Micropump 5 Minute Product & Pricing Guide.

Transcription

1 Micropump 5 Minute Product & Pricing Guide

2 ULTRA LOW FLOW MP6 MICROPUMPS mp6, mp6-pi & mp6-air mp6-pp Micropumps are used for processing of fluids such as gases or liquids, just like conventional pumps with the benefits of smaller size, minimal energy consumption and utilization of novel actuation principles (microactuators)

3 MP6 OPERATING PRINCIPLES The functional principle of piezo membrane micropumps is easily explained. A piezo ceramic is mounted on a brass membrane and deforms that membrane when a voltage is applied. With the resulting downstroke the medium is squeezed out of the pump chamber below. Check valves on both sides of the chamber define the flow direction. When the voltage is decreased, the piezo's corresponding deformation causes an upstroke of the membrane. The medium is sucked in and the chamber is filled. The pump can operate at up to several hundred pumping cycles per second. The pumping characteristics can be optimized by adjusting three parameters: amplitude, frequency and wave form of the electric control signal.

4 MP6 KEY FEATURES Suitable for gases and liquids Low energy consumption < 200 mw Size 30 x 15 x 3.8 mm³ mp6 Material in fluid contact: PPSU Max flow rates 7 ml/min (water) 42 ml/min (gas), use mp6-air Max pressures 600 mbar (water) 100 mbar (gas) mp6-air for air/gas pumping mp6-pi Valve foil made out of polyimide Material in fluid contact: Polyimide & PPSU Max flow rates same as mp6 mp6-pp (polypropylene-coated) Material in fluid contact: PP Max flow rates 5 ml/min (water) 6.8 ml/min (MeOH) Max pressure 650 mbar (water) 550 mbar (MeOH)

5 ROBUST AND RELIABLE Lifetime > 5,000 hours proven; 10,000 hours reached in continuous testing Steam sterilization according to DIN EN 554, 121 C, 20 min possible EtO Sterilization possible (50 C, 10% EtO > 60% rel. Humidity) Gamma or e-beam Durable under environmental composite temperature / humidity cyclic test according to IEC (10 cycles of 24h from 10 C to 65 C up to 93% rel. humidity)

6 APPLICATION OVERVIEW

7 EVALUATION KITS mp6-go! For tabletop testing, includes 3 mp6 micropumps, 1 mp-x controller with connection cable, 1 meter tubing Price: $1050 mp6-basic For tabletop testing, includes 3 mp6 micropumps, 1 mp6-eva evaluation board, 1 meter tubing Price: $380 mp6-pro For evaluation directly on your circuit board, includes 5 mp6 micropumps, 5 mp6-oem controllers, 1 mp6-mol (10 connectors), 1 meter tubing Price: $511

8 NEW EVALUATION KITS These kits utilize the new mp6-quadoem which allows for control of 4 pumps simultaneously. Increased frequencies of up to 800 Hz lets users pump up to 42 ml/min of air with mp6-air. mp6-quad-eva: Controls up to 4 mp6 pumps simultaneously. Price is $525. mp6-air-quadeva is $545. mp6-quadkey: Controls up to 4 mp6 pumps, detachable mp6-quadoem, utilizes Arduino as an interface. Price is $525 and mp6-air-quadkey is $545.

9 ESTIMATED PRICING, SUBJECT TO CHANGE WITHOUT NOTICE Model Under 10 pc mp6 $38.00 $26.26 $18.10 $16.23 mp6-pi $50.00 $36.36 $23.34 $20.93 mp6-air $44.00 $29.84 $20.66 $17.93 mp6-pp $ $ Contact us Additional price breaks in between & above these quantities are available, please contact us for pricing.

10 M SERIES OF MICROPUMPS M ml/min M ml/min M ml/min M lpm

11 M SERIES OF MICROPUMPS Voltage Max Free Flow (ml/min) Max Pressure (mbar) Motor Controller Price Range for samples M100 Series Brush N/A $75 - $84 M100P Series Brush N/A $75 - $84 M200 Series Brush N/A $75 - $84 M200P Series Brush N/A $75 - $84 M400 Series Brushless Internal $134 - $141 M400K Series Items common in most families: 380 Brushless Internal $134 - $141 M510 Series Brushless Required $ Centrifugal pump for liquids Wetted materials are aluminum/stainless Seals available: Viton, EPDM, Silicon & PTFE (M510 only) Various packages available including 2 port, 3 port, waterproof & submersible

12 D200 SERIES OF MICROPUMPS For Air or Liquids Sample prices range from $103-$159 V is Viton seal, SE is EPDM seal BLZ is longer life motor (slightly longer in size) Model Families D220S-V D220BLZ-V D250S-V D250BLZ-V D250S-LF-VSS D250BLZ-LF-VSS Input Voltage Description Coreless brushed Brushless long life, driver built-in Coreless brushed Brushless long life, driver built-in Liquid fuel, coreless brushed Liquid fuel, brushless long life, driver built-in

13 MG SERIES MG1000 & MG2000 MGD ml/min free flow Max pressure of 7000 mbar Voltage range of 5-24V Size: 55 x 35 x 35 mm Weight 75g Sample price: $338-$368 each MG ml/min free flow Max pressure of 15 bar Voltage range of 6-24V Size: 89 x 49 x 53 mm Weight 340g Sample price $428 each

14 R SERIES OF MICROPUMPS R400 Conical revolution liquid pump ml/min free flow Max pressure of 5000 mbar Voltage range of 6-24V Size: 30 x 30 x 65 mm Sample price: $263 each for brushless version

15 D10K SERIES OF MICROPUMPS D10K Micro Diaphragm gas pump 11 lpm Max pressure of 6 psi Voltage range of 8V Size: 41 x 40 x 78 mm Sample price: $353 Drivers available for purchase

16 EQI DRIVER SERIES Input Voltage 12-30Vdc Designed to be installed in-line with the pump s own wiring Flow can be controlled via an onboard Pot. or a 0-5v signal Dimensions 24x57x17mm Weight 14g Part Number Pump Used Price EQiM M500 $87.75 EQi-MG1 MGD1000 $87.75 EQi-MG2 MGD2000 $87.75 EQi-R R400 $87.75 EQi-D D10K $87.75

17 CONTACT US HOW MAY WE HELP YOU? Tel: or (US only) Fax: Web site: Blog: blog.servoflo.com Follow us on: Twitter LinkedIn Facebook Google+