APPLICATION FOR APPROVAL OF A TYPE OF PNEUMATIC TYRE ACCORDING TO ECE REGULATION No. 54, 00 SERIES OF AMENDMENTS

Transcription

1 APPLICATION FOR APPROVAL OF A TYPE OF PNEUMATIC TYRE ACCORDING TO ECE REGULATION No. 54, 00 SERIES OF AMENDMENTS 1. 's name or trade mark (2) 2. Tyre type designation by the manufacturer (2) 3. 's name and address 4. If applicable, name and address of manufacturer s representative HUASHENG;JINXIN;TAITONG;HONGTU;KAPSEN; PARAGON;PASSION;BLACKSTONE;ROADSONIC; MACROSUN;TUDOR;HUMSUNG;TERRAKING;BAOLITE; JINJI;DOUBLEROAD;MESHILINE;TRUCKPRO;AENEAS; TOURTRACK;NAMA;DONLLUP;GIACCI;FULUTONG; FURUITONG;HABILEAD;ROADBOSS;TYSONKING; ZEETEX;TOLEDO;ALTAIRE;CARGOFORCE HS205;DR818;MH3000;TP245;PILOTRS2;NF19;GA205; H5100;ZSH10 vfm;dr109;ap202;csl612;hs268 Qingdao Kebek Tire Co.,Limited Daozhuang Industry Zone, Guangrao County,Dongying City, Shandong Province , not applicable 5. Summarised description, 5.1. Tyre size designation 5.2. Category of use 5.3. Structure 215/75R17.5 normal/special/snow diagonal (bias-ply)/ radial 5.4. Speed category symbol Nominal M Additional (if applicable) not applicable 5.5. Load capacity indices corresponding to nominal speed single 126, twinned (dual) corresponding to additional speed single ---, twinned (dual) Overall dimensions(design) calculated/annex 5 overall section width 210 outer diameter Factor 'x' Ply-rating number for diagonal (bias ply) tyres Rims on which the tyre can be mounted Measuring rim and test rim see attached test report 11. Tyre class C2 / C3 12. State whether the tyre is tube less / tube type 13. Traction tyre Yes / no( see the tread pattern detail in drawing) 14. State if special use tyre n.a. Professional Off-Road Yes / no Tread depth n.a. Void to fill ratio n.a. 15. Inflation pressure and index for measuring and testing see attached test report 16. Submitted for approval on (date) October 06,2017 (1) Strike out what does not apply. (2) Modified points are underlined for extension.

2 We herewith declare that we have not applied and will not apply for approval with another Contracting Party of the ECE for the same type of product. MANUFACTURER'S STAMP Signature. Name LIUJIANQUN THIS APPLICATION IS ACCOMPANIED BY A drawing of the tyre's side wall, tread and dimensioned cross section. The test report. (1) Strike out what does not apply. (2) Modified points are underlined for extension.

3 Vehicle Technology Division THE NETHERLANDS (N E D E R L A N D) COMMUNICATION Concerning (1) - approval granted - approval extended - approval refused - approval withdrawn - production definitely discontinued of a type of pneumatic tyre for motor vehicles pursuant to Regulation number 54. Approval number E4-54R Extension number s name and address Qingdao Kebek Tire Co.,Limited Daozhuang Industry Zone, Guangrao County,Dongying City, Shandong Province , 2. Tyre type designation (2) 2.1. Brand-name(s) or trade mark(s) HUASHENG; JINXIN; TAITONG; HONGTU; KAPSEN; PARAGON; PASSION; BLACKSTONE; ROADSONIC; MACROSUN; TUDOR; HUMSUNG; TERRAKING; BAOLITE; JINJI; DOUBLEROAD; MESHILINE; TRUCKPRO; AENEAS; TOURTRACK; NAMA; DONLLUP; GIACCI FULUTONG; FURUITONG; HABILEAD; ROADBOSS; TYSONKING; ZEETEX; TOLEDO; ALTAIRE; CARGOFORCE 2.2. Trade description(s)/ Commercial name(s) 3. If applicable, name and address of the manufacturer s representative HS205; DR818; MH3000; TP245; PILOTRS2; NF19; GA205; H5100 ZSH10 vfm; DR109; AP202; CSL612; HS268 not applicable 4. Summarized description P.O. Box 777 Tel (0) Vehicle Admission & Surveillance 2700 AT Zoetermeer ttv@rdw.nl The Netherlands Tyres-commercial-vehicle R54-00 v4.00 Page 1 of 2

