User s Guide. L3D Series Thermal Dispensers. L3D-10 1 gallon L3D gallon L3D-20 2 gallon

Transcription

1 User s Guide L3D Series Thermal Dispensers L3D-10 1 gallon L3D gallon L3D-20 2 gallon 2009 Food Equipment Technologies Company FETCO, LUXUS, Driven To Pioneer Innovation, Freshness Time, and Volume Indicator are trademarks or trade names of Food Equipment Technologies Company. Part # P015 REV. 001 July 2011 for funnel revision April 2011

2 IMPORTANT SAFEGUARDS To prevent overflows, make sure the dispenser is completely empty before brewing. Always remove the funnel for manual filling of the dispenser. Do not use bleach or cleaners containing chlorides. Do not use solvent based cleaner or polish on this equipment. Use only non-metallic brushes and cleaning pads. Use only the handle to lift or carry the dispenser. Do not use the faucet guard to pull or lift the dispenser. Do not submerge the brew funnel. CLEANING AND MAINTENANCE Detailed instructions are available on our web site, Daily: Important Notice: To maintain proper operation of the funnel display, clean the funnel stem daily under running water with detergent and a sponge or towel. Do not submerge. Do not use abrasives of any kind Use any commercial beverage urn cleaner to clean the inside of the dispenser. Follow the cleaner manufacturer s instructions. Make sure to thoroughly rinse the dispenser after cleaning. Wash the drip tray and other plastic parts with dish detergent. Avoid abrasives. To sanitize the dispenser before filling, brew a batch of water only (no coffee) into the dispenser and allow it to rest for 10 minutes. Weekly, or as needed: Remove the faucet upper assembly and inspect the seat cup for wear. Clean or replace if necessary.

3 BREW FUNNEL DISPLAY = Each segment = 15 minutes. = 1 hour. = Maximum time has elapsed. (4 hrs.) Time is reset when dispenser is completely emptied, when funnel is removed, or when enough liquid is added to increase the volume by at least one level. NEW CONFIGURATION Each bar equals: 20% of the L3D dispenser - Vee section is the 1 st bar & does indicate 20% level. New display for all funnels is: L3D-10 Vee -plus- 4 bars. L3D-15 Vee -plus- 4 bars. L3D-20 Vee -plus- 4 bars. Example - for L3D-15: VEE counts as a level 1 hour, 45 minutes Half full ¾ gallon 3 hours, 30 minutes ¼ gallon Example - for L3D-10: 15 minutes Full 1 hour, 45 minutes Half full ½ gallon 3 hours, 30 minutes ¼ gallon

4 OPENING THE DISPENSER Squeeze tabs together and lift. OPENING AND CLOSING THE COVER PLUG Closed position for serving Open position for brewing REMOVING THE BREW FUNNEL Important Notice: To maintain proper operation of the funnel display, clean the funnel stem daily under running water with detergent and a sponge or towel. Do not use abrasives or submerge. Brew funnel must be removed for manual filling of dispenser. Removing the funnel resets timer. To extend battery life, remove the funnel when not in use. (Battery cannot be replaced.)

5 REMOVING THE DRIP TRAY latch release REMOVING THE FAUCET GUARD Press and hold down latch release while sliding drip tray out. Unscrew knob 4 turns and slide faucet guard out. REMOVING THE FAUCET knob Press faucet release latch up.

6 Rotate faucet 180 and pull it out. Replace gasket if removed Unscrew faucet upper assembly to clean or replace seat cup. Reverse procedure to re-install faucet. Press release latch down to lock faucet in place.

7 Replacement Parts

8 Dispenser Model Number ITEM Description L3D-10 & L3D-15 & L3D-20 & L3S-10 L3S-15 L3S-20 1a LOCK (inside cover) b PLUG ASSY COVER ASSY HANDLE ASSY FUNNEL GASKET FUNNEL ASSY TOP ASSY NECK GASKET FAUCET UPPER ASSY. (BLACK HANDLE) FAUCET HANDLE, BLACK FAUCET HANDLE, ORANGE FAUCET HANDLE,GREEN FAUCET HANDLE, RED Hot Water FAUCET SEAT CUP FAUCET BODY ASSY FAUCET ASSY.,COMPLETE FAUCET GUARD FAUCET GUARD KNOB & WASHER DRIP TRAY ASSY FAUCET LOCK INSERT, BOTTOM BOTTOM STAND ASSY Anti-slip Foot Rose Rd. Lake Zurich, IL USA Phone: (800) or (847) sales@fetco.com To order parts: Fax to Customer Service parts@fetco.com. Check prices at