with S/S vandal resistant mounting screws Metal mounting box Field adjustable shower time Slow closing solenoid valve Integral stop Hardwire - VAC to 6 VDC Battery backup available # Shower - Handhower with Push Button Pause and standard " (6mm) Slide Bar # Shower Flow Rate MAX:. 8 PSI (.7 kpa) # Shower Flow Rate MIN:.8 PSI (.8 kpa) Tempered water supplied to solenoid valve OPERATION: NOTES: Supplied as COMPLETE PRODUCT ONLY Shower flows when push button is activated. Adjustable maximum continuous run time minutes. Factory set to minutes PAUSE WARNING FOR # Handshower and OPTIONAL # Handshower Plumbing Codes require that showerheads and handshowers provide a small but continuous flow of water (trickle) when in PAUSE mode. Because of this continuous flow, in certain circumstances pressure variations in the water line and/or changes in the position of the shower temperature control handle while in PAUSE mode could result in dramatic changes to the temperature of the water when the shower head or hand shower is returned to the ON position. (Dimensional drawing on following page) ALWAYS point the shower head away from yourself when returning to the ON position and feel the water with your hand before resuming your shower to ensure the water flow is not too hot or too cold. DO NOT allow children or others who might not understand this warning to use the PAUSE function. Delta reserves the right () to make changes to specifications and materials, and () to change or discontinue models, both without notice or obligation. Dimensions are for reference. Measurement may vary plus or minus 6mm(."). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced May,. Page of Delta Faucet Company - East th St. - Indianapolis, Indiana, USA 68 - (7) 88-8 Delta Faucet Canada - 9 Matheson Blvd E - Mississauga, Ontario, Canada LZ H - (9)

2 Model No: 86T7 Delta reserves the right () to make changes to specifications and materials, and () to change or discontinue models, both without notice or obligation. Dimensions are for reference. Measurement may vary plus or minus 6mm(."). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced May,. Page of Delta Faucet Company - East th St. - Indianapolis, Indiana, USA 68 - (7) 88-8 Delta Faucet Canada - 9 Matheson Blvd E - Mississauga, Ontario, Canada LZ H - (9)

3 Push Button Electronic Shower 86T and 86T Specification: (example) Hardwire - VAC to 6 VDC or Battery - AA 6 VDC Stainless steel cover with S/S vandal resistant mounting screws Metal mounting box Field adjustable shower time Slow closing solenoid valve Integral stop Tempered water supplied to solenoid valve (except control box options No. and 6) and... with... (add shower required) with... (add sensor box required) 86T67 Engineer/Architect Approval Model Specified: Approval: Date: DESCRIPTION PRODUCT NO. Hardwire 86T Battery Operated Hardwire with Battery Backup 86T -BB SHOWER SENSOR Specify when no shower required. Showerhead, Arm & Set Screw Flange Recessed Mount with 8 Metal Box - No Mix Valve SEE Specification Drawing # Handshower with Check Valves, 6 mm ( ) S/S Bar with ADA Slide SHOWER # SHOWER FLOW RATES PSI ( kpa).6 gpm (. L/min) 8 PSI ( kpa). gpm (.7 L/min) 6 7 Vandal Resistant, Cast Wallmount Showerhead Vandal Resistant, Forged Brass Wallmount Showerhead 6 7 Components only UNASSEMBLED Metal Box - No Mix Valve SEE Specification Drawing # Recessed Mount with Metal Box and User Controlled SEE Specification Drawing # 6.8 gpm (.8 L/min).8 gpm (. L/min). gpm (.7 L/min). gpm (.7 L/min) 8 8 Recessed Mount with Metal Box and Concealed Thermostatic Mixing Valve SEE Specification Drawing # 7.6 gpm (. L/min). gpm (.7 L/min) 9 9 Refer to for individual models. Note: Use this page front and back, with specification drawing page referenced above, as product submittal sheets. Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.

