Ebike Operating Instructions

Transcription

1 Ebike Operating Instructions This is an important instruction, please make sure you read this carefully before you try your first ride. If you are in doubt about any information inside this instruction,please contact us or your local distributor.

2 Meet your Ebike Saddle 18 2 Charging Port 17 3 Seatpost Battery 4 Seatpost Clamp 5 Rear Wheel Rear Disc Brake 7 Chain 8 Controller 9 Power Interface 10 Foldable Pedal 11 Frame 12 Front Wheel 13 Front Disc Brake 14 Motor 15 Front Fork 16 Foldable Head Stem 17 Handlebar 18 Brake Lever LCD Display

3 Parameters Product name: CITY Ebike Model name:vveb1-blk/whi Size: 1320*580*980mm Folded size: 710*360*630mm Wheel base: 930mm Net weight: 14kg Range: PAS>50KM Standard load: 100KG Top speed: <25KM/H Charge time: 3 Hrs Battery type: Lithium-ion Battery capacity: 36V 5.2Ah Noise : 62db(A) Motor : 250W brushless geared DC motor Rated output power: 250W Motor efficiency: 80% Rated RPM: 300 RPM Rated voltage: 36V Max torque: 40N.m Overcurrent protection: 12±1A Low-voltage protection 30±1V Kwh 1.2Kw.h Ride system: 5 classes PAS+cruise Tyre Diameter: 16 inch Frame: 16 inch 6061 Al-Alloy foldable Front fork: 16 inch inch 6061 Al-Alloy Brake: 160mm disc brake Rim: 16 inch Al-Alloy 13G36H Tire: Kenda 16*2.125 Chain wheel: Prowheel 52T Fly wheel: 14T Rear hub: Sigma Al-Alloy Chain: KMC Handle bar:eva Display: Kunteng LCD Controller: Kunteng sine wave FOC Brake lever: Al-Alloy ebike lever Saddle: KNUS Pedal: foldable pedal

4 Folding your Ebike Hold the seat post(impor tant). loosen the clamp. 2. Push the seatpost to the ground slowly,tighten the seatpost clamp Loosen the handle bar clamp 4. Turn the handlebar clockwise until vertical,tighten the clamp Release the lock clamp, fold the head tube. 6. Fold the pedal by pushing it level Release the safety cap. 8. Pull the lock bar,fold the main tube.

5 Operating your Ebike Ⅰ Press & hold power button for 3 sec,lcd shows screen A,data shows as :single riding time- PAS class-speed-single range; Ⅱ Press power button,lcd Shows sceen B,data shows as: total riding time - PAS class Average speed - total range; Ⅲ Press power button twice,lcd shows sceen C,data shows as: total riding time - max speed - voltage Press & hold power button to turn off Up Power Down LCD backlight Pedestrian/ Walk Mode 00: DST TTM KM / H KM ODO 00: TTM AVS KM / H KM VOL 00: TTM MAX KM / H Ⅰ Ⅱ Ⅲ 1.Walk mode:press&hold DOWN button till flicker,your Ebike will slide at a fixed speed of 6KM/H,release to quit. 2.Cruise mode: Pedal your Ebike to your wanted speed (must be over 7KM/H),then press & hold DOWN button for 3 sec to enter cruise mode, take a break or press any button to quit. 3.LCD backlight: press & hold UP button to turn on backlight,press & hold UP button again to turn off. 4.PAS mode: press UP or DOWN button to choose PAS classes from 0~5.

6 Charging your Ebike Accessory list 1 Front mud guard 2 Rear mud guard 3 Reflectors Charging port is located beneath the saddle, covered by a rubber dust-free cover, uncover it, plug the charger into the port. Cover the port again when charged. 4 Bell Please mount accessories according to your needs. If you want to charge your battery separately, unscrew the power port,release the seatpost clamp,pull out the seatpost battery, then repeat the steps above.

