TriVac 500 and 700 Pressure Pool Cleaner owners manual

Transcription

1 TriVac 500 and 700 Pressure Pool Cleaner owners manual Hayward Pool Products 620 Division Street Elizabeth, NJ

2 SAFETY FACTS DO NOT use to remove large debris in new pools. REMOVE the cleaner before chemically shocking your pool DO NOT swim with cleaner Store the cleaner in a shaded safe area Hoses must be stored straight. DO NOT coil the hose Keep away from childrens and pets REMOVE cleaner when performing backwash REMEMBER safety first TOOLS LEGEND Tip Filtration pump Pool chemicals Warning Booster pump 2

3 CARTON CONTENTS TriVac 500 or TriVac 700 1x 1x TriVac 500 and 700 WALL CONNECTION CLEANER SIDE 1x GENUINE PARTS 1x 1x Main hose section 1x Cleaner connector hose and sweep tail 3

4 PREPARING THE POOL Manually remove very large and excessive debris from pool (ie. post storm, spring cleaning / pool opening situations). Perform a backwash, clean your filter, skimmer baskets and pump basket. BACKWASH POOL CHEMICALS ph : Chlorine : P.P.M Total Alkalinity : P.P.M DEDICATED RETURN LINE 1-1\2 inch dedicated return + line 1-1/2 female thread Universal wall fitting 3/4 inch dedicated return line 3/4 female thread 1 1/2 inch NPTF x 3/4 inch NPTM adapter (NOT INCLUDED) + + Universal wall fitting OR 4

5 CONNECTING THE TRIVAC INSTALLING WALL FITTING Lay the hose straight for 3 hours OR run on bottom mode for a full cleaning cycle. When installing or reinstalling the universal wall fitting use Teflon tape on its plastic threads. DEDICATED LINE Remove plug or existing universal wall fitting from previously installed pool cleaner (if any). Screw the universal wall fitting into the dedicated line. (see p.4) Connect pressure hose with the wall quick connect 5

6 SIZING PRESSURE HOSE Sizing the hose should be performed without the last section. dedicated line dedicated line dedicated line farthest point farthest point farthest point Connect the hose to wall connector Pull main hose to farthest point of the pool. Extend hose to furthest part of of pool. Measure to 3-4 feet over the edge of the pool and mark hose. Cut the excess length. For every 2 feet of hose removed, one float should be removed starting with the closest from the cutting area. All the remaining floats should remain at same position CUT DO NOT cut the sweep hose Assembling cleaner connector hose with sleep tail to main pressure hose 6

7 DEBRIS BAG ATTACHING DEBRIS BAG CLICK Make sure the bag is not pinched REMOVING DEBRIS BAG Pull the top of the debris bag frame back and then up. Section View CLEANING DEBRIS BAG Full debris bag can reduce cleaner performance. if you allow the bag to dry it will be easier to remove the debris 7

8 SETTING PRESSURE Too much pressure will cause poor cleaning and premature wear of cleaner parts. Low pressure will affect cleaner s performance and cleaning capability BACKWASH 23 PSI (+/- 3) Use a flat blade screwdriver to adjust the wall quick connect knob to reach 23 PSI (+/- 3) - PSI Check pressure regularly + PSI 8

9 TRIVAC NORMAL OPERATION The TriVac 500 (bottom/wall only) and 700 (when in bottom/wall mode) offers best in class pool coverage. Its unique AquaDrive system enables the cleaner to easily climb walls often reaching into areas such as sun shelves or benches that other pressure cleaners simply can t. While most of the pool can be cleaned in 1 hour, 3 hours is considered normal for complete coverage of a standard pool. The cleaning cycle should be extended on pools with special features or shapes such as shelves, steps or swim-outs to allow the TriVac to fully clean all surfaces. Please note that TriVac will not operate properly on areas where the water is less than 8 deep. OPERATING THE TRIVAC 700 CHANGING BOTTOM TO SKIM SWITCH CHANGING SKIM TO BOTTOM SWITCH 9

10 ADJUSTING THE SWEEP HOSE ADJUSTING SWEEP HOSE POWER SWEEP HOSE MOVES SLOWLY OR NOT AT ALL: turn the adjustment knob counter-clockwise to increase sweep hose power. SWEEP HOSE FREQUENTLY SPRAYS OUT OF THE POOL: turn the adjusment knob clockwise to reduce sweep hose power. 10

11 MAINTENANCE REMOVE CLEANER FROM POOL CLEANING THE IN-LINE FILTER if the screen frequently becomes plugged, the filtration system is not performing properly or there is another plumbing problem. SCREEN Make sure the o-ring is in place and properly seated. 11

