EM4410TS-4 125HP,1785RPM,3PH,60HZ,444TS,A44076M,TEF

Transcription

1 Product Information Packet EM0TS- HP,RPM,PH,0HZ,TS,A0M,TEF opyright All product information within this document is subject to Baldor Electric ompany copyright protection, unless otherwise noted.

2 Part Detail Revision: K Status: PRD/A hange #: Proprietary: No Type: A Prod. Type: A0M Elec. Spec: AWG0 D Diagram: 0-0 Enclosure: TEF Mfg Plant: Mech. Spec: Layout: -00 Frame: TS Mounting: F Poles: 0 reated Date: 0--0 Base: Rotation: R Insulation: F Eff. Date: Leads: #/0 Replaced By: Literature: Elec. Diagram: Page of

3 Nameplate NPL AT.NO. EM0TS- SPE NO. PG90 HP AMPS VOLTS 0 DESIGN B FRAME TS RPM HZ 0 AMB 0 SF. DRIVE END BEARING 90B0J0X PHASE DUTY ONT INSUL.LASS F OPP D.E. BEARING 90B0J0X TYPE P ENL TEF ODE G SER.NO. POWER FATOR NEMA-NOM-EFFIIENY 9. MAX ORR KVAR.0 GUARANTEED EFFIIENY 9. NEMA NOM/SA QUOTED EFF MOTOR WEIGHT 00 Page of

4 xt REL. S.O. AMPS E/S FRAME HP TYPE T P /0 0 DUTY ONT 0/F. B G TEF ROTOR AMB / INSUL. S.F. TEST S.O PERFORMANE LOAD HP AMPERES RPM NO LOAD / / / / / LOKED ROTOR PULL UP BREAKDOWN FULL LOAD PHASE/ HERTZ NEMA DESIGN TEST DATE SPEED TORQUE RPM TORQUE % FULL LOAD RPM ODE LETTER % POWER FATOR TORQUE LB.-FT. VOLTS ENL. STATOR RES.@ OHMS (BETWEEN LINES) % EFFIIENY AMPERES Page of AMPERES SHOWN FOR 0. VOLT ONNETION. IF OTHER VOLTAGE ONNETIONS ARE AVAILABLE, THE AMPERES WILL VARY INVERSELY WITH THE RATED VOLTAGE REMARKS: TYPIAL DATA NEMA NOMINAL EFFIIENY = 9.PT. DR. BY K. BY APP. BY DATE D D R. MELVEEN A- MOTOR PERFORMANE DATA AWG0-R00 // ISSUE DATE 09/0/ Printed on 9// bengap0.bal

5 xt RPM S.F.. ROTOR 0 T VOLTS 0 NEMA DESIGN B TEST S.O. TYPIAL DATA AMPS ODE LETTER G TEST DATE --- P DUTY ONT ENLOSURE TEF STATOR RES.@.0 /0 AMB /INSUL 0/F E/S 0 REL S.O. FRAME HP TYPE PHASE/HERTZ!" %& '(( OHMS (BETWEEN LINES) #$ Page of AMPERES SHOWN FOR ONNETION, IF OTHER VOLTAGE ONNETIONS ARE AVAILABLE, THE AMPERES WILL VARY INVERSELY WITH THE RATED VOLTAGE. DR. BY K. BY APP. BY DATE A- MOTOR PERFORMANE URVES Printed on 9// bengap0.baldor.com ISSUE DATE

6 xt RPM S.F.. ROTOR 0 T VOLTS 0 NEMA DESIGN B TEST S.O. TYPIAL DATA AMPS ODE LETTER G TEST DATE --- P DUTY ONT ENLOSURE TEF STATOR RES.@.0 /0 AMB /INSUL 0/F E/S 0 OHMS (BETWEEN LINES) REL. S.O. FRAME HP TYPE PHASE/HERTZ 9 Page of REMARKS:!" AMPERES SHOWN FOR VOLT ONNETION, IF OTHER VOLTAGE ONNETIONS ARE AVAILABLE, THE AMPERES WILL VARY INVERSELY WITH THE RATED VOLTAGE. DR. BY K. BY APP. BY DATE #$# A- MOTOR PERFORMANE URVES ISSUE DATE "## Printed on 9// bengap0.bal

