Pumping Industry 101. THE DYNAMICS of pumping grease waste works and the responsibilities we carry

Transcription

1 Pumping Industry 101 THE DYNAMICS of pumping grease waste works and the responsibilities we carry

2 PUMP TRUCK PUMPING OF GREASE WASTE WORKS

3 Different brands Different sizes Vacuum Pumps Different vacuum power Same concept To vacuum waste from underground. Three directional function Size does matter and altitude affects performance of power in Colorado.

4

5 Massport Pump Three Direction pump. Natural, vacuum and pressurize

6 Tanks Different size of tanks 300 gallons to 5500 gallons Rated volume of tank vs. true volume held Steel tanks Aluminum tanks Various size valves Working Valves in back 6 dump valve / 3-4 suction valve

7 3600 Gallon Tank Typical 3600 gallon pump truck

8 VALVES 3 TO 4 SUCTION VALVES 6 DUMP VALVE

9 Function of a pump tank

10 LARGE SPILL FROM REVERSING PUMP IN FRONT, PATIO EATING AREA OF A VERY HIGH END RESAURANT

11 GREASE SPILL CLEAN UP WAS EXTENSIIVE AND EXPENSIVE

12

13 PUMP SET UP PUMP TRUCK CLOSE TO GREASE TRAP FOR SERVICE

14 GREASE TRAP LOCATIONS IN FRONT OF RESTAURANTS IN BACK OF RESTAURANTS IN LANDSCAPING LOADING DOCS IN BASEMENTS IN PARKING GARAGES SIDEWALKS PARKING LOTS DRIVE THRUS UNDER CRAWL SPACE

15 GREASE TRAP FRONT DOOR OF RESTAURANT

16 GREASE TRAP BACK OF RESTAURANTS

17 GREASE TRAP LANDSCAPING

18 GREASE TRAP LOADING DOCK

19 GREASE TRAP PARKING GARAGE ENTRANCE

20 GREAE TRAP SIDEWALKS

21 GREASE TRAP PARKING LOTS

22 GREASE TRAP DRIVE THRU

23 GREASE TRAP HANDICAP PARKING LOT

24 GREASE TRAP BELOW PARKING GARAGE

25 PLASTIC 2000 GALLONS GREASE TRAP PLASTIC GREASE TRAP IN PARKING GARAGE

26 GREASE TRAP/INTERCEPTORS OUTSIDE GREASE TRAPS/INTERCEPTORS INSIDE GREASE TRAPS/INTERCEPTORS CONCRETE PLASTIC STEEL

27 INSIDE GREASE TRAP GREASE TRAP INSIDE KITCHEN AREA

28 GREASE TRAP SMALL GREASE TRAP UNDER SINK 2 GALLONS

29 GREASE TRAP UNDER SINK GREASE TRAP 5 GALLONS

30 UNDER KITCHEN SINK TRAP 3 BAY WASH SINK EACH HOLDING 35 GALLONS

31 GREASE TRAP INSIDE GREASE TRAP IN FLOOR

32 GREASE TRAP IN FLOOR TRAP WITH SEWER TEES

33 GREASE TRAP SIZES AND ACCESS GREASE TRAPS RANGE FOR 2 GALLONS TO GALLONS AND MORE AVERAGE SIZE 1000 GALLONS TO 1500 GALLONS MID RANGE 2000 GALLONS TO 5000 GALLONS EASY ACCESS, SHALLOW HARD ACCESS, DEEP ONLY 2 FOOT ACCESS HOLE AFFECT IN CLEANING DEPENDS ON ALL OF THE ABOVE

34 EASY ACCESS, SHALLOW EASIER THE ACCESS THE EASIER IT IS TO CLEAN

35 EASY TO CLEAN 1200 GALLON GREASE TRAP

36 PRIMARY CHAMBER BEFORE GREASE TRAP

37 SECONDARY CHAMBER GREASE TRAP

38 PRIMARY CHAMBER AFTER GREASE TRAP PUMP AND CLEANED WITH PROPER TOOLS

39 SECONDARY CHAMBER CLEANED WITH PROPER TOOLS

40 BAD ACCESS PRIMARY CHAMBER WITH OBSTRUCTION

41 VIEW OF TRAP WITH HOSE VERY LITTLE VIEW AND ROOM TO WORK WITH

42 PRIMARY CHAMBER 1500 GALLON 2 FOOT ACCESS REDUCED TO 1 FT ACCESS WITH A 5 FT DEEP THROAT

43 SECONDARY CHAMBER 1500 GALLON ACCESS CUT AWAY FROM SEWER TEE AND REDUCED BY A FOOT

44 VERY DEEP GREASE TRAP GREASE TRAP WITH STEPS AND A PLATFORM

45 PRIMARY CHAMBER GREASE TRAP 8 X 6 HOLE

46 LARGE GREASE TRAP 5000 GALLON WITH 3 LIDS

47 VERY LARGE GREASE TRAP 4 LIDS

48 5500 GALLON GREASE TRAP 2 LID ACCESS TO A 5500 GALLON GREASE TRAP. EACH LID 2 FT A CROSS

49 750 GALLON GREASE TAP 2 LID GREASE TRAP ON PLATFORM BY DRIVE THRU

50 COLORADO CONVENTION CENTER STARTING POINT TO GREASE TRAP

51 COLORADO CONVENTION CENTER HOSES DEPLOYED UP THE RAMP

52 COLORADO CONVENTION CENTER GREASE TRAP LOCATED BY PAY BOTHS

53 GREASE TRAPS CONDITIONS NORMAL CONDITIONS ABNORMAL CONDITIONS

54 PRIMARY CHAMBER PRIMARY CHAMBER LEVEL IS GOOD. NO GREASE ON SIDE OF WALLS, NO GREASE ON TOP OF SEWER TEE

55 SECONDARY CHAMBER SAME AS PRIMARY

56 PRIMARY CHAMBER GREASE PILED AND STUCK TO SEWER TEE AND WALL

57 PRIMARY CHAMBER GREASE TRAP OVER FLOWED. THICK GREASE STUCK ON WALLS

58 PRIMARY CHAMBER GREASE TRAP PACKED AND HARDENED

59 PRIMARY CHAMBER GREASE TRAP THICK AND TURNING BLACK

60 PRIMARY CHAMBER GREASE TRAP CHOCKED WITH GREASE BUILD UP

61 PRIMARY CHAMBER GREASE TRAP HIGH LEVEL, OVER FLOWING

62 PRIMARY CHAMBER BROKEN SEWER TEE

63 ? TAKE A GUESS

64 IS THIS THE RIGHT WAY? HIRING THE RIGHT CONTRACTOR

65 PUMPING COMPANY DRIVER: I HATE MY JOB

66 PROPER TOOLS IMPORTANT Typically 3 hoses Hoses have cam locks Man hole hooks Pry bars Assorted tools 3 pvc stingers Power washer Scrapers???

67 GROCERY STORE PRODUCE

68 GARBAGE DISPOSAL (GARBEL)

69 WHAT PRODUCE?

70 BASEMENT BATHROOM

71 18 SEWER MAIN HEAVY GREASE

72 HARD WORK BAD HOURS EVIL SMELL GREASE TRAP PUMPING LOTS OF DRIVING NOT A LOT OF COMPANIES MORE FOOD SERVICING FACILITIES THEN PUMPERS SPECILZED TYPE OF WORK SPECIAL TYPE OF PERSON

73