12 REPLACING PARTS SWEEP HOSE If a hole forms in the sweep hose, it should be replaced. Unscrew the mender nut from the hose and pull the sweep hose off the cleaner connector. Attach a new sweep hose to the cleaner connector. PART NUMBER: TVX7000HST-01 SWEEP HOSE ROLLERS The Sweep hose rollers are wear parts. When the rollers wear-down to the outer groove (wear line) replace the wear roller. PART NUMBER: TVX OUTER GROOVE DEBRIS BAG The debris bag should be replaced if it is torn. PART NUMBER: TriVac 500 TVX5000BA TriVac 700 TVX7000BA SWIVELS If a swivel ceases to turn easily or leaks while the cleaner is running, it should be replaced. PART NUMBER: TVX7000SA-01 TIRES The tires are wear parts. When the tires wear-down to the wear marks replace the tire. PART NUMBER: TVX7000RW-01 (X2) wear marks SIDE ROLLERS The side rollers are wear parts. When the side rollers wear-down, replace the side rollers. PART NUMBER: TVX (X5) 12

13 TROUBLESHOOTING FOR TECHNICAL ASSISTANCE CALL: PROBLEM CAUSE SOLUTION Slow or no forward movement Cleaner does not reach farthest point in pool Cleaner unable to clear obstacles (stairs, steps...) Hose frequently tangles Low or no water pressure Hose too short Hose too short Float not properly placed Hose too long Sweep hose not moving Check filtration and booster pumps, valves, cleaner connections. Check Cleaner pressure. (backwash) Add extra hose section if necessary Add extra hose section Check position of floats on the hose (see diagram) Check hose length Check sweep hose for holes or clogs, increase sweep hose power. Sweep hose sprays out of pool Sweep hose power too strong Reduce sweep hose power Little or no sweep hose movement Trivac running on side or upside down Cleaner cannot climb to the surface in TOP mode Sweep hose power too weak Hole in sweep hose Debris clogging sweep hose Heavy debris Incorrect pressure setting Incorrect pressure setting Too much heavy debris in bag Increase hose power Replace sweep hose Disconnect sweep hose and flush out Empty Bag Check operating pressure Check operating pressure Empty bag Cleaner runs in small circles Hose assembly bent Layout in sun until straight Cleaner get stuck on shallow area of pools (beach entry, tanning shelf...) Cleaner inability to recover from obstacle or specific areas Cleaner does not cover the entire pool The sweep hose may interfere with obstacle The sweep hose may interfere with obstacle Operating pressure too low The sweep hose affects cleaning pattern of cleaner Operate the cleaner without the sweep hose Operate the cleaner without the sweep hose Check operating pressure Operate the cleaner without the sweep hose 13

14 WARRANTY A limited warranty program protects your HAYWARD TRIVAC cleaner. To take full advantage of the limited warranty, please, read, complete and return registration card within the 14 days of purchase date. Your warranty card is packed in the Owner s Guide and accessory pack. HAYWARD POOL PRODUCTS LIMITED WARRANTY To original purchasers of this equipment, Hayward Pool Products warrants these cleaners to be free from defects in materials and workmanship for a period of TWO (2) year (TriVac 700) ore One (1) year (TriVac 500) from the date of purchase, when used in single family residential applications. The limited warranty excludes damage from freezing, negligence, improper installation, improper use or care or any Acts of God. Parts that fail from a defect or become defective during the warranty period shall be repaired or replaced, at our option, within 90 days of the receipt of defective product, barring unforeseen delays, without charge. Proof of purchase is required for warranty service. In the event proof of purchase is not available, the manufacturing date of the product will be the sole determination of the purchase date. To obtain warranty service, please contact the place of purchase or the nearest Hayward Authorized Service Center. For assistance on your nearest Hayward Authorized Service Center please visit us at Hayward shall not be responsible for cartage, removal, repair or installation labor or any other such costs incurred in obtaining warranty replacements or repair. The Hayward Pool products warranty does not apply to components manufactured by others. For such products, the warranty established by the respective manufacturer will apply. The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its pool products and is in lieu of all other warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event shall Hayward Pool products be responsible for any consequential, special or incidental damages of any nature. Some states do not allow a limitation on how long an implied warranty lasts, or the exclusion of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. 14

15 REGISTRATION CARD DETACH HERE: Fill out bottom portion completely and mail within 10 days of purchase/installation or register online Please Print Clearly: First Name Register online at Years Pool has been in service WARRANTY REGISTRATION CARD Last Name Street Address City State Zip Phone Number Purchase Date Address Serial Number Model Number Pool Capacity (U.S. Gallons) Please include me on all communications regarding Hayward Equipment or promotions. Mail to: Hayward Pool Products, 620 Division Street, Elizabeth, NJ Attn: Warranty Dept or REGISTER YOUR WARRANTY ON-LINE AT Thank you for your purchase. < 1 year >15 Purchased from Builder Retailer Pool Service Internet/Catalog Company Name Address City State Zip Phone Type of Pool: Concrete/Gunite Vinyl Fiberglass Other New Installation Replacement Installation for: In Ground Above Ground Spa 15

16 Hayward Pool Products 620 Division Street Elizabeth, NJ