SMALL BLOCK CHEVY COMPRESSOR BRACKET L/P PASSENGER SIDE VCB. Bracket Systems

Transcription

1 SMALL BLOCK CHEVY COMPRESSOR BRACKET L/P PASSENGER SIDE 53-VCB 8865 GOLL ST. - SAN ANTONIO, TX ph fax SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCITONS PG OF 7

2 Table of Contents PAGES COVER TABLE OF CONTENTS PACKING LIST/PARTS DISCLAIMER COMPRESSOR MOUNTING BRACKET INSTALLATION INSTALLATION DIAGRAM BELT ROUTING, COMPRESSOR WARNING PACKING LIST SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCTIONS PG 2 OF 7

3 SMALL BLOCK CHEVY L/P PASSENGER SIDE COMPRESSOR BRACKET No. QTY. PART No. DESCRIPTION SCR SCA SCR 93-HCA FRONT MOUNTING BRKT REAR MOUNTING BRKT ASM COMPRESSOR MOUNTING BRKT HARDWARE KIT COMPRESSOR BRKT 53-VCB ** BEFORE BEGINNING INSTALLATION, OPEN ALL PACKAGES AND CHECK CONTENTS OF SHIPMENT. PLEASE REPORT ANY SHORTAGES DIRECTLY TO VINTAGE AIR WITHIN 5 DAYS. AFTER 5 DAYS, VINTAGE AIR WILL NOT BE RESPONSIBLE FOR MISSING OR DAMAGED ITEMS SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCTIONS PG 3 OF 7 3

4 - INSTALLATION INSTRUCTIONS COMPRESSOR MOUNTING BRACKET INSTALLATION. REMOVE THE TOP WATER PUMP MOUNTING BOLT PASSENGER SIDE. (DISCARD) SEE FIGURE, BELOW. 2. REMOVE ST AND 3RD MANIFOLD BOLTS PASSENGER SIDE. (DISCARD) SEE FIGURE, BELOW. NOTE: ASSEMBLE ALL BRACKETS LOOSELY TO ENGINE, BEFORE TIGHTENING BOLTS, THIS WILL INSURE PROPER ALIGNMENT OF ALL BRACKETS. 3. ATTACH COMPRESSOR FRONT MOUNTING BRACKET TO WATER PUMP USING A 3/8-6 x 3 ¾ BOLT AND ¼ SPACER (SEE FIGURE 2, PAGE 5). 4. ATTACH COMPRESSOR REAR MOUNTING BRACKET TO MANIFOLD USING (2) 3/8 X 3 ¼ BOLTS AND (2) SPACERS (SEE FIGURE 2, PAGE 5). NOTE: EXHAUST SPACERS RAM HORN MANIFOLDS USE: /4 SPACER AT THE REAR OF BRACKET /6 SPACER AT THE FRONT OF BRACKET DROP-TYPE MANIFOLD USE: (2) /6 SPACERS HEADERS USE: (2) 2 ¼ SPACERS REMOVE BOLTS FIGURE SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCTIONS PG 4 OF 7

5 FIGURE 2 - NOTE: ASSEMBLE ALL BRACKETS LOOSELY TO ENGINE BEFORE TIGHTENING BOLTS. THIS WILL ENSURE PROPER ALIGNMENT OF ALL BRACKETS. NOTE: EXHAUST SPACERS RAM HORN MANIFOLDS USE: /4 SPACER AT THE REAR OF BRACKET (SHOWN BELOW) /6 SPACER AT THE FRONT OF BRACKET DROP-TYPE MANIFOLD USE: (2) /6 SPACERS HEADERS USE: (2) 2 ¼ SPACERS 3/8 LOCKNUT RAM HORN MANIFOLDS /4 SPACER ¼ SPACER 3/8 LOCKNUT 3/8 x ¼ BOLT 3/8 x 3 ¾ BOLT FRONT MOUNTING BRACKET SCR 3/8 x 3 ¼ BOLTS REAR MOUNTING BRACKET SCA /6 SPACER 3/8 LOCKNUT NOTE: THESE SYMBOLS REPRESENT THE MOUNTING EARS ON THE COMPRESSOR. 3/8 x ¼ BOLT 3/8 x 5 BOLT COMPRESSOR MOUNTING BRACKET SCR 3/8 x BOLT w/ FLAT WASHER 9053-SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCTIONS PG 5 OF 7 5

6 BELT ROUTING. ROUTE BELTS AS SHOWN BELOW. VINTAGE AIR RECOMMENDS USING ONLY DAYCO, GATES OR GOODYEAR BRAND REINFORCED V-BELTS WITH THIS COMPRESSOR BRACKET KIT. COMPRESSOR BELT LENGTH OF 60 TO 6 INCHES IS RECOMMENDED. NOTE: THIS CAN VARY WITH DIAMETER OF YOUR WATER PUMP AND CRANKSHAFT PULLEYS. COMPRESSOR FRONT WATER PUMP PULLEY ALTERNATOR PULLEY 2 FRONT CRANKSHAFT PULLEY CRANKSHAFT PULLEY GROOVES:. CRANKSHAFT, WATER PUMP & ALTERNATOR 2. CRANKSHAFT, WATER PUMP & COMPRESSOR (FRONT GROOVE) COMPRESSOR WARNINGS NOTE: FAILURE TO FOLLOW THESE PROCEDURES WILL VOID ALL WARRANTIES.. WITH COMPRESSOR KIT INSTALLED, AND BELT TIGHTENED, CHECK ANGLE OF OIL PLUG ON COMPRESSOR. AS SHOWN BELOW, OIL PLUG MUST NOT EXCEED 90 BEYOND VERTICAL CENTERLINE. 2. DO NOT CONNECT COMPRESSOR CLUTCH WIRE UNTIL SYSTEM IS BEING CHARGED WITH REFRIGERANT. RUNNING COMPRESSOR WITHOUT REFRIGERANT CHARGE MAY RESULT IN COMPRESSOR FAILURE. IMPORTANT NOTICE: DO NOT CONNECT COMPRESSOR CLUTCH WIRE UNTIL SYSTEM IS BEING CHARGED WITH REFRIGERANT. SINCE AN A/C SYSTEM RELIES ON REFRIGERANT TO CIRCULATE LUBRICANT, RUNNING THE COMPRESSOR WITHOUT REFRIGERANT MAY DESTROY THE COMPRESSOR AND VOID THE WARRANTY. PROPER COMPRESSOR ORIENTATION IS IMPORTANT. SANDEN COMPRESSORS MAY BE ROTATED FROM VERTICAL (OIL FILL PLUG AT TOP) UP TO 90 IN EITHER DIRECTION (SEE ILLUSTRATION). Oil Plug SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCTIONS PG 6 OF 7

7

8 SMALL BLOCK CHEVY L/P PASSENGER SIDE COMPRESSOR BRACKET No. QTY. PART No. DESCRIPTION CHECK LIST SCR SCA SCR 93-HCA FRONT MOUNTING BRKT REAR MOUNTING BRKT ASM COMPRESSOR MOUNTING BRKT HARDWARE KIT CHECKED BY: PACKED BY: DATE: COMPRESSOR BRKT 53-VCB SCA REV D 08/30/6 SBC L/P COMP BRKT INSTRUCTIONS PG 7 OF 7