4 Approval number E4-54R Extension number Size of tyre 215/75R Category of use normal/snow/special (1) 4.3. Structure diagonal(bias-ply)/radial (1) 4.4. Tyre class C2/C3 (1) 4.5. Speed category symbol Nominal M additional (if applicable) Load-capacity indices Corresponding to nominal speed - single twinned (dual) Corresponding to additional speed - single twinned (dual) Technical service and, where applicable, test laboratory approved for purposes of approval or of verification of conformity 6. Date of report issued by that service October 26, 2017 Technologiezentrum Verkehrssicherheit Am Grauen Stein D Köln (Poll) 7. Number of report issued by that 86-R /17-00 service 8. Reason(s) of extension (if applicable) Addition of trade marks and tread patterns 9. Any remarks Place Zoetermeer 11. Date 12. Signature 13. Annexed to this communication is a list of documents in the approval file deposited at the administrative service having delivered the approval and which can be obtained upon request. - Application form relating to ECE approval for a pneumatic tyre pursuant to Regulation number The drawing of the tyre's sidewalls, tread and dimensioned cross-section. - The test report as mentioned in item 7. (1) Strike out what does not apply. (2) A list of Brand name(s)/trademark(s) or Trade description(s)/ Commercial name(s) may be annexed to this communication Tyres-commercial-vehicle R54-00 v4.00 Page 2 of 2

5 11 D入lo-9TREAD PATTERN 昙lREFER TO ATTACHMENT No. 1 11AI LOAD SINCLB 3750 LBs ( 1700 [G) DUAL mo LBS (1600 C) AT 105 PSI (7001Pa) COLD LOAD IANGB 126/124 II 16Pl SAPBTYIAINING TRBAD PATTRRN lbpbl TO ATTACH 讥 NT No.1 CCC TIBAD 4 STBBL PLIBS SIDBfALL I STBBL PLY 4 I TOBBLBSS UDIAL ALL STBBL 2 MADB IN CHINA I TUDBMAU RBFBl TO ATTACHllBNT No /75Rl 7. 5 TIRE SIZE 126/124 M LOAD INDBX TUBELESS -- 一 一 TYPE 767 D(u) 212 S (111) 152. S A (111) SIID DEPTH (am) DRAIN BY Zhang Yueguang CHBC BD BY Wang Haizben APPROVED BY Liu Zhiplng QINGDAO KEBEK TIRE CO., LIMITED

6 TREAD PATTERN ATTACHMENT NO.1 TYRE SIZE215/75R /124M TRADE MARK APPROVAL NO.E4-54R TREAD PATTERN NAME HUASHENG;JINXIN;TAITONG;HONGTU;KAPSEN; PARAGON;PASSION;BLACKSTONE;ROADSONIC; MACROSUN;TUDOR;HUMSUNG;TERRAKING;BAOLITE; JINJI;DOUBLE ROAD;MESHILINE;TRUCKPRO;AENEAS; TOURTRACK;NAMA;DONLLUP;GIACCI;FULUTONG; FURUITONG;HABILEAD;ROADBOSS;TYSONKING; ZEETEX;TOLEDO;ALTAIRE;CARGOFORCE; HS205;DR818;MH3000;TP245;PILOTRS2;NF19; GA205;H5100;ZSH10 vfm;dr109;ap202;csl612 HS268

7 215/75R17.5 Qingdao Kebek Tire Co.,Limited T E S T R E P O R T according to UNECE-Regulation Uniform provisions concerning the approval of pneumatic tyres for commercial vehicles and their trailers ECE-R54 including all amendments until Amend.00, Suppl. 21 Approval Status UNECE approval E4-54R Ext. 01 Structure of the Test Report Item No. 0. General information 1. Tested vehicle(s) / object(s) 2. Test record 3. List of appendices 4. Statement of conformity The Test Report shall be reproduced and published in full by the client only. It shall however be reproduced partially with the written permission of the Testing Laboratory only. Designation RDWT-CEB-01 Master_RDW_en_R16 Page 1 / 5

8 215/75R17.5 Qingdao Kebek Tire Co.,Limited 0. General Information 0.1. Make (trade name of the manufacturer) Category of vehicle 0.4. Name and address of the manufacturer Qingdao Kebek Tire Co.,Limited 215/75R17.5 Not applicable Qingdao Kebek Tire Co.,Limited Daozhuang Industry Zone, Guangrao County,Dongying City, Shandong Province , 0.5. No. of the information folder Not applicable -Date of issue --- -Date of last change Tested vehicle(s) / object(s) 1.1. Description Vehicle / object Commercial description (s) /variant(s) /version(s) Not applicable 215/75R17.5 Identification number See Appendix Condition of vehicle(s)/object(s) New / used / pretested 1.2. Worst case selection The determination of the worst case was done according to internal procedures of the Technical Service (QMA , section ) Remarks Not applicable Designation RDWT-CEB-01 Master_RDW_en_R16 Page 2 / 5

