Arena-Walsall power track system standard

Transcription

1 standard Standard track length SL12 Standard feeder unit SFU Standard tap-off SO3U Standard SFB 1 Dimensions and technical information (p ) wo bar and earth 63 power track system Pack Cat. Nos. rack lengths and feeder unit Standard track lengths Recommended spacing between two clamps no greater than one metre 1 SL metres, 4 tap-offs 1 SL metres, 6 tap-offs 1 SL metres, 8 tap-offs 1 SL metres, 10 tap-offs 1 SL metres, 12 tap-offs Standard feeder unit Supplied with to be 1 SFU 2 x 20/25 mm knockout entries Standard tap-offs SL12 SFU ll tap-offs conform to Section 607 of BS 7671 : 2001 hese tap-offs can also be used with the dual circuit power track Standard 1 SFB1 Comprises a length of 25 mm conduit with a plug-in feed at each end, pre-wired with 10 mm 2 tri-rated cable Standard tee units Supplied with slider and 1 SU Left feed 1 SU B Centre feed 1 SU C Right feed Standard four way 1 SFW Supplied complete with slider and two end caps ccessories 1 Spare hold down clamp SFB1 SU B SFW 1 SO3U 3 metres, unfused 1 SO3F 3 metres, fused 1 SO5F 5 metres, fused 2 Bar + Earth SO3F 1 Spare end cap Standard power track is denoted by a white label with a black flash 194

2 clean earth track length CL12 feeder unit CFU tap-off CO3U CFB 1 Dimensions and technical information (p ) hree bar and earth 63 power track system including an independant clean earth copper bar Pack Cat. Nos. rack lengths and feeder unit track lengths Recommended spacing between two clamps no greater than one metre 1 CL metres, 4 tap-offs 1 CL metres, 6 tap-offs 1 CL metres, 8 tap-offs 1 CL metres, 10 tap-offs 1 CL metres, 12 tap-offs feeder unit Supplied with to be 1 CFU 2 x 20/25 mm knockout entries tap-offs ll tap-offs conform to Section 607 of BS7671 : 2001 hese tap-offs can also be used with the dual circuit power track 1 CO3U 3 metres, unfused 1 CO3F 3 metres, fused 1 CO5F 5 metres, fused CL12 CFU Clean Earth CO3U 1 CFB1 Comprises a length of 25 mm conduit with a plug-in feed at each end, pre-wired with 10 mm 2 tri-rated cable tee units Supplied with slider and 1 CU Left feed 1 CU B Centre feed 1 CU C Right feed four way 1 CFW Supplied with slider and two end caps ccessories 1 Spare hold down clamp CFB1 CU B CFW 1 Spare end cap power track is denoted by a white label with a red flash 195

3 dual circuit track length DL12 feeder unit DFU tap-off DO3U DFB 1 Dimensions and technical information (p ) Five bar and earth 50 power track system incorporating both standard and clean earth systems within one enclosure Pack Cat. Nos. rack lengths and feeder unit track lengths Recommended spacing between two clamps no greater than one metre 1 DL metres, 4 tap-offs 1 DL metres, 6 tap-offs 1 DL metres, 8 tap-offs 1 DL metres, 10 tap-offs 1 DL metres, 12 tap-offs feeder unit Supplied with to be 1 DFU 2 x 20/25 mm knockout entries tap-offs ll tap-offs conform to Section 607 of BS 7671 : 2001 hese tap-offs must only be used with the dual circuit power track ll tap-offs from standard and clean earth track can also be used 1 DO3U 3 metres, unfused 1 DO3F 3 metres, fused 1 DO5F 5 metres, fused DL12 DFU Dual Circuit D03U 1 DFB1 Comprises a length of 25 mm conduit with a plug-in feed at each end, pre-wired with 10 mm 2 tri-rated cable tee units Supplied with slider and 1 DU Left feed 1 DU B Centre feed 1 DU C Right feed four way 1 DFW Supplied with slider and two end caps ccessories 1 Spare hold down clamp DFB1 DU B DFW 1 Spare end cap power track is denoted by a white label with a black and red flash For pre-wired floor boxes and grommets, see p. 200, 204 Contact us on

4 three phase Single phase track length PL12 Single phase feeder unit PFU Single phase tap-off PO3UR hree phase PFB 1 Dimensions and technical information (see p ) Four bar and earth 50 power track system. hree phased bars, one neutral bar and earth Pack Cat. Nos. rack lengths and feeder unit hree phase track lengths Recommended spacing between two clamps no greater than one metre 1 PL metres, 4 tap-offs 1 PL metres, 6 tap-offs 1 PL metres, 8 tap-offs 1 PL metres, 10 tap-offs 1 PL metres, 12 tap-offs hree phase feeder unit Supplied with to be 1 PFU 2 x 20/25mm knockout entries ap-offs for three phase power track Single phase tap-offs ll tap-offs conform to Section 607 of BS 7671 : 2001 BS 7671 : 2001 amendment No.2 fixed wiring hese tap-offs must only be used with the 3 phase power track 1 PO3UR 3 metres, unfused reconfigurable 1 PO3FR 3 metres, fused reconfigurable 1 PO5FR 5 metres, fused reconfigurable hree phase tap-off PL12 PFU ll tap-offs conform to Section 607 of BS7671 : 2001 his tap-off must only be used with the 3 phase power track Single Phase PO3FR hree phase 1 PFB1 Comprises a length of 25 mm conduit with a plug-in feed at each end, pre-wired with 10 mm 2 tri-rated cable hree phase tee units Supplied with slider and 1 PU Left feed 1 PU B Centre feed 1 PU C Right feed hree phase four way 1 PFW Supplied with slider and two end caps ccessories 1 Spare hold down clamp 1 Spare end cap SFB1 PU B SFW 1 PO3U 3 metres, unfused (L1, L2 and L3 connected) Single Phase PO3U hree phase power track is denoted by a white label with a blue flash For pre-wired floor boxes and grommets, see p. 200, 204 Contact us on