4 Approvals: Indicates ADA compliance to ICC/ANSI A7./ADA Control/Sensor Box Option 7, ASSE 6 Control/Sensor Box Option 8 Thermostatic Mixing Valve, CSA certified and meets ASSE 69, 7 Handshower backflow protection provided by two integral certified check valves in series, which operate independently, ASME A.8. (Contact Delta Representative for State and/or Local Approvals.) atented 86T68 TYPICAL INSTALLATION 7 mm (-/8") Push Button Electronic Shower 86T and 86T mm (") mm (") FLOW RATE vs PRESSURE mm ( ) Control Box FLOW (L/min) Outlet Flow Rates FLOW (GPM) Line Pressure (psig)... mm ( ) Outlet mm (-/8 ) Button Institutional Shower Head mm (")* 7 mm (79")* Shower Outlets No.,, 6 & 7 (67--BG, 96-WHB-BG, 6A, 696A) OPERATION: Adjustable maximum continuous run time minutes. Factory set to minutes. HARDWIRE WITH BATTERY BACKUP Add suffix -BB Number. See DSP-BB for detailed specification (found in the Add-On Option section when using the printed spec binder) x7xmm ("x-/8"x") Control Box * NOTE: Recommended Mounting Height FINISHED FLOOR 8 mm (8")* AS SHOWN BY SOLID LINES. ALL ITEMS SHOWN BY DOTTED LINES OTHERS. NOTE: For optimum performance of this product,we recommend a system pressure between and 8 PSI static. This product will operate up to a maximum of PSI static per ANSI and CSA requirements. However, we do not recommend pressures above 8 PSI. Thermal expansion or leaking pressure reducing valves may require use of expansion tanks or relief valves to ensure your system never exceeds its maximum intended pressure setting. NOTE: For Showers # 6 and # 7: Not for use as an anti-ligature device. Note: Measurements may vary ± 6mm (. ) 86T & 86T ELECTRONIC SHOWER OPTIONAL ACCESSORIES: TRANSFORMERS: 67A to VAC Class II VA (Up to Electronic Valves) 677A to VAC Class II VA (Up to Electronic Valves) 677A to VAC Class II VA (Up to Electronic Valves) CORDS: 69A Solenoid Extension Cord 69A 6 Solenoid Extension Cord Refer to for individual models. Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.

5 Specification Drawing # TEMPERED WATER ASSEMBLED CONTROL BOX 86T AND 86T SERIES PRODUCT NO. VALVE TYPE MOUNT TYPE COVER 86T ush Button Shower Valve Hardwire Recessed Mount mm ( ) ush Button Shower Valve Battery Recessed Mount mm ( ) 86T AND 86T SERIES Battery Operated Batteries and battery pack supplied. COMPENSATING VALVE NOTE: Models with Control Box # selected must be used with automatic compensating valves rated at or less than the CV value shown for the different showerhead selection below. Hardwire Version comes complete with Watertight Connector and Hardwire Converter VAC to 6VDC. Hardwire with Battery Backup (-BB) comes complete with Watertight Connector, Hardwire Converter VAC to 6VDC and 9V battery. See DSP-BB for detailed specification (found in the Add On Option section when using the printed spec binder). MODELS WITH CONTROL BOX # CV PSI ( kpa).6 gpm (. L/min).8 gpm (.8 L/min).8 gpm (. L/min).6 gpm (. L/min) mm ( ) mm (8 ) mm ( ) mm ( ) 86T Driver Board Metal Control Box 6 mm (8-/8 ) Slow Closing Solenoid Valve Screwdriver Stop Inlet /" Copper Tempered Water (By Others) Required for battery models only. Note: Measurements may vary ± 6mm (. ) Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.

