USER MANUAL EN 1~7 中 8~14 com

Transcription

1 USER MANUAL EN ~7 中 8~4 www. sz-freewing. com

2 Catalog Introduction Basic Product Information Package List PNP Install Insturctions Install Main Wing Install Vertical Stabilizer Install Antenna Pushrod instructions Battery Size Center of Gravity Control Direction Test Dual Rates and Flight Attention Accessories Description Motor Specifications Motor Overview Accessories Introduction Servos Introductions Install nose landing gear lnstall rear landing gear

3 Product Overview 495mm(9.5") Standard version Wing Loading: 50g/dm Wing Area 8 dm Motor: KV Brushless Outrunner Motor Ducted fan: 4mm 5-Blade Fan ESC: 0A Brushless Servo: 9g Plastic Servo(pcs) Top Speed : 0KPH/00MPH Empty Weight:0g (without battery) Bench Tested Thrust: 750g Landing gear: fixed landing gear (Optional spare part, need to purchase separately.) 750mm(9.5"), The package don t include the landing gear, if you need,please contact your local dealer. Package List No. Name PNP ARF Plus Airframe No. Name 5 Antenna Carbon tube 7 Glue 4 8 User Manual Item No.: FJ0 PNP ARF Plus Airframe

4 PNP lnstallation Instructions Install Main Wing As shown in this photo:.insert the carbon tube into the fuselage and keep it in the center..as the right photo show, use glue to install the main wing on the fuselage. Carbon tube (Ø4x0mmmm) Step Fuselage Main wing Step Install Vertical Stabilizer.Use glue to attach the vertical stabilizer on the fuselage as the below photo shown. Vertical stabilizer Install Antenna Antenna Pushrod Instructions Aileron pushrod size Aileron pushrod mounting hole 7.8mm (-/") Pushrod diameter Ø.mm

5 PNP lnstallation Instructions Battery Size Cockpit Battery Pull the latch back and open the cockpit. Use rubberized non-slip tape or hook-and-loop tape Battery tray Velcro Battery cabin size: L=0 W=4 H=4(mm) Before connecting the battery and receiver, please switch on the transmitter power and make sure the throttle stick is in the lowest position. Bind your receiver to your transmitter according to your transmitter s instruction manual. We recommend the following LiPo battery: S.V 000mAh ~ S.V 00mAh Discharge rate of C > 0C Center of Gravity Correct Center of Gravity ( CG ) is critical for the aircraft to fly safely and in control. Please refer to the following CG diagram to adjust your plane s Center of Gravity. - You can move the battery forward or backward to adjust the Center of Gravity. - If you cannot obtain the recommended CG by moving the battery to a suitable location, you can also install a counterweight to achieve correct CG. However, with the recommended battery size,no counterweight is required. We recommend not flying with a battery size that requires a counterweight. 58mm (-5/") 4

6 PNP lnstallation Instructions Control Direction Test 升降舵 Stick Down Stick Up Dual Rates According to our testing experience, use the following parameters to set Aileron/Elevator Rate. Program your preferred Exponential % in your radio transmitter. We recommend using High Rate for the first flight, and switching to Low Rate if you desire a lower sensitivity. On successive flights, adjust the Rates and Expo to suit your preference. Aileron Elevator H H H H Low Rate High Rate Aileron(measured closest to the fuselage) H/H mm/mm D/R Rate:0% H/H 5mm/5mm D/R Rate:80% Elevator(measured closest to the fuselage) H/H 5mm/5mm D/R Rate:80% H/H 0mm/0mm D/R Rate:00% Flight attention: When full throttl to fly, the nose will be down. please set up.5mm elevator up to avoid the nose down phenomenon and maintian its in the same level. 5

7 Accessories Description Motor Specifications Item No.:MO kv Power system No. EDF Fans Use voltage (V) Current(A) Max power (W) Thrust(g) Efficiency (g/w) Motor Specifications (KV) Uni:mm Rotating speed (rpm) 4mm E blade EDF Motor 平尾组 Overview 装 Standard version A- Motor KV B- 4mm Outrunner ducted frame C- Screw (PM.5x pcs) D- Motor collet E- Motor collet backplate F- 4mm 5-blade ducted fan G- Nut G F E D C B A Weight (g) Refer to the following photo to install ESC and power system A- ESC B- 4mm EDF power system C- EDF cover D- Screw (PA.x pcs) Note: When the ESC and battery are connected, avoid touching the ESC by hand to avoid accidental injury due to heat When testing the EDF, please use safety test stand for testing.never hold an EDF unit in your hand while it is powered on. A B D C Accessories Introduction Servos Introductions Step Step Step If you need to purchase another brand s servo, please refer to the following list to choose a suitable servo. Position Main wing(l) Main wing(r) Servo regulation No. Pos./Rev. Cable length 9g plastic servo 9g plastic servo Positive Positive 00mm 00mm

8 Landing Gear Assemble Landing gear is the optional part, please consult with the local distributor to purchase, and refer to the following instructions to install. Install nose landing gear Please refer to the following photo for assembly and installation of the landing gear. Spare part name and parameters A -Servo fixed mount B -9g Servo C- Screw (PWA.x8 pcs) D- Set screw (Mx 4pcs) F E -Nose wheel strut fixed piece C F -Nose wheel strut (top) E G-Wheel connecting part D H-Nose wheel strut (bottom) G D I -Nose wheel (Ø5x0mm) B H J -Wheel chock I K -Nose landing gear D A J K Step D Step Step Install rear landing gear Please refer to the following photo for assembly and installation of the landing gear. Spare part name and parameters A-Main landing gear fixed mount B-Rear gear main strut C-Nose wheel (Ø50x5mm) A D-Wheel chock B C E-Set screw (Mx) D F -Main landing gear door F Step Attention: install the wheel on E the direction of nose fuselage. Step 7

9 R Dongguan Freewing Electronic Technology Ltd HK Freewing Model International Limited Add.:FeiYi Building,face to Labor Bureau, Fumin Middle Road, Dalang Town, Dongguan City,Guangdong Province, China Web: Tel: Fax: 东莞市飞翼电子科技有限公司香港飞翼模型国际有限公司 地址 : 广东省东莞市大朗镇富民中路 号飞翼楼四楼 Web: freewing@sz-freewing.com Tel: Fax: