a p prove d ELECTROMECHANICAL SLIDING GATE OPENER

Transcription

1 EN 25 EN 25 ELETROMEHNIL SLIING GTE OPENER G

2 The Junior gear box is built completely of die cast aluminium, and the coupling is supported by shielded roller bearings. ll of the internal operational components are protected with gaskets and oil seals and are lubricated with specific high performance grease for motor drive applications. The mounting of the Junior gate opener is by way of pavement expansion plugs or else by way of x M0 anchor bolts attached to the special anchor plate. This also enables the adjustment of the height of the reduction gear motor. iagnostic status of the entire system is indicated by way of the standard LE lamp in the protective housing. The ELPRO programmer as standard equipment is located in the upper part of the unit just below the cover. uring installation it is possible to immediately set Junior for Right or Left operations by way of the dipswitches, without need to act on the motor phase or the limit switches. lue signal lamp Protective housing Gear box in painted aluminium Manual unlock handle with coded key LE lamp turning amber in colour signals malfunction Magnetic limit switch standard Manual unlock with coded key

3 62, JUNIOR 62 JUNIOR 6 JUNIOR 650 Power yield 0.25KW (0.HP) 0.7KW (0.5HP) Power supply voltage Hz 20V 50Hz 20V 50Hz Motor voltage 2Vdc 20V 50Hz 20V 50Hz Max power absorbed 220W 00W 50W Max urrent bsorbed Max thrust force 00N 600N 000N Max gate weight 00 Kg 600 Kg 200 Kg Speed 2m/ 0m/ 0m/ Protection Grade IP 5 IP 5 IP 5 Lubrication Grease Grease Grease Operational Temperature Junior weight Kg. Kg.5 Kg Service ycle 0s opening / closing 20s pause 60s opening / closing 0s pause 60s opening / closing 0s pause omplete cycle time 00s = 6 cycles/hour 80s = 20 cycles/hour 80s = 20 cycles/hour Via Mantova 77/.P erea (VR) Italy Tel Fax info@fadini.net

4 EN 25 EN 25 2 The Junior 62 is an electromechanical sliding gate opener with a 2 V dc low voltage motor, designed and developed compliant with the EN 25 and EN 25 safety standards and the EN 2 product standard: any obstacle detected when the gate is either opening or closing, gate travel is reversed a while allowing obstacle removal, or reversed to fully open position. The backup batteries (optional) are recharged automatically by the ELPRO 62 programmer. ELPRO 62 Electronic Programmer 20V mains power supply input Motor Safety microswitch Quality in Motion omplete KIT with all commanding, signalling and safety accessories

5 EN 25 EN 25 2 The Junior 6 is an electromechanical sliding gate opener with a 20V single phase motor with 0. Hp, designed and developed compliant with the EN 25 and EN 25 safety standards and the EN 2 product standard: any obstacle detected when the gate is either opening or closing, gate travel is reversed a while allowing obstacle removal, or reversed to fully open position. ELPRO 6 Electronic Programmer 20V mains power supply input Motor Safety microswitch HIS 7 wall mount keyswitch 2 Pair of FIT 55 wall mount photocells

6 EN 25 EN 25 2 The Junior 650 is an electromechanical sliding gate opener with a 20V single phase motor with 0.5 Hp, designed and developed compliant with the EN 25 and EN 25 safety standards and the EN 2 product standard: any obstacle detected when the gate is either opening or closing, gate travel is reversed a while allowing obstacle removal, or reversed to fully open position. ELPRO 6 Electronic Programmer 20V mains power supply input Motor Safety microswitch MIRI flasher with antenna Plug in radio receiver with remote transmitter