SACE FORMULA Link. Incoming kit for lugs. Outgoing for A1. Incoming for CB T6. Outgoing for A2. Doc. N. 1SDH000717R L5808

Transcription

1 Phase indent Circuit No Cable Size FORMULA Link FORMULA Link is approved for use with the following ABB SACE Circuit Breakers: - SACE Tmax T6 - SACE FORMULA A - SACE FORMULA A - SACE FORMULA A In selecting circuit breakers both for initial installation and for replacement, due consideration must be given to the short circuit capacity, instantanous trip current, voltage and current requirements of the application. Doc. N. SDH77R64 - L588 SACE FORMULA Link Istruzioni di installazione FORMULA Link 6-8 Installation instructions for FORMULA Link 6-8 Installationsanleitungen FORMULA Link 6-8 Instructions d'installation FORMULA Link 6-8 Instrucciones de instalación FORMULA Link 连接母排安装说明书 FORMULA Link 6-8 Disconnettere ogni alimentazione a monte dell'installazione e portare ogni interruttore in posizione di aperto prima di installare, modificare o eseguire manutenzioni. E' proibito avvicinarsi a parti in tensione prima di aver disconnesso l'alimentazione a monte. ABB non si assume responsabilità per danni a persone o cose derivanti dalla non applicazione o dall'incorretta applicazione delle istruzioni fornite qui e nelle istruzioni d installazione degli interruttori. Disconnect all power sources on the supply side of the installation and set each circuit-breaker to the open (off) position before proceeding with the installation, modification or servicing operations. Do not touch live parts without having first disconnected the power sources on the supply side. ABB declines all liability for damage to persons or things deriving from failure to comply with the instructions given here and in the installation instruction manuals of the circuit-breakers, or from incorrect application of such instructions. Jede der Anlage vorgeschaltete Stromversorgung unterbrechen und jeden Leistungsschalter in die Aus-Stellung bringen, bevor Installationen, Änderungen oder Wartungsarbeiten ausgeführt werden. Es ist verboten, sich Spannung führenden Teilen anzunähern, bevor die Stromversorgung stromauf unterbrochen worden ist. ABB haftet nicht für Sach- oder Personenschäden infolge der Nichtanwendung oder der nicht korrekten Anwendung der Anweisungen, die hier und in den Installationsanleitungen der Leistungsschalter geliefert werden. Débrancher chaque alimentation en amont de l installation et placer chaque disjoncteur dans la position de ouvert avant de mettre en place, modifier ou effectuer des opérations d entretien. Il est interdit de s approcher des parties sous tension avant d avoir débranché l alimentation en amont. ABB décline toute responsabilité pour les dommages aux personnes ou aux biens dérivant de la non application ou de la mauvaise application des instructions fournies ici et dans les instructions de mise en place des disjoncteurs. Desconectar todas las alimentaciones en entrada a la instalación y poner todos los interruptores en posición de abierto antes de efectuar instalaciones, modificaciones o trabajos de mantenimiento. Está prohibido acercarse a partes bajo tensión antes de haber desconectado la alimentación en entrada. ABB no se asume ninguna responsabilidad por eventuales daños a las personas o a las cosas imputables al incumplimiento o bien a una errónea implementación de las instrucciones aquí suministradas y aquellas relativas a la instalación de los interruptores. 在进行安装 更改或维修操作前, 必须断开所有供电端的电源, 并将每个断路器操作到断开 (off) 位置 在没有断开供电端 电源之前, 不可触摸带电的零部件 ABB 不承担因不遵守本说明书和断路器安装说明书或不正确的使用而导致对人身或物体造成损伤的责任 Panel Reference...[Type] Incoming Supply: Current...[A] Voltage...[V] Frequency...[Hz] Incoming device...[type] FORMULA Link 6-8A IEC 649- Useful Length F=54 Ue=55V AC, 5-6 Hz Ui=69V AC, 5-6 Hz Uimp=6 KV Icw=4 KA, rms sec Outgoing for A Incoming kit for lugs Outgoing devices: Load Incoming for CB T Outgoing for A

2 A B A A C D OK,Nm NO E F Nm

3 G Example with main CB T6 H 57 ±.5 7Nm Nm I 用户自备. 6A J 8A mm Nm 4 9Nm 5 mm 9Nm K 用户自备. 8A L 8A mm Nm 4 9Nm 5 mm 9Nm

4 M Example without main CB N 用户自备 54 ± Nm 4 min max ø max 9 max 6 max O Example mounting outgoing P Q R for A only Nm OK NO 用户自备

5 S for A only for A only T 4Nm 用户自备.,Nm U for A only V for A-A 65 mm 8Nm,Nm 6 mm W 用户自备. FORMULA Link 6-8A IEC 649- Useful Length F=54 Ue=55V AC, 5-6 Hz Ui=69V AC, 5-6 Hz Uimp=6 KV Icw=4 KA, rms sec FORMULA Link 6-8A IEC 649- Useful Length F=54 Ue=55V AC, 5-6 Hz Ui=69V AC, 5-6 Hz Uimp=6 KV Icw=4 KA, rms sec NL 6 ITH AW R FO 6 FORMULA Link FORMULA Link is approved for use with the following ABB SACE Circuit Breakers: O A ND A A ITH A A W OR 8 F R 6 S FO LWA A 8 FORMULA Link - SACE Tmax T6 - SACE FORMULA A - SACE FORMULA A - SACE FORMULA A FORMULA Link is approved for use with the following ABB SACE Circuit Breakers: - SACE Tmax T6 - SACE FORMULA A - SACE FORMULA A - SACE FORMULA A In selecting circuit breakers both for initial installation and for replacement, due consideration must be given to the short circuit capacity, instantanous trip current, voltage and current requirements of the application. Panel Reference...[Type] In selecting circuit breakers both for initial installation and for replacement, due consideration must be given to the short circuit capacity, instantanous trip current, voltage and current requirements of the application. Panel Reference...[Type] Incoming Supply: Current...[A] Voltage...[V] Frequency...[Hz] Incoming device...[type] Incoming Supply: Current...[A] Voltage...[V] Frequency...[Hz] Incoming device...[type] Outgoing devices: Outgoing devices: Phase indent Circuit No Load Cable Size Phase indent Circuit No Load Cable Size 用户自备.

6 A-8A A B F 4WA F 6WA F 8WA F4 WA F5 WA C Z A-8A D F 4WA 5 F 6WA 6.5 F 8WA F4 WA 8 F5 WA D 4 min B 5 A 5 == == 6A 8A ( 47 ) With A only With A and A, or A only 6A C 6 mm 8 mm 8A C 8 mm 8 mm C With A only With A and A, or A only 6A C 6 mm 8 mm 8A C 8 mm 8 mm Copyright 9 ABB.All rights reserved