LIFTING EQUIPMENT lift tables HIW RANGE. Ergox hygraulic single scissor lift tables PRODUCT SPECIFICATIONS

Transcription

1 LIFTING EQUIPMENT lift tables HIW RANGE Ergox hygraulic single scissor lift tables PRODUCT SPECIFICATIONS

2 HIW Range Ergox hygraulic single scissor lift tables FEATURES High pressure cylinder with dual safety function Emergency switch off Hard chrome plated piston rods 3m long control cable 3 Phase power pack Anti-entrapment bar on all four sides of table Hand-held pendant controls Complies with European safety standard EN month warranty SPECIFICATIONS Model HIW2.0EU HIW4.0EU HIW3.0EU Capacity kg Platform Size (LxW) mm 1300 x x x 800 Lowered Height mm Raised Height mm Lifting time sec Lifting speed with load mm/s Lowering speed with load mm/s Motor KW Net Weight kg

3 Maintenance of Lift tables To be carried out once every 3 months, unless the operation and environmental conditions require shorter intervals. Discuss suitable intervals with your Ergox representative. Inspections, servicing and repair works must be carried out by competent personnel. During inspections, service and repair works there must be no load on the machine. During all work beneath the platform the service supports/maintenance chocks must be in place. MECHANICAL EQUIPMENT: Check that all wheels and bearing pins are properly secured. Check that there is no excessive bearing play. Check that that there are no breaks or cracks in any welded joints. Check that the safety frame profiles (safety trip bars) and their fittings are intact and not damaged Check that the floor/ground fixings are firm. Check that all labels are present and fully legible. When greasing the bearings the machine must be unloaded. GREASING POINTS: When greasing the bearings the lift must be unloaded! Remember when checking the oil level in the tank that the oil volume is at a maximum when the lift is at the lowest level. Handle oil spillage as hazardous waste. HYDRAULIC SYSTEM: Check the oil tank for possible leakage. Check the oil level in the tank. Re-fill if necessary. Oil type ISO 32, unless otherwise specified on the power pack. If the oil is dirty it must be changed. Inspect hydraulic hoses and connections for leaks or damage. Correct if necessary. Inspect cylinders, hydraulic hoses and fittings for damage or wear. ELECTRICAL EQUIPMENT: Inspect and test electrical functions. Check that there are no loose or trapped cables and wires. Adjust if necessary. LIFT TABLE GREASING POINTS: 1. Upper arm fixing 3. Arm Centre 2. Piston rod bearing 4. Lower arm fixing

4 Spare Parts GENERAL: RECOMMENDED SPARE PARTS: During inspections, servicing and repair work there must be no load on the platform. Only Ergox original spare parts are to be used when replacing any parts. Our warranty commitment may otherwise be invalidated We keep a stock of all types of spare parts for standard Lift tables. However it is sometimes reasonable for you to keep some vital parts in stock. We can suggest appropriate stock, depending on individual circumstances. ORDERING SPARE PARTS: RETURN OF PARTS: When ordering spare parts always quote the details shown on the machine plate, i.e. Type/Model Manufacturing number Year of Manufacture Position number and article number according to the spare parts list. Voltage for electrical components Number of units A full spare parts list will be supplied with the machine for reference and use by your onsite maintenance team. Do not return any parts that have been worn out during normal operation or accidentally damaged. Only return worn or damaged parts if it is considered that the fault is covered by our warranty conditions. In such cases, return the parts without delay as otherwise the right to replacement may be lost. When returning parts always quote the details shown on the manufacturer s plate, i.e. Type/Model Manufacturing number Year of Manufacture Installation date Describe the operating conditions for the machine Remember to quote name, address and telephone number of the appropriate contact person.

5