5 technical information Specification / technical data erminal block connections Electrical data Rated current Rated voltage Frequency Rated short circuit withstand rack conductor resistance - line and neutral rack conductor impedance Volt drops Line and neutral : track ap-off (32-4 mm 2 cable) Flexible bend (10 mm 2 tri-rated cable) Feed unit rack connector Earth fault loop Impedance : L+N track conductors Earth track conductor ap-off (32-4 mm 2 cable) Feed unit rack connector Flexible bend (10 mm 2 tri-rated cable) 63 / V/415 V 50/60 Hz 16 k 3 mω/m 1 43 mω/m 2 86 mv//m 10 mv//m 3 7 mv//m 0 3 mv//m 0 4 mv//m 1 5 mω/m 1 2 mω/m 33 mω (3 metre L/N/E) 0 3 mω 0 4 mω 3 7 mω (1 metre L/N/E) L3 Standard L2 hree phase N L N L N L1 he three phase system is not interchangeable N2 L2 N1 L1 he three types above are compatible and an installation can be downrated from the dual circuit to either standard or clean earth in mid-run by means of a or direct connection (see opposite) rack length ll dimensions in mm Mechanical data Number of conductors PE + 2,3,4 and 5 rack conductor cross section area 13 mm 2 Incoming cable termination capacity 16 mm 2 ap-off cable 32 unfused 4 mm 2 ap-off cable 13 fused L/N : 2 5 mm 2, E : 4 mm 2 ap-off conduit 16 mm/20 mm diameter Feeder conduit entry 20 mm/25 mm diameter IP rating IP 40 (when fully assembled) Maximum profile height 47 mm including tap-off rack height 17 mm Material specification rack housing rack conductors rack insulator Sockets, track connectors, track ends ap-off plugs End shutters and track shutters ap-off / cable ap-off / feeder and connector pins echnical information Galvanised steel High conductivity copper Self extinguishing PVC extrusion Nylon Nylon Glass filled nylon LSF/PVC Brass Certification sta Certified and tested to BS EN : 1999 and BS EN : 2000 Manufactured within a S BEB approved ISO 9001:2000 facility Feeder units ap-offs Overall height : 47 mm with feeder unit and tap-off wo 20/25 mm knockout entries Supplied complete with terminal block, lid and turnbuckle fastener and ll dimensions in mm 60 Section of the Wiring Regulations require any conductor exceeding 3 m in length to have a fault current protective device (e.g. fuse) at the point where current carrying capacity is reduced (tap-off plug) ll tap-offs over 3 m will be supplied with a BS fuse fitted within the plug If the system is to be protected by a 32 breaker then unfused tap-offs exceeding 3 m may be specified at time of order Other pre-wired tap-off lengths are available on request Unfused tap-offs are rated at 32 Fused tap-offs are supplied with a standard BS fuse mm IEE Wiring regulations Legrand fully complies with BS 7671 : 2001 Section 607 requirements ll items comply with the relevant paragraphs of Section 607 of BS 7671 : 2001 Cable length - 3 or 5 m ap-off length refers to the cable and not the conduit length he conduit is 250 mm shorter than the cable length 198

6 ap-offs for three phase power track Single phase tap-offs hree phase tap-off ypical Layout he example opposite shows a typical layout consisting of numerous service outlet boxes with both standard and clean earth sockets in the call centre, two boxes with just clean earth sockets (fax, photocopier, etc) and boxes with standard sockets in the meeting rooms. Boxes with both standard and clean earth sockets can be fed with a dual circuit tap-off into a dual circuit track. he two clean earth boxes can be fed from the dual circuit track with just a clean earth tap-off PO3FR / PO5FR (fused) PO3UR (unfused) PO3U (unfused) he system can then be downgraded by connecting standard track on to the dual circuit track by means of a or direct connection. he continuing circuit is then restricted to a standard two bar and earth. his will save the contractor time and money by eliminating the need for extra cable and feeder units that would be required with separate systems ees and four ways Supplied complete with slider, lid, turnbuckle fasteners and end cap(s) Four way ee unit Left feed tee unit Component Cat. No./ Centre feed tee unit Component Cat. No./B Right feed tee unit Component Cat. No./C rack length (1 800 mm) rack length (1 200 mm) Flexible bends 1 metre Flexible bend End cap Cat. No. 19 Feeder unit ll dimensions in mm Meeting rooms Hold down clamp 80 Black Each power track length is supplied already fitted with sliding clamps. 2 clamps on each 1 2, 1 8 and 2 4 metre length 3 clamps on each 3 0 and 3 6 metre length Call centre R Red ll dimensions in mm 128 Vertical hanger bracket C Supplied in two parts complete with clamping screws () Use one M8 threaded rod (B) and four M8 nuts (C) (one above and below each bracket flange) Recommended spacing between vertical hanger brackets is 1 metre maximum B C R Red / Black Plant room Horizontal hanger bracket Supplied in two parts Use two M8 threaded rods () and four M8 nuts (B) (one above and below each bracket flange) Recommended spacing between horizontal hanger brackets is 1 metre maximum B B 3 compartment service outlet box complete with 1 standard twin socket and 1 clean earth red twin socket. 3 compartment service outlet box complete with 2 clean earth red twin sockets. 3 compartment service outlet box complete with 2 standard twin sockets. 199