PRODUCT DATASHEET. t~íéêj_äçåâéçtbqj`lk DESCRIPTION

Size: px

Start display at page:

Download "PRODUCT DATASHEET. t~íéêj_äçåâéçtbqj`lk DESCRIPTION"

Kelley Hopkins
6 years ago
Views:

t^qboj_il`hba tbqj`lk t~íéêj_äçåâéçtbqj`lk DESCRIPTION The new water blocked bulkhead tbqj`lk was developed to be used in applications where there will be reverse pressure applied to the connector i.

1 t^qboj_il`hba tbqj`lk t~íéêj_äçåâéçtbqj`lk DESCRIPTION The new water blocked bulkhead tbqj`lk was developed to be used in applications where there will be reverse pressure applied to the connector i.e. subsea electronic pods or ROV systems. This new design is back pressure rated to 100 psi. Inexpensive and reliable Suitable for a variety of applications Available from 2 to 16 contacts KEY FEATURES Optional materials available Short delivery times Current carrying capacity 19 amps per contact (subject to cable)* Contact Resistance: <0.01 ohms Insulation Resistance: >500 megohms after wet mating Mating Cycles: >500 wet matings** DESIGN SPECIFICATION * Maximum current carrying capacity for contacts may be affected by cable selection ** Provided proper handling procedures are adhered to Operating Voltage: 600 VDC Pressure Ratings: Mated condition In-line: 20,000 psi (46,000ft) Mated condition Bulkhead: 10,000 psi (23,000ft) Open face pressure Bulkhead: 1,000 psi (2,300ft) Page 1 of 7

MATERIALS Standard Optional Connector Body Neoprene Hypalon Bulkhead Shell DGS 1043 or CA630 per QQ-C-465 316 Stainless Steel (no cost option) 6061-T6 Aluminium, Hard Anodized Contacts Guide Pins

2 MATERIALS Standard Optional Connector Body Neoprene Hypalon Bulkhead Shell DGS 1043 or CA630 per QQ-C Stainless Steel (no cost option) 6061-T6 Aluminium, Hard Anodized Contacts Guide Pins O-Rings In-Line Cable Bulkhead Pigtails Locking Sleeves Bulkhead Nut/Washer Copper Alloy Gold plated per MIL-G Stainless Steel Buna N, 70 Durometer #18 AWG SO 18 inch standard length Teflon (Registered trademark for DuPont) type E hook-up wire* #14 or #16 AWG SO 18 inch standard length Delrin (DuPont trademark for Acetal Resin) Brass or Stainless Steel Part Description Number of Contacts BH-2-WB-FS/MP BH-3-WB-FS/MP BH-4-WB-FS/MP AMPACITY CHART FOR STANDARD PARTS (18 AWG SO CABLE) Ampacity 7 amps 7 amps 5.6 amps Part Description Number of Contacts BH-6-WB-FS/MP BH-8-WB-FS/MP Ampacity 5.6 amps 4.9 amps See following pages CONFIGURATIONS QUALITY operate a Quality Management System accredited to Page 2 of 7

3 Page 3 of 7

4 Page 4 of 7

5 Page 5 of 7

6 Page 6 of 7

7 FACE PATTERNS IL-1-FS IL-2-FS IL-3-FS IL-4-FS IL-6-FS IL-8-FSX IL-10-FSX IL-12-FSX IL-16-FSX NOTE: Female face view only. For male face view contact configurations please contact. STANDARD WIRING COLOR CODE pq^ka^oafkjifkb`lilo`labepl`^_ibf `lilo `lilo N _i^`h V dobbkl_i^`h O tefqb NM lo^kdbl_i^`h P oba NN _irbl_i^`h Q dobbk NO _i^`hltefqb R lo^kdb NP obaltefqb S _irb NQ dobbkltefqb T tefqbl_i^`h NR _irbltefqb U obal_i^`h NS _i^`hloba All reasonable efforts have been taken to ensure that the information contained herein is accurate at the date of publication, but no representation or warranty as to the accuracy or completeness of such information is intended or to be implied by its inclusion herein. Any and all representations and warranties pertaining to the information and products referred to herein shall be set forth in pb^`lk standard sales order form. In addition, pb^`lk reserves the right to make changes to the contents hereof without notice, therefore it is suggested that at the time of inquiry, the appropriate sales office or factory be contacted directly for verification of published specifications and products availability ALL RIGHTS RESERVED Page 7 of 7

R49 SERIES TABLE OF CONTENTS

PRODUCT GUIDE R49 SERIES TABLE OF CONTENTS 3 Product Overview 4 Features Spotlight 5 Code Logic 6 Panel Mount Receptacle Female 7 Panel Mount Receptacle Male 8 Cable Mount Receptacle 9 Bulkhead Mount Receptacle