Fully illuminated pushbutton switches - bushing Ø 24 mm - momentary or latching

Transcription

1 istinctive features and specifications Full actuator or symbol illumination UG1410R1 Suited for integrated designs Large but lightweight Sealed to IP69K Pad printed or laser etched symbols Pad printing Laser Nonilluminated Illuminated LTRIL SPIFITIONS Max. current/voltage rating with resistive load : silver contacts (code 2) : 4 12V gold plated contacts (code 4) : 200m 12V Initial contact resistance : 50 mω max. Insulation resistance : 1 GΩ min. at 500V ielectric strength : Vrms 50 Hz min. lectrical life at full load : Momentary models : 1 million cycles (gold plated contacts) cycles (silver contacts) Latching models : cycles MTRILS ase : P46 ctuator : P12 ushing/ bezel : P66 ontacts : silver (code 2) or silver, gold plated (code 4) able : length 300 mm, section depending on switch model Terminal seal : epoxy or overmolding GNRL SPIFITIONS Front panel sealing : IP69K according to IN Panel thickness : 1(.039) to 18 mm (.708) max. Total travel : 2,5 mm ± 0,5 mm Typical operating force : 8N ± 2N Low level or mechanical life : Momentary models : 1 million cycles Latching models : cycles Torque : 3 Nm max. applied to nut Operating temperature : 40 to +75 WIRING IGRM L POL 2 POL 1 + L The company reserves the right to change specifications without notice. PM 145

2 Overview FP SRIS ctuator lectrical function Terminals Model Threaded bushing, dia. 24 mm P R F Round, flat Round, curved Round, curved, flush New! 1 OFF ON 3 Normally open (NO) L control and No of poles 1 Solder lugs 2 Straight cable 3 Right angle cable, length 300 mm Nonilluminated, 1 pole Nonilluminated, 2 poles, 1 pole, 2 poles, 1 pole, dimming L ontact mat. ctuator colour ezel colour L colour L resistor Symbols 2 Silver 4 Silver, gold plated 1 lue 2 lack 3 Green 4 Grey 5 Yellow 6 Red 7 White/natural 9 Orange 1 lue 2 lack 3 Green 4 Grey 5 Yellow 6 Red 7 White/natural X F G Nonillum. lue Green Red Yellow White Red/green Red/blue 0 No resistor supplied 1 12V resistor 2 24V resistor Marking X No marking 1 Pad printing 2 Laser See end of series OUT THIS SRIS On the following pages, you will find successively : model structure of switches and options in the same order as in above chart imensions : first dimensions are in mm while inches are shown as bracketed numbers. NOTI : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Mounting accessories : Standard hardware supplied : 1 hex nut and 1 ORing Packaging unit : solder lug versions : 20 pieces cable versions : 1 piece PM

3 Ø24.20 (.953I) Three terminal types urved or flat actuator (.445) FP (.886) To order a product, replace with one of the codes selected under L control and number of poles on next page, then add the desired options. MOL STRUTUR 6.30 (.248) 0.50 (.020) 2.80 (.110) Solder lug terminals LTHING FPR1 1 OFF ON FPP1 1 OFF ON (.886) FPT1 MOMNTRY (NO) FPR3 1 FPP (.248) 0.50 (.020) 2.80 (.110) Straight cable terminals LTHING FPR1 2 OFF ON FPP1 2 OFF ON MOMNTRY (NO) FPR3 2 FPP /0 ( /0) /0 ( /0) FPT2 Right angle cable terminals LTHING FPR1 3 OFF ON FPP1 3 OFF ON MOMNTRY (NO) FPR3 3 FPP /0 ( /0) FPT3 PM 147

4 Options L ONTROL N NUMR OF POLS omplete the model numbers on previous pages with one of the following codes. Function 1 (latching) Function 3 (momentary) Function 1 (latching) Function 3 (momentary) Nonilluminated FPSH1 FPSH2 + + FPSH5 FPSH5 FPSH6 FPSH6 Nonilluminated two poles FPSH3 FPSH4 two poles imming L FPSH7 FPSH8 dotted line = jumper to be wired by the user. L has to be wired to one pin of pole 2. FP30SH ONTT MTRILS 2 Silver 4 Silver, gold plated TUTOR OLOUR 1 : blue 2 : black 3 : green 4 : grey 5 : yellow 6 : red 7 : white/natural 9 : orange ZL OLOUR 1 : blue 2 : black 3 : green 4 : grey 5 : yellow 6 : red 7 : white/natural L OLOUR X : nonilluminated : blue : green : red : yellow : white F : red/green G : red/blue PM

5 Options L RSISTOR 0 No resistor supplied 1 12V resistor 2 24V resistor MRKING X No marking 1 Pad printing 2 Laser SYMOLS XX No symbol vailable symbols See end of Krange, section. Marking colour White marking for illuminated actuators (laser etching) and nonilluminated black actuators (pad printing). lack marking for nonilluminated colour actuators (pad printing). Other : on request. Marking area The symbol will be included in the hatched area. Ø16.00 (.630I) FPZL Flat PM 149