MI4 OL-BLADE-AL(DL)-MI4-EN. Alarms & Remote Start Automotive Data Solutions Inc.

Transcription

1 larms & Remote Start utomotive Data Solutions Inc. MI INSTLL GUIDE OL-LDE-L(DL-MI-EN vailable for : OL-LDE-L Rev. Date: June 9, 05 Doc. No.: ##05## U.S. Patent No. 8,85,80 The brand names and logos found in this guide are property of their respective owners. utomotive Data Solutions Inc. 05! NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill & knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.

2 ll in one U.S. Patent No. 8,85,80 Page of OL-LDE-L(DL-MI-EN 0509 Doc. No.: ##05## install type SeLeCtiOn YeR DT immoilizer YPSS PRioRiTY UnloCK DooR lock DooR UnloCK RM oem lrm DiSRM oem lrm HooD STTUS output** DooR STTUS output TRUnK STTUS output RKe PeDl STTUS output e-rke output TCHoMeTeR output Outlander Sport PTS T* -5 RVR PTS T* -5 instll TYPe MoDel MiTSUiSHi MKe FeTUReS * Take over and idle mode not available. ** Hood Status Output available ONLY on vehicles equipped with factory hood pin. Visit our website for advanced features. utomotive Data Solutions Inc. 05

3 ll in one U.S. Patent No. 8,85,80 Page of OL-LDE-L(DL-MI-EN Doc. No.: ##05## 0509 COmPOnent LOCatOr utomotive Data Solutions Inc. 05

4 ll in one U.S. Patent No. 8,85,80 OL-LDE-L(DL-MI-EN Page of Doc. No.: ##05## 0509 ConneCToR nme ConneCToR ColoR ConneCToR TYPe PoSiTion WiRe ColoR PolRiTY MoDUle loction CoMPonenT loctor RVR PTS T WiRe DeSCRiPTion MiTSUiSHi Outlander Sport PTS T YeR MoDel MKe type - Wire CrOSS reference CHart V C-08 lack pin ETCS/ECU, left side dash Ignition C- 5 pin ETCS/ECU, left side dash ccessory C- 5 pin LtGreen ETCS/ECU, left side dash C-5 9 pin Ltlue ETCS/ECU, left side dash CanL C- lack/ pin Red (DT ETCS/ECU, left side dash CanH C- lack/ pin Green (DT ETCS/ECU, left side dash larm sensor D-5 ~ pin Purple (DT Overhead console, near radar sensor V C-08 lack pin ETCS/ECU, left side dash Ignition C- 5 pin ETCS/ECU, left side dash ccessory C- 5 pin LtGreen ETCS/ECU, left side dash C-5 9 pin Ltlue ETCS/ECU, left side dash CanL C- lack/ pin Red (DT ETCS/ECU, left side dash CanH C- lack/ pin Green (DT ETCS/ECU, left side dash larm sensor D-5 ~ pin Purple (DT Overhead console, near radar sensor -5 Start -5 Start utomotive Data Solutions Inc. 05

5 ll in one U.S. Patent No. 8,85,80 OL-LDE-L(DL-MI-EN Page 5 of 0509 Doc. No.: ##05## type - Wiring diagram RY SO C-5 - WHITE S CE C ETCS/ECU FRONT VIEW LCK C- - WHITE 5 5 NI TI 0 IG T R ST ON 9 C- - LCK/WHITE C-08 - LCK NL C H N C REMOTE STRTER V V INPUT CCESSORY OUTPUT STRTER OUTPUT V GROUND WHEN RUNNING (- OUTPUT IGNITION INPUT/OUTPUT RKE STTUS INPUT CUTION: PERFORM THE INSTLLTION S SHOWN IN THE WIRING DIGRM. MODIFYING THE INSTLLTION TO CHIEVE TKE-OVER WILL RESULT IN VEHICLE MLFUNCTION. *LDE CONNECTOR EXCT PIN-OUT WHITE/RED 0 0 WHITE/LCK WHITE 09 9 NO WIRE PINK/LCK 08 8 PINK NO WIRE 0 LCK ROWN/RED 0 ROWN/YELLOW ORNGE/LCK 05 5 ORNGE/WHITE ORNGE 0 NO WIRE LUE/RED 0 LUE/YELLOW GREEN/RED 0 YELLOW GRY/RED 0 GRY/YELLOW WHITE/LCK (NC WHITE/RED (NC WHITE (NC YELLOW (NC ROWN/RED - CNH ROWN/YELLOW - CNL ORNGE - RKE STTUS OUTPUT ORNGE/WHITE (NC ORNGE (NC PINK/LCK (NC PINK (NC LUE/RED (NC LUE/YELLOW (NC GREEN/RED (NC GRY/RED (NC GRY/YELLOW (NC LCK (NC 8 8 D-5 - OVERHED CONSOLE R M SE NS OR 0 L 85 8 WRNING: PPLY ONLY IF VEHICLE IS EQUIPPED WITH PROXIMITY SENSOR IMPORTNT: FOR PTS MODELS ONLY - NO TKEOVER ND NO IDLE MODE VILLE. UPON OPENING VEHICLE DOOR ENGINE WILL SHUTDOWN. - LL DOORS MUST E CLOSED TO REMOTE STRT VEHICLE. utomotive Data Solutions Inc. 05

6 ll in one U.S. Patent No. 8,85,80 OL-LDE-L(DL-MI-EN Page of Doc. No.: ##05## 0509 Cartridge installation Slide cartridge into unit. Notice button under LED. Ready for Module Programming Procedure. module module PrOgramming PrOgramming PrOCedUre PrOCedUre WitH PUSH - PUSH toto Start Start SyStem x DO NOT PRESS RKE PEDL Push start button twice [x] to ON position. Wait, LED will turn solid LUE GREEN for seconds. x DO NOT PRESS RKE PEDL Push start button once [x] to OFF position. Module Programming Procedure completed. utomotive Data Solutions Inc. 05

7 ll in one U.S. Patent No. 8,85,80 OL-LDE-L(DL-MI-EN Page of Doc. No.: ##05## 0509 identify VeHiCLe year Locate the Vehicle Identification Number (VIN, identify the 0th character then match it to its corresponding year. 5YN5TL8D5R0X 980 l 990 Y M C 98 n C 0 D 98 P D 0 e 98 R e 0 F 985 S F 05 G 98 T G 0 H 98 V H 0 J 988 W J 08 K 989 X K 09 module diagnostics led STTUS DiGnoSTiCS DURinG PRoGRMMinG DURinG ReMoTe STRT WiTH ignition off Flashing RED Missing/wrong information from firmware or vehicle Incorrectly programmed Incorrectly programmed or connected Solid RED Waiting for more vehicle information Incorrectly programmed Not programmed waiting for more vehicle information Flashing LUE dditional steps required to complete programming Correctly programmed and operational False ground when running status from remote starter Solid LUE then OFF Correctly programmed Reset in progress Reset in progress OFF No activity or already programmed Invalid ground when running status from remote starter t rest and ready for a remote start sequence FaCtOry reset PrOCedUre DISCONNECT cartridge from remote starter. PRESS ND HOLD programming button while re-connecting cartridge to remote starter. LED will flash red. Immediately RELESE programming button. LED will turn solid red for seconds. RESET COMPLETED. 5 RECONNECT all connectors. Repeat programming procedure.! Failure to follow procedure may result with a DTC or a CHECK ENGINE error message. utomotive Data Solutions Inc. 05