9 215/75R17.5 Qingdao Kebek Tire Co.,Limited 2. Test record 2.1. Equipment for measuring and testing The test facilities / measurement equipment used were in compliance with the test requirements Specifications for the test site Not applicable Subcontracting Not applicable 2.2. Test results See Appendix 1 Numbering according to Paragraph 6. and 7. of the UNECE-R Test results refering to measurements Pass / Fail Attributive tests Not applicable Alternative test provisions Not applicable Remarks concerning extension The type has been tested according to the modification(s) mentioned in appendix 0. The new parts meet the requirements of the regulation. An actual practical test of the type was not necessary. The results of the previous test(s) are still valid Additional information The results of the test refer exclusively to the object(s) mentioned under point 1. of this report. Test site Qingdao Kebek Tire Co.,Limited Daozhuang Industry Zone, Guangrao County,Dongying City, Shandong Province , Test date April 17-19, Remarks Not applicable Designation RDWT-CEB-01 Master_RDW_en_R16 Page 3 / 5

10 215/75R17.5 Qingdao Kebek Tire Co.,Limited 3. List of Appendices Appendix 0 Appendix 1 List of modifications Test minutes 4. Statement of conformity The in point 0.5. mentioned information folder and the type described in that comply with the requirements mentioned on page 1. With regard to the required level of performance to be achieved, the tested items were representative for the type to be approved (see point 1.2). The mentioned test results refer to the vehicle(s)/object(s) described under point 1.1 of this report. Engineering centre Shanghai / October 26, 2017 LX Liu Xin Expert Technical Service Designation RDWT-CEB-01 Master_RDW_en_R16 Page 4 / 5

11 215/75R17.5 Qingdao Kebek Tire Co.,Limited List of modifications Appendix 0 Correction of --- Modification of --- Addition of Trade marks and tread patterns Deletion of --- Designation RDWT-CEB-01 Master_RDW_en_R16 Page 5 / 5

12 215/75R17.5 Qingdao Kebek Tire Co.,Limited Test minutes Appendix 1 1. Test data 1.1 Object markings Trade name or mark KAPSEN Tyre type designation HS Plies of Tread / Sidewall 4 STEEL / 1 STEEL Tyre size designation 215/75R Category of use Indication of category of use Structure Indication / symbol of structure Normal Not applicable Radial Word "RADIAL", letter "R" in front of rim diameter marking Speed category Nominal M Supplementary Load-Capacity Indices(L.I.) corresponding to nominal speed Single 126 Twinned 124 corresponding to supplementary speed Single --- Twinned Index of inflation pressure for testing 100 PSI Ply-rating number Word in case of without inner tube TUBELESS Word in case of tyre can be regrooved REGROOVABLE Inscription in case of Free Rolling Tyre or Traction Tyre Not applicable Date of manufacture Dimension measurement according to Annex Measuring rim 6.0 X Inflation pressure after mounting on measuring rim Inflation pressure adjusted before conditioning 7.0 bar 7.0 bar Conditioning of tyre More than 24 hours Inflation pressure readjusted after conditioning 7.0 bar Overall width at six equally spaced points mm mm mm mm mm mm Max mm Designation RDWT-CEB-01 Master_RDW_en_R16 Page 1 / 2 Appendix 1

13 215/75R17.5 Qingdao Kebek Tire Co.,Limited Circumference 2409 mm Outer diameter mm Tread depth / void to fill ratio in case of special use tyre Not applicable 1.3. Load/speed performance test according to Annex Test machine GX-YLN Diameter of test drum m Test rim 6.0 X Inflation pressure adjusted before conditioning 7.0 bar Conditioning of tyre More than 3 hours Test-room temperature 26 ~ 28 C Inflation pressure readjusted after conditioning Circumference after conditioning, before testing Outer diameter after conditioning, before testing 7.0 bar 2409 mm mm % load corresponding to L.I.(single) 1700 kg Step Step duration Total duration Actual speed Test Load [h] [h] [km/h] [%] [kg] Conditioning after testing More than 6 hours Circumference after conditioning, after testing Outer diameter after conditioning, after testing 2410 mm mm Difference outer diameter before and after testing (max. 3.5 %) 0.3 mm 0.04 % Inspection after test The tyre does not exhibit tread separation, ply separation, cord separation, chunking or broken cords. 2. Remarks The test data mentioned in Paragraph 1. Of Appendix 1 refer to report No. 86-R /17-00 corresponding to type approval No. E4-54R Ext.00. Designation RDWT-CEB-01 Master_RDW_en_R16 Page 2 / 2 Appendix 1