7 Attention Battery & Charge 1.Red indicator on the charger means charging.when it turns green,please stop charging your battery; 2 Do not expose to temperature -20 or 35 Fully charge the battery and store separately if not used for over 30 days. Fully charge it every 90days, or the battery may self-discharge and be damaged. This damage is not covered by the Limited Warranty; 3.Never expose your battery to damp environment or soak into water,never short circuit the battery terminals, This damage is not covered by the Limited Warranty; 4.Charge with the original charger only; 5.Do not disassemble/punch battery pack.do not place it in fire or drop from height,avoid contact with electrical contacts; 6.Turn off Ebikes power before charging. Plug the charger port in first then the AC plug; 7.Do not cover any items on the charger during charging; 8.Pull out charger port before the AC plug; 9.Please keep battery out of reach of children. 10.The capacity of Li-battery will decrease when < Recycle or dispose of in accordance with local regulations. Ride & Maintenance r r 1.Always wear your helmet when riding and follow the local laws and regulations. 2.Read this instruction manual carefully before riding your Ebike. 3.Start your ride with the 3rd PAS class. 4.Keep the lamp on at night. 5.Fully check brake system,tyre pressure,and remaining battery charge before riding. 6.PLEASE do use front brake FIRST. 7.Do not ride aggressively. 8.Do not ride into water over 15cm deep! 9.Replace the quick-wear parts (like brake pads) in time. 10.Children, Pregnant Women, Intoxicated are not allowed to ride Ebike ; 11.Keep your Ebike away from damp, high temperature or corrosive environment; 12.Do not leave in direct sunlight or rain. 13.Check screws,chain and other parts regularly.

8 Standards and Conformity Velovolt City is an electric power assisted cycle developed in accordance with: 2006/42/EC 2004/108/EC The Machinery Directive The Electromagnetic Compatibility Directive and is in conformity with the applicable requirements of the following documents: EN 15194: A1 EN 14764:2005 Cycles - Electrically power assisted cycles - EPAC bicycles City and Trekking bicycles - Safety requirements and test methods Original Instructions, Translations and Updates Original instructions are produced in English language. Translations of the original instructions to other languages may take place, however Velovolt LLP accepts no responsibility for any errors or misinterpretation of information as a result of such translation. Disclaimer The specifications, information and performance of the Velovolt City and other products manufactured by or sold under license granted by Velovolt LLP and featured in this document may change without notice. The use of this information or products and the conditions under which the products are used are the sole responsibility of the buyer and/or the rider. It is the buyer s and/or rider s responsibility to determine the correct and safe selection of settings and conditions of use of the products and to periodically check the products for secure and proper operation. To the extent that the law permits, any liability which may be incurred as a result of the use of a product manufactured by or sold under license granted by Velovolt LLP is limited to the cost of repairing or replacing the failed product or component at the discretion of Velovolt LLP, either within or outside of warranty periods, and does not extend to any loss or damage which may be caused as a consequence of misuse or failure of the products. Damages to the product, other property or any persons are the responsibility of the buyer and/or rider. By using this product manufactured by or sold under license granted by Velovolt LLP, you are stating that you have read this disclaimer and agree to hold Velovolt LLP, its owner/s and any of its employees or directors free from all liabilities, that you agree you are using and operating the product at your own risk, and that no warranties or guarantees are made by Velovolt LLP, expressed or implied, on performance or operation.

9 Intended Use The Velovolt City is an electric bicycle developed and designed for commuting usage and/or simple riding in fair weather and at speeds relevant to safe and appropriate travel in an urban or suburban environment. Where applicable, the product meets the minimum requirements outlined in EN 14764:2005 and EN Abusive riding styles or inappropriate use will invalidate any warranty protection offered in this agreement. WARNING! Understand your Velovolt City and its intended use. Using your Velovolt City in the wrong manner or for the wrong purpose can be dangerous and may impact the service life of the product. The Velovolt City is a power-assisted bicycle intended for sensible use by physically competent riders. If you have any concerns or doubts about your use or enjoyment of such a product due to a medical condition, an illness or if you are recovering from treatment for a condition or illness, you should consult your doctor regarding the suitability of the product for you. If you are the user of an implanted medical device such as a pacemaker or defibrillator, you agree to seek appropriate advice from the manufacturer of such device prior to the usage of Velovolt LLP products. Copyright Notice Copyright Velovolt LLP. All rights reserved. This material provided by Velovolt LLP is the property of Velovolt LLP and is protected by copyright, trademark and other intellectual property laws. You may view this material and print this material only for personal use, provided that you maintain all copyright, trademark and other proprietary rights or notices. You may not otherwise use, reproduce, store, post, broadcast, transmit, modify, sell or make available to others or the public, content from this material without the prior written approval of Velovolt LLP.