Transmitter/Controller Series JUMO dtrans ph 01, Rd 01, Lf 01, Rw 01, Az 01

Transcription

1 Transmitter/Controller Series JUMO dtrans ph 01, Rd 01, Lf 01, Rw 01, Az 01 with C-UL-US approval PR EN ph mv ms/cm µs/cm M xcm

2 Transmitter/ Controller Series JUMO dtrans ph 01, Rd 01, Lf 01, Rw 01, Az 01 completely in microprocessor technology simple operation from membrane keys simultaneous indication of process value and temperature on easily read LED display up to two isolated analog outputs, for use as process value output or proportional controller (freely configurable) temperature monitoring is available sensor monitoring is available as standard two freely programmable relays for limit monitoring or control, also one alarm output up to four relay outputs can be implemented pulse duration or pulse frequency controller with P, PI, PD and PID action programmable modulating controller function compact size 96 x 48 x 110mm (W x H x D) protection IP65 front only two power supply variants from 24V DC to 240V AC interface RS422 / 485 (option) PROFIBUS-DP surface-mounting or outdoor case IP65 available manual function (pulsing and switching) simulated process output available, e.g. for dry start-up Az 01 version standard signal input 0 / 4-20mA universal calibration adaptation supply voltage for 2-wire transmitters Operation Operating level Parameter level Configuration level The controller parameters and configuration data are arranged on several levels for easy programming and operation. The levels are protected against unauthorized access by codewords. Membrane keys provide simple and user-friendly operation. The two LED displays indicate parameter symbols and corresponding values. JUMO SVS3000 Process visualization software with batch-related data reporting and evaluation Simple and rapid linking of Series JUMO dtrans ph - 01, Rd 01, Lf 01, Rw 01, Az 01 microprocessor transmitter/controller to the SVS3000 visualization software. (You can request further information on the SVS3000 using the fax reply on the back page.) *relays are also programmable as limit comparators for temperature

3 JUMO dtrans ph 01 for ph Complete measurement chain from one supplier JUMO dtrans Rd 01 for redox potential ph and metal electrodes, conductivity cells, fittings and accessories are also available JUMO dtrans Lf 01 for electrolytic conductivity JUMO dtrans Rw 01 for high-purity water wall-mounting housing (option)

4 Simple operation... e.g. calibration of ph electrode 1. Enabling the operating level Instrument in measurement mode (Fig. 1) protected against unauthorized operation by codeword Fig. 1 Press key PGM,hold down until Cod.E appears Using the arrow keys set codeword for operating level and enter with PGM (Fig. 2) Fig. 2 Press EXIT key instrument jumps back to measurement mode 2. Calibration with 2 buffer solutions Start calibration by pressing and PGM simultaneously Fig. 3 Set temperature of buffer solution with arrow keys (manual temperature compensation), or indication of measured buffer temperature (automatic temperature compensation) (Fig. 3) Enter with PGM Fig. 4 CAL 1: immerse electrode in first buffer solution. As soon as reading is steady, adjust indication with arrow keys to buffer ph, enter with PGM (Fig. 4) CAL 2: use buffer 2, repeat as for CAL.1 (Fig. 5) Fig. 5 Instrument jumps back to measurement mode (Fig. 1)

5 measurement and control range ph 1.00 to can be switched from ph to redox (ORP) with redox: display in %, without dimensional unit (can be freely assigned) electrode connection through BNC connector suitable for all conventional ph and redox electrodes (combination electrodes and separate measurement / reference electrodes) input for antimony electrodes provided version for JUMO 2-wire ph transmitter available measurement and control range 1999 to mv, freely adjustable display in %, without dimensional unit (can be freely assigned) suitable for all conventional redox electrodes (metal combination electrodes or separate metal and reference electrodes) temperature indication can be switched on version for JUMO 2-wire redox transmitter available freely adjustable ranges from 0-0.5µS / cm to 0-200mS / cm in one instrument selection without jumpers or solder links can be connected to electrolytic 2-electrode cells with cell constants 0.01 / 0.1 / 1.0 / 3.0 / 10.0 (also intermediate values) integrated calibration for temperature coefficient and cell constant cable break monitor freely programmable dual-slope calibration of process value output for electrolytic 2-electrode cells with cell constant 0.01 and 0.1 indication can be switched from MOhm cm to µs / cm temperature compensation to ASTM D meets the requirements of USP several compensation curves are stored: acidic (HCl), alkaline (NaOH), high-purity water (NaCl); temperature compensation linear or switched off cell constant programmed manually

