B Trailer. Axles. Comments: Suspension Comments: King pin. Comments: Ring Feeder. Comments:

Transcription

1 Your perfect TrailerHILLCREST Stockcrates and Equipment Lot 22 Napier Street Phone (07) Fax (07) PO Box 872 Dalby QLD 4405 ABN Noel ( ) Marty ( ) B Trailer. Axles. o BPW Spider hubs(standard) o BPW 10 studs o K-Hitch spider hubs o K-Hitch 10 studs Suspension o ETE (Standard) o K-Hitch (Not Recommended) o BPW air bag suspension o Hendrickson airbag suspension King pin. o 2 Jost (Standard) o 2 Holland (Standard) o 3 Jost Ring Feeder. o Ringfeder (Standard) o Jost Rockinger o V-Olandee

2 Landing legs. o Jost. (standard) o Holland. o K-hitch. Skid plate Nylon wear pad. o Nylon Wear plate o 3mm lyten plate NOTE: With wear pad you will require a 16mm King Pin. Under trailer. o 1x tool box o 2x tool box o Belly tank o Water tank o 1x Tyre carrier o 2x Tyre carriers (having two tyre carriers eliminates belly tank and can only have 1 tool box. Waste tanks. o Waste tanks on driver and passenger behind tri. o Waste tanks in center behind tri (this option eliminates ring feeder). Troughs. o 2x troughs in bottom deck/ 2x troughs in top deck (standard) o 3x trough in bottom deck/ 3x troughs in top deck (extra trough mount towards front of trailer) o Flat floor shoots are positioned in same area. Shoots.

3 o 8 shoots with welded grids. o 8 shoots with pull out grids. (Standard) o 8 full stainless shoots with pull out grids with air operated shut off. o 8 full stainless chutes with pull out grids with manual shut off lever. Decks. o Crimped 3mm lyten decks top and bottom. (standard) o Crimped 3mm Stainless decks top and bottom. o 6mm mild steel deck in bottom and side shedding 3mm lyten decks up top (east, west) o 6mm mild steel deck in bottom and crimped 3mm lyten decks up top (north, south). Skid plate. o Open skid plate with 16mm mesh. o Covered skid plate with 3mm lyten. o Stainless crimped deck. o Covered skid plate with 6mm plate. Mesh. o 12mm round bar (on crimped deck) (standard) o 16mm round bar (on crimped deck) o 16mm rio bar (on crimped deck) o 18mm round bar (on crimped deck) o 16mm round bar fold up mesh. (on flat 6mm floor) Deck beams. o RHS support underneath top deck. (Making it easy to wash out) o Deck rails between decks. (To have a maximum bottom walk through height of 5 8 ) Ramp.

4 o Rear 12ft full width ramp. (Standard) o Rear 13ft full width ramp. o Rear 14ft full width ramp. o Front 12ft full with ramp. (standard) o Front 13ft full with ramp. o Front 14ft full width ramp. o Front and rear 12ft full width ramp. o Front and rear 13ft full width ramp. o Front and rear 14ft full width ramp. Rear doors. o Sliding through load doors with 4ft-5ft opening. o Sliding doors with 4ft-5ft opening. o Road train full width through load doors with safety door. o Road train full width through load doors without safety door. Front doors. o Driver side through load doors with 4ft opening with overlapping doors. o Driver side through load doors with 4ft opening with half doors. o Middle through load doors with 4ft opening with over lapping doors. o Middle through load doors with 4ft opening with half doors. o Road train Full width through load doors with safety doors. o Road train Full width through load doors without safety doors. o No doors. Fully closed Bottom Middle gates. o ¾ gate with panel, hinging on passenger side. (Standard) o ¾ gate with panel, hinging on driver side. o Half doors slam shut forward, middle and backward. Top Middle gates. o Half doors slam shut forward, middle and backward. (Standard) o Concertina doors sliding open to passenger side.

5 o Concertina doors sliding open to driver side. Comments. Rear driver side, Side load doors. o 3ft-5ft combination side load doors top and bottom. o 3ft side load doors top and bottom. Front driver side, Side load doors. o 3ft-5ft combination side load doors top and bottom. o 3ft-5ft combination side load door bottom only. o 3ft side load door top and bottom. o 3ft side load door bottom only. Front passenger side, Side load doors. o 3ft side load doors top and bottom. o 3ft side load doors bottom only. Comment: Grab rails. o 16mm round bar (standard) o 20x10mm Flat bar. o 16mm Rio bar. Grab Rail position. o 4 grab rails up both sides evenly in side sheet area. (Standard) o 5 grab rails up both sides evenly in side sheet area with one in top kick panel area. Catwalk. o 3x 8 boards with necessary boards off to sides. (24 wide) (Standard) o 2x 8 boards with necessary boards off to sides. (16 wide)

6 LED Lights/Electrical/Brakes. (Optional Extras) o Led light on front for through loading. o Trickle feed (front to toolbox). o Trickle feed (front to toolbox to rear hookup). o Glad hands couplings. o Suzi coils before landing legs. o Belly tank Hose (3/4) to front only. o Belly tank Hose (3/4) to front and to back. o Electrical and air hookup on Passenger. o Electrical and air hookup on driver. o Electrical and air hookup in middle. o Electrical and air Hookup at front only. o Electrical and air Hookup underneath only. o Electrical and air Hookup underneath and front. Lights and electrical that are standard on Hillcrest B trailer. o Interior lights top and bottom. o Front top lights x4 o Rear top lights x2 o Side lights, driver and passenger x6 each side o Side indicators, driver and passenger x1 each side o Rear jumbo lights. (stop, clearance and indicator) o Big 5 core road train wire. o X5 Ramp switches x2 beside side load openings. -x1 in bottom side load opening top corner. -x1 beside solar panel. -x1 on passenger side beside ramp lever. Extras. o (Passenger) Bottom fold down side walk. o (driver) Bottom fold down side walk. o Ramp latch handle to catwalk. o Ramp latch handle to catwalk and bottom. o Push-Pull Bar. o 8 shoot plugs.

7 o Extra Gaps on side sheets and extra noggins. Please Send back Photos or Right in comments. o Spray suppression above tyres (fur). o Raise & lower Valve (Air bag Suspenion only). PLEASE CONTACT NOEL OR MARTY FOR ANY QUESTIONS.