PRODUCT DATASHEET Laura series last update 25/2/2013

Transcription

1 Ordering number CA353_LAURA-RS (simulated) 8 (simulated) 5 (simulated) 2+36 (simulated) 0 Ordering number CA355_LAURA-M Ordering number CA365_LAURA-O Ordering number CA643_LAURA-SS May 8th 203 5:34 Copyright - Subject to change without prior notice - Page /3

2 Ordering number CA360_LAURA-D 4 degrees 62 degrees 7 degrees Ordering number CA766_LAURA-WW Ordering number CA525_LAURA-R-W NOTE: The typical divergence will be changed by different color, chip size and chip position tolerance. The typical total divergence is the full angle measured where the luminous intensity is half of the peak value. May 8th 203 5:34 Copyright - Subject to change without prior notice - Page 2/3

3 GENERAL INFORMATION - Product series especially designed & optimized for series of s. - Special care taken to make light distribution as uniform as possible. - Lens material optical grade with high UV and temperature resistance. Allows use of high current and temperature conditions. Please find more information about used material from below: Lens material optical grade with high UV and temperature resistance (20 degrees of Celcius / 248 degrees of Fahrenheit). Allows use of high current and temperature conditions. Please find more information about used materials from below: - Reflector is made of aluminium coated (20 degrees of Celcius / 248 degrees of Fahrenheit) with protective lacquer (0 degrees of Celcius / 230 degrees of Fahrenheit). - Optic holder molded by high quality material (20 dergees of Celcius / 248 degrees of Fahrenheit). - to heat sink with a PU foam adhesive tape of automotive grade. Please find fastening details by clicking link: /datasheets/datasheet_tape.pdf NOTE : We advise customer to ensure the suitability and sufficiency of the bond in the end product. For example, mechanical stress, vibration and holes on the surface of the circuit boar weaken the strength of the tape. NOTE 2: to the surface must be made straight, so the tape bonds constant and balanced with fastening surface. Slanted assembly might cause unbalanced bond to the surface. All surfaces where tape is applied must be clean, dry and free from grease and dirt. If cleaning of B surfaces is needed, please follow strictly the cleaning instructions of your manufacturer - this is important as cleaning shall under no circumstances damage s or other electronics components on the B. Further note that optical components shall not be cleaned with any chemicals - only micro fiber cloth may be used to remove fingerprints or other traces from handling. May 8th 203 5:34 Copyright - Subject to change without prior notice - Page 3/3

4 Relative intensity of CA525_-Refl-W--tape 00% 75% 50% 25% 0%

5 A B C D 4 4 Isometric view Scale: : 2.6 Bottom view Lens Holder Front view 2 2 Materials lens: holder:, black : PU Foam This drawing is our property. It can't be reproduced or communicated without our written agreement. DRAWN BY CHECKED BY DESIGNED BY Led Teh FIN Fin DRAWING TITLE pv SIZE hh hh D Datasheet -tape series assy DRAWING NUMBER A4 SCALE 2: WEIGHT(g) REV CA353 SHEET A /