7 -00 F DUTY MASTER ALTERNATING URRENT MOTORS SQUIRREL-AGE INDUTION F ENLOSURE: TOTALLY ENLOSED FRAME GTS ABOVE NEMA RATINGS OOLING: FAN OOLED MOUNTING: FOOT INLUDES TS FRAME MOUNTING HOLES E E D.0 D.00. SQ. KEY LEAD OPENING / HOLES B B GROUND HOLES QTY /- TAP; QTY /- TAP VARIES +.00,-.0 VARIES +.000,-.00 ON STANDARD MOTORS THIS IS ONDUIT SIZE. ON XT AND ORROSION PROOF MOTOR THIS IS PIPE TAP. MOTOR WEIGHTS MAY VARY BY % DEPENDING ON RATING. OBSTRUTION MUST NO ENROAH ON AIR INLET WEIGHT (LBS): 00 DRIVE END AIR DEFLETOR IS ONLY INLUDED WHEN NEESSARY. A SHEET NUMBER OF -00 ONDUIT BOX LOATED ON OPPOSITE SIDE WHEN F-. IF MOUNTING LEARANE DETAILS ARE REQUIRED, ONSULT FATORY. MAXIMUM PERMISSIBLE SHAFT RUNOUT WHEN MEASURED AT END OF STANDARD SHAFT EXTENSION IS.00" T.I.R. TO INH DIA. DIMENSIONS ARE IN INHES; SEE SHEET FOR DIMENSIONS IN MILLIMETERS USTOMER IS RESPONSIBLE FOR DETERMINING THAT MOTOR PERFORMANE IS SUITABLE IN THE APPLIATION. REV. DES: ADJUSTED OVERALL LENGTH DIMENSION REV: D VERSION: 0 REVISED: 0:: 09/09/0 TDR: MODEL NO. -00 REF: GTS/TS STD FOOTED SIDE/ENTER /B BY: RAGJSS Material: -00 A Page of

8 -00 F DUTY MASTER ALTERNATING URRENT MOTORS SQUIRREL-AGE INDUTION F ENLOSURE: TOTALLY ENLOSED FRAME GTS ABOVE NEMA RATINGS OOLING: FAN OOLED MOUNTING: FOOT INLUDES TS FRAME MOUNTING HOLES E. E D. D..9 SQ. KEY LEAD OPENING / HOLES B B GROUND HOLES QTY /- TAP; QTY /- TAP VARIES +.00,-.0 VARIES +.000,-.00 ON STANDARD MOTORS THIS IS ONDUIT SIZE. ON XT AND ORROSION PROOF MOTOR THIS IS PIPE TAP. MOTOR WEIGHTS MAY VARY BY % DEPENDING ON RATING. OBSTRUTION MUST NO ENROAH ON AIR INLET WEIGHT (KGS): 90 DRIVE END AIR DEFLETOR IS ONLY INLUDED WHEN NEESSARY. A SHEET NUMBER OF -00 ONDUIT BOX LOATED ON OPPOSITE SIDE WHEN F-. IF MOUNTING LEARANE DETAILS ARE REQUIRED, ONSULT FATORY. MAXIMUM PERMISSIBLE SHAFT RUNOUT WHEN MEASURED AT END OF STANDARD SHAFT EXTENSION IS.0 MM T.I.R. TO MM DIA. DIMENSIONS ARE IN MILLIMETERS; SEE SHEET FOR DIMENSIONS IN INHES USTOMER IS RESPONSIBLE FOR DETERMINING THAT MOTOR PERFORMANE IS SUITABLE IN THE APPLIATION. REV. DES: ADJUSTED OVERALL LENGTH DIMENSION REV: D VERSION: 0 REVISED: 0:: 09/09/0 TDR: MODEL NO. -00 REF: GTS/TS STD FOOTED SIDE/ENTER /B BY: RAGJSS Material: -00 A Page of

9 Page 9 of