6 COMPONENTS ONLY UNASSEMBLED Specification Drawing # 86T AND 86T SERIES PRODUCT NO. VALVE TYPE MOUNT TYPE COVER 86T 6 ush Button Shower Valve Hardwire Recessed Mount mm (-7/8") 6 ush Button Shower Valve Battery Recessed Mount mm (-7/8") 86T AND 86T SERIES Battery Operated Batteries and battery pack supplied. Hardwire Version comes complete with Watertight Connector and Hardwire Converter VAC to 6VDC. Hardwire with Battery Backup (-BB) comes complete with Watertight Connector, Hardwire Converter VAC to 6VDC and 9V battery. See DSP-BB for detailed specification (found in the Add-On Option section when using the printed spec binder). COMPENSATING VALVE NOTE: Models with Control Box #6 selected must be used with automatic compensating valves rated at or less than the CV value shown for the different showerhead selection below. MODELS WITH CONTROL BOX #6 CV PSI ( kpa).6 gpm (. L/min).8 gpm (.8 L/min).8 gpm (. L/min).6 gpm (. L/min) mm (-/ ) mm (-7/8 ) mm ( ) mm (-7/8 ) Standard Electrical Box x mm ( x ) Required for battery models only Outlet /8" F.I.P. Inlet /" M.I.P./ /" copper sweat Slow closing solenoid valve AND Screwdriver stop Tempered Water (By Others) Note: Measurements may vary ± 6mm (. ) Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.

7 Specification Drawing # PRESSURE BALANCING MIXING VALVE ASSEMBLED CONTROL BOX 86T AND 86T SERIES PRODUCT NO. VALVE TYPE MOUNT TYPE COVER 86T 7 Recessed Mount mm (") 7 Recessed Mount mm (") 86T AND 86T SERIES Battery Operated Batteries and battery pack supplied. Models supplied without a showerhead must be used with showerheads rated at.7 L/min (. gpm) or higher. Hardwire Version comes complete with Watertight Connector and Hardwire Converter VAC to 6VDC. Hardwire with Battery Backup (-BB) comes complete with Watertight Connector, Hardwire Converter VAC to 6VDC and 9V battery. See DSP-BB for detailed specification (found in the Add-On Option section when using the printed spec binder). mm ( ) mm ( ) mm (-/8 ) 7 mm ( ) 86T Driver Board mm ( ) Slow Closing Solenoid Valve 7 mm (-/8 ) Hot Water Inlet Cold Water Inlet Inlet - / Copper 7 mm (-7/8 ) Metal Control Box / Copper Sweat Screwdriver Stop Required for battery models only. Note: Measurements may vary ± 6mm (. ) Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.

8 Specification Drawing # THERMOSTATIC BALANCING MIXING VALVE ASSEMBLED CONTROL BOX 86T AND 86T SERIES PRODUCT NO. VALVE TYPE MOUNT TYPE COVER 86T 8 Recessed Mount mm (") 8 Recessed Mount mm (") 86T AND 86T SERIES Battery Operated Batteries and battery pack supplied. Models supplied without a showerhead must be used with showerheads rated at.9 L/min (. gpm) or higher. Hardwire Version comes complete with Watertight Connector and Hardwire Converter VAC to 6VDC. Hardwire with Battery Backup (-BB) comes complete with Watertight Connector, Hardwire Converter VAC to 6VDC and 9V battery. See DSP-BB for detailed specification (found in the Add-On Option section when using the printed spec binder). HOT INLET 7 mm (.9 ) mm ( ) 7 mm (.9 ) Outlet COLD INLET mm ( ) 8 mm (. ) HARDWIRE CONVERTER SOLENOID VALVE CONTROLLER mm ( ) 7 mm (. ) SCREWDRIVER SCREWDRIVER mm (. ) THERMOSTATIC Note: Measurements may vary ± 6mm (. ) Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.

9 86T Series Shower Add-On Options DESCRIPTION ADD-ON NUMBER 86T Shower Add-On Options (A number from each option column must be used for a complete Product Add-On) HOSE SLIDE BAR Always use if NO selection is required from this column Always use if NO selection is required from this column 7 mm (69") Long Hose Stretches to 9" (7 mm) (See Note ) 9 mm (6") S/S Slide Bar (See Note ) Note: () Base Product for the HOSE must include SHOWER option No. () Base Product for S/S Slide Bar must include SHOWER option No. HOW TO SELECT AND SPECIFY ADD-ON OPTIONS: Example No. : 6 S/S Slide Bar Add-On Suffix Number is - Product Number to Specify: 86T- Refer to for individual models. Note: Use this page as a product submittal sheet. Delta reserves the right () to make changes in specifications and materials, and () to change or discontinue models, both without notice or obligation.