Wood/wide aluminum hardware set

Transcription

1 AVENTOS HK Wood/wide aluminum hardware set Lift mechanism set Lift mechanism (qty 2) #7 x mm (-/8 ) wood screw (qty 0) Power factor Opening angle K200.N K200.N K2700.N K2900.N Cover set Right and left cover plate Non-handed cover cap (qty 2) Cover set 20K8000.NA Wood or wide alum door hardware set Mounting plate with bracket set Arm assembly mounting plate (qty 2) Left and right mounting plate with bracket For large overlay five-piece doors Hardware set 20S4200 Inst. screw for wood doors 606N or 606P Inst. screw for wide alum doors 7072A Mounting plate w/ bracket set 20S4F0 Subject to technical modifications without notice. 20

2 Assembly WARNING Risk of injury from spring-loaded arm Do not push arm assembly down or leave in the down position Remove mechanism before installing or removing cabinet Locating pin locations and minimum depth Panel Face frame Z NOTE: Face frame cabinets must be blocked out flush with the frame. Overlay up to 28 2 Z 7 Universal individual template is available for pre-boring locating pins Attaching the lift mechanism Align the lift mechanism in the cabinet using the mm locator pins and attach the mechanism with the three wood screws provided. min. Ø #7 x mm (-/8") wood screws (qty ) 2 Subject to technical modifications without notice. 20

3 Remove transport tab from lift mechanism and raise arms A B Carefully remove the transport tab. Raise the arm to the upright position. NOTE: Do not remove transport tab until just before attaching the door Risk of injury from spring loaded arm. Attaching the mounting plates 4a For Wood/wide aluminum doors 4b With bracket for five-piece doors Panel 0 + Overlay 2. + Overlay ü 2. more than Standard mounting plate works 2. Face frame 4. + Overlay 2. + Overlay NOTE: All four screws must be installed ü less than 6 Standard mounting plate does not work 2. 9 Use mounting plate with bracket when panel is < 6 mm from screw Mounting plate w/ bracket set 20S4F0 Subject to technical modifications without notice. 20

4 Assembly Attaching the door Attach the door using the CLIP mechanism in the mounting plate. 6 Adjust the door tension Use a screw gun and #2 x 2 POZI driver bit to adjust the lift mechanism to the desired tension. 4 Subject to technical modifications without notice. 20

5 7 Finalize the door adjustments Use a POZI screwdriver to adjust cam adjustments for each of the three-dimensional adjustments. 2 2 mm mm mm 8 Attach cover caps Snap the symmetrical cover caps on each cover plate. Place the left and right cover plates over the appropriate lift mechanisms and snap them in place. Subject to technical modifications without notice. 20

6 Removal WARNING Risk of injury from spring-loaded arm Do not push arm assembly down or leave in the down position Remove mechanism before installing or removing cabinet Removing the covers Remove the cover caps and cover plate. 2 Removing the door Open the door. Use a screwdriver to disengage the CLIP mechanism of the lever arm from the mounting plate Support the door with one hand and repeat on the other side 6 Subject to technical modifications without notice. 20

7 Other information Panel and face frame clearance Inch mm X Door thickness /2.0 /6.06. / /8.2 /2.6 4 / /2.29. / / Door thickness X /6. 8 / / / /6.48 / /2. 7 /2.. 9 / /2.94 / / / / / / / / Blum, Inc sales.us@blum.com blum.com Subject to technical modifications without notice. 20 INST-AVT / / / /