THE NETHERLANDS (N E D E R L A N D) COMMUNICATION. Approval number: E4-110R Extension number: 00

Transcription

1 Vehicle Technology Division THE NETHERLANDS (N E D E R L A N D) COMMUNICATION Concerning (1) - approval granted - approval extended - approval refused - approval withdrawn - production definitely discontinued of a type of CNG/LNG component pursuant to Regulation number 110. Approval number E4-110R Extension number CNG/LNG component considered - Container(s) or cylinder(s) (1) - Tank(s) or vessel(s) 2 - Pressure indicator (1) - Pressure relief valve (1) - Automatic valve(s) (1) - Excess flow valve (1) - Gas-tight housing (1) - Pressure regulator(s) (1) - Non-return valve(s) (1) - Pressure relief device (PRD)(temperature triggered) (1) - Manual valve (1) - Flexible fuel lines (1) - Filling unit or receptacle (1) - Gas injector(s) (1) - Gas flow adjuster (1) - Gas/air mixer (1) - Electronic control unit (1) - Pressure and temperature sensor(s) (1) - CNG filter(s) (1) - PRD (pressure triggered) (1) - Fuel rail 2 - Heat exchanger/vaporizer 2 - Natural gas detector 2 - LNG filling receptacle 2 - LNG pressure control regulator 2 - LNG pressure and/or temperature sensor 2 P.O. Box 777 Tel (0) Vehicle Admission & Surveillance 2700 AT Zoetermeer ttv@rdw.nl The Netherlands CNG-components R v3.00 Page 1 of 5

2 Approval number E4-110R Extension number 00 - LNG manual valve 2 - LNG non return valve 2 - LNG pressure relief valve 2 - LNG excess flow valve 2 - LNG fuel pump 2 2. Trade name or mark LNG Tank including vaporizer 3. Manufacturer s name and address Alutech GmbH Lend Lend Austria 4. If applicable, name and address of manufacturer s representative 5. Submitted for approval on June Technical service responsible for conducting approval tests Kiwa Nederland B.V. P.O. Box AC Apeldoorn The Netherlands 7. Date of report issued by that service June 15 th, Number of report issued by that service Approval granted/refused/extended/withdrawn (1) 10. Reason(s) of extension (if applicable) 11. Place Zoetermeer 12. Date 13. Signature 14. The documents filed with the application or extension of approval can be obtained upon request. (1) Strike out what does not apply. CNG-components R v3.00 Page 2 of 5

3 Approval number E4-110R Extension number 00 ADDENDUM 1. Additional information concerning the type-approval of a type of CNG/LNG components pursuant to Regulation number Natural Gas Storage System Container(s) or cylinder(s) Dimensions Approved outer tank diameters 200 mm MIN O.D. 853 mm Max O.D. Approved inner tank diameters 150 mm MIN O.D. 803 mm MAX O.D. Approved tank length mm MIN mm MAX Material Stainless steel Tank(s) or vessel(s) (for LNG system) Capacity Material Component Heat exchanger Fill receptacle Fill receptacle Vent receptacle Manual vent valve Economizer Final pressure regulator Automatic valve Excess flow valve Secondary relief valve Manual drain valve Fill check valve Primary relief valve Pressure gauge Pressure gauge Maximum allowable working pressure Temperature range Primary relief valve Secondary relief valve From 100 litre up to 935 litre The LNG tank system complying with the R110 consists out of the following components Certificate number Part of this approval E4-110R L E4-110R E4-110R L E4-110R L E4-110R E4-110R E4-110R E4-110R E4-110R E4-110R E4-110R E4-110R E4-110R E1-110R L E4-110R L 1.59MPa (15,9bar) -162 C up to 85 C 1.2. Pressure indicator Working pressure(s) (2) Material 1.3. Pressure relief valve (discharge valve) Working pressure(s) (2) Material 1.4. Automatic valve(s) Working pressure(s) (2) Material CNG-components R v3.00 Page 3 of 5

4 Approval number E4-110R Extension number Excess flow valve Working pressure(s) (2) Material 1.6. Gas-tight housing Working pressure(s) (2) Material 1.7. Pressure regulator(s) Working pressure(s) (2) Material 1.8. Non-return valve(s) or non-return valve(s) Working pressure(s) (2) Material 1.9. Pressure relief device (temperature triggered) Working pressure(s) (2) Material Manual valve Working pressure(s) (2) Material Flexible fuel lines Working pressure(s) (2) Material Filling unit or receptacle Working pressure(s) (2) Material Gas injector(s) Working pressure(s) (2) Material Gas flow adjuster Working pressure(s) (2) Material Gas/air mixer Working pressure(s) (2) Material Electronic control unit (CNG-fuelling) Basic software principles Pressure and temperature sensor(s) Working pressure(s) (2) Material CNG filter(s) Working pressure(s) (2) Material CNG-components R v3.00 Page 4 of 5

5 Approval number E4-110R Extension number PRD (pressure triggered) Working pressure(s) (2)... MPa Material Fuel rail(s) Working pressure(s) (2)... MPa Material Heat Exchanger(s) / Vaporizer(s) Working pressure(s) (2) MPa Material Natural gas detector(s) Working pressure(s) (2)... MPa Material LNG filling receptacle(s) Working pressure(s) (2)... MPa Material LNG pressure control regulator(s) Working pressure(s) (2)... MPa Material LNG pressure and/or temperature sensor(s) Working pressure(s) (2)... MPa Material LNG manual valve(s) Working pressure(s) (2)... MPa Material LNG automatic valve(s) Working pressure(s) (2)... MPa Material LNG non return valve(s) Working pressure(s) (2)... MPa Material LNG pressure relief valve(s) Working pressure(s) (2)... MPa Material LNG excess flow valve(s) Working pressure(s) (2)... MPa Material LNG fuel pump(s) Working pressure(s) (2)... MPa Material (2) Specify the tolerance CNG-components R v3.00 Page 5 of 5