FRONT MOUNT DE-THATCHER MANUAL LIFT. Operating and Assembly Manual Palmor Products Inc Serum Plant Road Thorntown, IN

Transcription

1 FRONT MOUNT DE-THATCHER MANUAL LIFT Operating and Assembly Manual Palmor Products Inc Serum Plant Road Thorntown, IN 46071

2 FM 330, 335 PARTS BREAKDOWN (Manual Lift) KEY PART NO DESCRIPTION A Frame, Frame, 56 B Pivot Frame Mount C Caster Bracket D 45060A Caster Yoke Assembly E Pneumatic Wheel F Cylinder Mount G Tine, Thatcher H Top Half Bracket I Half Channel J Kick Tube K Push Tube Bracket L Push Tube Extension M Clevis Pin N Bearing, 1 Nylon O Transport Bracket P 359*** Hitch Kit (Tractor Specific)

3 J K F M L O N B H I A C P E D G

4 FIG. 1 FIG. 2 equidistant equidistant FIG. 3 FIG. 4 FIG. 5 FIG. 6

5 FIG. 7 FIG.8 FIG. 9 FIG.10

6 FM DE-THATCHER INSTALLATION INSTRUCTIONS 1. Install tractor specific mountings according to instructions provided with kit. Do not tighten hardware for mounts, leave them loose. 2. Slip each crosstube into caster arm mounts and pin in place with ¾ pin and hairclip provided. FIG Orient half brackets around crosstubes as illustrated and bolt together two halves using eight 5/16 x 1 bolts and whizlock nuts. Once again, do not tighten. Only snug bolts at this time. FIG Square up the thatcher to the first crossmember of the footpan on tractor. Do not try and use the casters to square as most of the commercial midmount mowers have two different length caster arms. Once assembly is squared, tighten hardware to the crosstube mounts, but leave the bolts in the clamp halves loose. FIG Remove thatcher from its box and attach main pivot frame to it using four 3/8 x 3/4 HHC, flat washers and whizlock nuts provided. FIG Assemble front caster bracket. Attach caster bracket to pivot frame. FIG Attach thatcher to tractor mount by slipping arms of main pivot frame around the receiver tubes on half bracket and secure with 1 x 4 clevis pins and #5 hairpin cotter. FIG. 6 & 7. Slip lower cylinder mount over main pivot frame that is bolted to the thatcher frame. Align holes in arms of main pivot with holes in arms of lower cylinder mount and secure with 3/8 x 1 bolts and whizlock nuts. Tighten these bolts also. FIG Center thatcher frame on drive-tires of mower. The entire assembly should still be able to slip on the crosstubes because clamp halves are not tightened yet. 9. Attach transport bracket (O) to tab on top half bracket with ½ x 1 HHC and lock nut provided. Pin the receiver tube bracket and extension bracket to the cylinder mount and top half bracket as illustrated FIG Slide the Kick Tube (J) into the receiver on receiver tube bracket (K). Adjust Kick Tube (J) to the most comfortable operating position and secure with 5/16 x ¾ square head set screw provided. 11. Test operation of unit. OPERATION OF FM DE-THATCHER. Ground speed of 2-3 MPH recommended. Flip thatcher into transport position to trailer. To flip thatcher into transport position, remove the cylinder mount on the thatcher side. Rotate thatcher over and pin into transport position with the ½ x 2 clevis pin just removed from cylinder mount through the transport bracket. To bring back to operating position, remove the ½ x 2 clevis pin securing the thatcher in the transport position and rotate the unit back around to the operating position. Pin through the cylinder mount and extension bracket.

7 TRAC VAC WARRANTY POLICY Palmor Products, Inc. will repair or replace, free of charge, any part, or parts that are defective in material or workmanship or both for a period of one year residential use, and 90 day s for commercial and rental use. The purchaser will pay transportation charges on parts submitted for replacement under warranty. For warranty service, contact your local dealer from whom the unit was purchased. There are no other express or implied warranties. Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state. PALMOR PRODUCTS, INC Serum Plant Rd. Thorntown, IN Phone: Trac-Vac Web Page: palmor@trac-vac.com