6 High-profile products and services Phone: Analytical Measurement ph/redox: sensors and transmitters/controllers Conductivity instrumentation: conductive and inductive Dissolved oxygen measurement Chlorine, chlorine dioxide, ozone, hydrogen peroxide and peracetic acid instrumentation Fittings and accessories Controllers, Power units, System/ Recording technology Process controls and programmers Automation software Electronic thermostats/microstats Safety temperature monitor/limiter Digital indicators Process controller Recording instruments Temperature transmitters Thyristor power switches /power units Software and accessories Thermostats and Dial Thermometers Panel and surface mounting thermostats in TR, TW, TB, STW and STB versions Room thermostats Warm-air thermostats Ex thermostats (ATEX) Electronic thermostats Dial thermometers as indicating and control instruments Bimetallic temperature switches Electronic temperature indicators with transmitter Pressure measurement technology Pressure transmitters Level probes Pressure gauge Pressure switch Pressure cells Chemical seals and accessories Electronic modules CAD layouting Component procurement THT and SMD placing AOI-testing In-circuit testing Functional testing Run-In Final assembly Final instrument test Transducers for Temperature and Humidity Thermocouples Resistance thermometers Ex temperature probes (ATEX) Wireless temperature probe Humidity measuring instruments DKD (German Calibration Service) laboratory Nationally accredited testing station for heat Metalworking Stamping and forming systems Tool manufacture Flexible sheet metal working Welding, jointing and assembly systems Surface engineering Machining Float Materials laboratory Platinum temperature sensors in wirewound technology: Glass Glass with glass extension Ceramic Foil in thin-film technology: Chip with connecting wires Chip in SMD style on epoxy board Chip with terminal clamps Chip in cylindrical style Chip in SMD style Service Planning and project design for automation solutions German Calibration Service (DKD) for temperature Support during commissioning and optimization Worldwide service network Technical support line Seminars and workshops Fieldbus center Technical literature JUMO home page: / Head office Fulda JUMO GmbH & Co. KG mail@jumo.net Darmstadt Essen Hannover Ingolstadt Leipzig Stuttgart Austria JUMO Mess- und Regelgeräte Ges.m.b.H info@jumo.at Belgium JUMO Automation S.P.R.L./P.G.M.B.H./B.V.B.A info@jumo.be Bulgaria JUMO Izmervatelni uredi i Regulatori jumobg@centrum-group.com Croatia JUMO Mess- u. Regelgeräte Ges.m.b.H info@jumo.hr Czech Republic JUMO Mereni a regulace s.r.o info@jumo.cz Denmark JUMO Måle- og Reguleringsteknik A/S info.dk@jumo.net France JUMO Régulation SAS info.fr@jumo.net Hungary JUMO HUNGARIA Kft jumobudapest@jumo.hu China JUMO Automation Dalian Co. Ltd. India JUMO India Pvt. Ltd. info@jumo-china.com info.in@jumo.net Italy JUMO Italia SRL info.it@jumo.net Netherlands JUMO Meet- en Regeltechniek B.V info@jumo.nl Norway JUMO AS info.no@jumo.net Poland JUMO Sp.z.o.o biuro@jumo.com.pl Romania S.C. JUMO Romania S.R.L info@jumo.ro Slovakia JUMO Slovensko s.r.o jumo@stonline.sk Slovenia JUMO merilni in regulacijski aparati info@jumo.si Spain JUMO Control S.A g.jentsch@jumo.es Sweden JUMO Mät- och Reglerteknik AB info@jumo.se Switzerland JUMO Mess- und Regeltechnik AG info@jumo.ch Russia JUMO GmbH jumo@jumo.ru Turkey Serbia/Montenegro JUMO Ölçü Sistemleri ve JUMO Mereni i regulacioni uredajaj mail@jumo.com.tr sipljan@eunet.yu USA JUMO Process Control, Inc info@jumo.us United Arab Emirates JUMO GmbH & Co. KG info.ae@jumo.net United Kingdom JUMO Instrument Co. Ltd sales@jumo.co.uk For further international locations please visit