PRODUCT DATASHEET Laura series last update 14/6/2012

Transcription

1 PRODUCT DATASHEET series last update 14/6/2012 CA13307_LAURA-O-WAS-PIN 21.6x21.6 mm 13.1 mm Pin, tape Asym degrees 83 % CP13308_LAURA-O-WAS-PG 21.6x21.6 mm 12.9 mm Pin, glue Asym degrees 83 % CP13311_LAURA-SS-WAS-PG 21.6x21.6 mm 12.9 mm Pin, glue Asym degrees 93 % CA13312_LAURA-SS-WAS-PIN 21.6x21.6 mm 13.1 mm Pin, tape Asym degrees 93 % May 8th :12 Copyright Ledil Oy - Subject to change without prior notice - Page 1/4 Ledil Oy Salorankatu SALO Finland ledil@ledil.com FAX:

2 PRODUCT DATASHEET series last update 14/6/2012 CA12011_LAURA-SS-PIN mm 13.1 mm Pin, tape 11 degrees 93 % CA11837_LAURA-M-PIN 21.6 mm 13.1 mm Pin, tape 28 degrees 92 % CA12012_LAURA-O-PIN mm 13.1 mm Pin, tape degrees 94 % CA12344_LAURA-W-PIN mm 13.1 mm Pin, tape 42 degrees 86 % May 8th :12 Copyright Ledil Oy - Subject to change without prior notice - Page 2/4 Ledil Oy Salorankatu SALO Finland ledil@ledil.com FAX:

3 PRODUCT DATASHEET series last update 14/6/2012 CA12325_LAURA-WW-PIN 21.6 mm 13.1 mm Pin, tape 48 degrees 86 % NOTE: The typical divergence will be changed by different color, chip size and chip position tolerance. The typical total divergence is the full angle measured where the luminous intensity is half of the peak value. May 8th :12 Copyright Ledil Oy - Subject to change without prior notice - Page 3/4 Ledil Oy Salorankatu SALO Finland ledil@ledil.com FAX:

4 PRODUCT DATASHEET series last update 14/6/2012 GENERAL INFORMATION - Product series especially designed & optimized for series of s. - Special care taken to make light distribution as uniform as possible. - Lens material optical grade with high UV and temperature resistance. Allows use of high current and temperature conditions. Please find more information about used material from below: Optic holder molded by high quality material (120 dergees of Celcius / 248 degrees of Fahrenheit). May 8th :12 Copyright Ledil Oy - Subject to change without prior notice - Page 4/4 Ledil Oy Salorankatu SALO Finland ledil@ledil.com FAX:

5 Relative intensity of -WW-Pin-XP-G 100% 75% 50% 25% % -70

6 D C B A 4 4 Isometric view Front view c/c Bottom view 2 1 Tolerances if not otherwise shown According to DIN ISO Linear measures: Up to 30mm class F, otherwise class M. According to DIN ISO Form and position: class K THIRD ANGLE PROJECTION: This drawing is the property of il Oy. It may not be reproduced, copied or communicated without a written agreement with il Oy." DRAWING TITLE SIZE A4 Ledil Oy Salorankatu 10 FIN SALO Finland PART NUMBER LAURA-WAS-PIN-TAPE - 1 SCALE 3:2 WEIGHT - SHEET 1/1 D A

7

8

9

10

11

12

13

14