(Se Upper H Single- Lowe. See Page 14

Transcription

1 (Se Upper H Single- Lowe See Page 14 15

2 e Page 13 for ook Installation) Double-Chained Units Lower Hook Block Chained Units r Hook Block SHOPSTAR ELECTRIC CHAIN HOIST EXPLODED VIEW 16

3 SHOPSTAR ELECTRIC HOIST STATOR Hoists /60 Hoists , and Hoists ROTOR ASSEMBLY (INCLUDES AND ) ROTOR BEARING, OUTBOARD ROTOR BEARING, INBOARD ROTOR THRUST WASHER MOTOR END COVER CAPACITOR Hoists MAIN FRAME (INCLUDES AND ) LIFTWHEEL SEAL PROTECTOR BEARING - MAIN FRAME SIDE CUT-OUT DEVICE Hoists PROTECTOR ASSEMBLY 6 fpm, 1,000 lbs fpm, 500 & 600 lbs fpm, 1,000 lbs fpm, 500 lbs fpm, 600 lbs fpm, 1,000 lbs fpm, 250 & 300 lbs fpm, 500 lbs fpm, 500 lbs fpm, 600 lbs fpm, 250 & 300 lbs fpm, 500 lbs fpm, 250 lbs fpm, 300 lbs PROTECTOR THRUST WASHER GEAR HOUSING (INCLUDES AND ) PROTECTOR BEARING - GEAR HOUSING SIDE FIRST PINION BEARING BRAKE BASE PLATE BRAKE DISC BRAKE ARMATURE BRAKE DRIVER BRAKE DRIVER PIN BRAKE LEAF SPRING BRAKE FIELD (INCLUDES BRAKE COIL) Hoists /60, , and Hoists Hoists BRAKE SPRING BRAKE SCREW PIN RETAINER PLATE PIN RETAINER PLATE SCREW LIFTWHEEL AND GEAR ASSEMBLY 6 fpm, 1,000 lbs fpm, 500, 600 & 1,000 lbs fpm, 500 lbs fpm, 600 & 1,000 lbs fpm, 250, 300 & 500 lbs fpm, 500 & 600 lbs LIFTWHEEL AND GEAR ASSEMBLY cont d 24 fpm, 250, 300 & 500 lbs fpm, 250 & 300 lbs LIFTWHEEL BEARING LIFTWHEEL THRUST WASHER LIFTWHEEL SHAFT SEAL FIRST PINION AND SHAFT BRAKE END COVER BRAKE END COVER SCREW Hoists without contactor Hoists with contactor GEAR HOUSING SCREW GEAR HOUSING SCREW SEAL (No longer used) FRAME PIN HOOK (INCLUDES ) HOOK LATCH KIT HOOK RETAINER HOOK RETAINER SCREW CHAIN GUIDE CHAIN GUIDE/STRIPPER PIN STRIPPER LOAD CHAIN SPECIFY LIFT OR LENGTH LOOSE END RING CHAIN STOP CHAIN STOP SCREW LIFTWHEEL SHAFT FIRST PINION THRUST WASHER POWER CORD GROMMET Hoists without contactor Hoists with contactor POWER CORD Hoists with contactor Hoists without contactor /60, , and Hoists POWER CORD GROUND SCREW CONTROL STATION AND CORD ASSEMBLY (includes control station, cord, warning tag and upper grommet) Orange Control Station for 10 ft lift ft lift ft lift Black Control Station for 10 ft lift ft lift ft lift For other lifts contact CM MOTOR COVER SCREW CAUTION LABEL HOOK BLOCK, Single-chained HOOK BLOCK, Double-chained HOOK BLOCK SCREW, Single-chained HOOK BLOCK SCREW, Double-chained CHAIN PIN HOOK (INCLUDES ) LATCHLOK HOOK DEAD END PLATE, Double-chained

4 SHOPSTAR ELECTRIC HOIST DEAD END PIN, Double-chained SHEAVE WHEEL W/ , Double-chained SHEAVE WHEEL SHAFT, Double-chained SHEAVE WHEEL BEARING, Double-chained SHEAVE WHEEL THRUST WASHER, Double-chain JUMPER (#2) JUMPER (CAP) DEAD END PLATE SCREW, Double-chained CAPACITY/WARNING LABEL 250 lbs lbs lbs lbs ,000 lbs I.D. LABEL 250# (16 FPM) # (16 FPM) # (8 FPM) # (8 FPM) # (13.3 or 16 FPM) / # (13.3 or 16 FPM) / # (6.6 OR 8 FPM) / # (6.6 OR 8 FPM) / # (13.3 OR 16 FPM) , , # (13.3 OR 16 FPM) , , # (6.6 OR 8 FPM) , , # (6.6 OR 8 FPM) , , # (33.3 OR 40 FPM) /60, 1 CONTACT 500# (16.6 OR 20 FPM) /60, 1 CONTACT 500# (19.9 OR 24 FPM) /60, 1 CONTACT 1000# (9.9 OR 12 FPM) /60, 1 CONTACT 500# (13.3 OR 16 FPM) /60, 1 CONTACT 1000# (6.6 OR 8 FPM) /60, 1 CONTACT 500# (9.9 OR 12 FPM) , /60, 1 CONTACT 1000# (4.9 OR 6 FPM) , /60, 1 CONTACT WARNING LABEL SHOPSTAR LABEL WIRE NUT (Specify No. Req d.) GASKET CONTROL CORD ASSEMBLY (includes cord, strain relief and warning tag) for Orange control station and 10 ft lift ft lift ft lift For black control station and 10 ft lift ft lift ft lift For other lifts, contact factory FRAME SPACER CONTACTOR (includes power jumpers) 115 VAC Coils VAC Coils COMPONENTS BOARD-OUTBOARD COMPONENTS BOARD-INBOARD TRANSFORMER 48 Volt Secondary (220/380 primary) Volt Secondary (460 primary) Volt Secondary (230/460 primary) Volt Secondary (575 primary) Volt Secondary (575 primary) DIODE ASSEMBLY CONTROL CORD PLUG POWER CORD PLUG CONTACTOR JUMPER (Specify No. Req d.) VOLTAGE SUPPRESSOR /60, , and Hoists Hoists GROUND JUMPER BRAKE SPACER Part Number for Packaged Lubricants Used in the ShopStar Electric Chain Hoist (Refer to Page 7 for Lubrication Instructions) Part Numbers and Lubricant Type Packaged Quantity Usage Lubricant of Lubricants Hoist Gears Grease for 1/2 lb. Can American for 1 lb. Can Lubricants # for 4 lb. Can Spline on end Oil-Graphite Mixture First Pinion Hercules Packing Co. and Shaft Moly-Duolube for 1 Pint Can Load Chain Oil Fiske Bros. Lubriplate Bar and Chain Oil #10R for 1 Pint Can for 1 Gal. Can 18 Lower Hook Knob Grease Dow Corning Molykote BR-2-S for 1/2 lb. Can for 1 lb. Can When ordering lubricants, specify the type of lubricant, part number and packaged quantity required. Touch-up paints for ShopStar Electric Chain Hoist: Order# *(1) Case (12-12 oz. Aerosol Cans) of Orange Touch-up Paint Part Number *Touch-up paints are only available in case quantities. Note: When painting hoists, also order warning labels, etc. that may be coated during painting.

5 CONTROL STATION (ORANGE) FOR USE ON HOISTS WITHOUT CONTACTOR NOTE: Individual components are not available for repairs Screw (4) Retainer Grommet Control Station No. KEY NO. PART NAME. PART Control station with retainer, screws and grommet Control Station (Black) for use on hoists with contactor and three phase units