RISER POLES RISER POLES. Overhead Electric Distribution Standards INTRODUCTION

Transcription

1 INTRODUCTION. For proper fuse coordination, refer to the SYSTEM PROTECTION section to select the appropriate fuse for underground risers.. Terminators or Potheads and their mounting brackets are included with the associated underground plates.. The terminator bracket shall always be installed a minimum of 8 inches below the cutout and arrester bracket. 4. The feeder riser plates are no longer in this section. They have been re-named and are now included in the SWITCHING section of this book. 5. Plate options are listed on each construction standard. 6. The plates within this section have had their names changed slightly to be consistent with other plates within this book. 7. Hot-line clamps are not part of the riser plates and must be plated separately. 8. There is no longer a designation for tangent or deadend riser, so all riser plates can be built on tangent or deadends, as shown in the drawings. For example, for 6.4kV, there is no longer a DUA and DUA. All 6.4kV single phase risers are now built with DUA. 9. The 6.4kV plates are shown, but the 4kV and.kv plate names are also listed on each page. The only difference is the size and kv rating of the arrester. 0. For the 6.4kV system, the 8kV arrester ARR LI 00 is now used in both riser pole and distribution line applications. Previously, ARR LI 04 served as the riser pole arrester. IV Page of 7

2 DUA SINGLE PHASE RISER 6.4kV (RUA 4kV, WUA.kV) OPTIONS: 0T, T, 5T, 0T, 5T, 0T, 40T, 50T, 65T, 80T, 00T ARR LI *** ARRESTER, LIGHTNING, POLYMER, kv, 0kV, or 8kV BKT AC 00 BRACKET, ARRESTER AND CUTOUT, SINGLE PHASE, POLE MOUNTED CAI RH 00 5 CABLE, NO. 4 COVERED SOFT DRAWN COPPER, FT 4 CNN VG 00 CONNECTOR, VISE TYPE, 6- SOL. 0- SOL. 5 COB CO 08 5 CONDUCTOR, BARE COPPER, #4 SOFT DRAWN 6 CUT OT 004 CUTOUT, FUSED, 5kV BIL, 00 AMP, 7kV 7 FUS OH *** GENERAL CODE FOR T-LINK FUSES 8 GUA AN 00 GUARD, ANIMAL, FOR USE WITH TRANSFORMERS AND ARRESTERS 9 GUA AN 006 GUARD, ANIMAL, FOR USE WITH FUSE CUTOUTS, SILICONE RUBBER IV Page of 7

3 DUAF (FIBERGLASS CONSTRUCTION) SINGLE PHASE RISER 6.4kV (RUAF 4kV, WUAF.kV) OPTIONS: 0T, T, 5T, 0T, 5T, 0T, 40T, 50T, 65T, 80T, 00T ARR LI *** ARRESTER, LIGHTNING, POLYMER, kv, 0kV, or 8kV BKT AC 009 BRACKET, FIBERGLASS, ARRESTER AND CUTOUT CAI RH 00 0 CABLE, NO. 4 COVERED SOFT DRAWN COPPER, FT 4 CNN VG 00 CONNECTOR, VISE TYPE, 6- SOL. 0- SOL. 5 CUT OT 004 CUTOUT, FUSED, 5kV BIL, 00 AMP, 7kV 6 FUS OH *** GENERAL CODE FOR T-LINK FUSES 7 GUA AN 00 GUARD, ANIMAL, FOR USE WITH TRANSFORMERS AND ARRESTERS 8 GUA AN 006 GUARD, ANIMAL, FOR USE WITH FUSE CUTOUTS, SILICONE RUBBER IV Page of 7

4 DUB TWO-PHASE RISER 6.4kV (RUB 4kV, WUB.kV) OPTIONS: 0T, T, 5T, 0T, 5T, 0T, 40T, 50T, 65T, 80T, 00T 9 6 ARR LI *** ARRESTER, LIGHTNING, POLYMER, kv, 0kV, or 8kV BKT AC 00 BRACKET, ARRESTER AND CUTOUT, TRI-MOUNT CAI RH 00 0 CABLE, NO. 4 COVERED SOFT DRAWN COPPER, FT 4 CNN VG 00 CONNECTOR, VISE TYPE, 6- SOL. 0- SOL. 5 COB CO 08 0 CONDUCTOR, BARE COPPER, #4 SOFT DRAWN 6 CUT OT 004 CUTOUT, FUSED, 5kV BIL, 00 AMP, 7kV 7 FUS OH *** GENERAL CODE FOR T-LINK FUSES 8 GUA AN 00 GUARD, ANIMAL, FOR USE WITH TRANSFORMERS AND ARRESTERS 9 GUA AN 006 GUARD, ANIMAL, FOR USE WITH FUSE CUTOUTS, SILICONE RUBBER 0 WAS RD 005 WASHER, ROUND, IN. DIA., FOR /4 IN. BOLT WAS SF 00 WASHER, SQUARE, FLAT, IN., FOR /4 IN. BOLT WAS SP 00 WASHER, SPRING, DOUBLE HELIX, FOR /4 IN. BOLT IV Page 4 of 7

5 DUBF (FIBERGLASS CONSTRUCTION) TWO-PHASE RISER 6.4kV (RUBF 4kV, WUBF.kV) OPTIONS: 0T, T, 5T, 0T, 5T, 0T, 40T, 50T, 65T, 80T, 00T 8 5 ARR LI *** ARRESTER, LIGHTNING, POLYMER, kv, 0kV, or 8kV BKT AC 00 BRACKET, FIBERGLASS, ARRESTER AND CUTOUT, TRI-MOUNT CAI RH 00 0 CABLE, NO. 4 COVERED SOFT DRAWN COPPER, FT 4 CNN VG 00 CONNECTOR, VISE TYPE, 6- SOL. 0- SOL. 5 CUT OT 004 CUTOUT, FUSED, 5kV BIL, 00 AMP, 7kV 6 FUS OH *** GENERAL CODE FOR T-LINK FUSES 7 GUA AN 00 GUARD, ANIMAL, FOR USE WITH TRANSFORMERS AND ARRESTERS 8 GUA AN 006 GUARD, ANIMAL, FOR USE WITH FUSE CUTOUTS, SILICONE RUBBER 9 WAS RD 005 WASHER, ROUND, IN. DIA., FOR /4 IN. BOLT 0 WAS SF 00 WASHER, SQUARE, FLAT, IN., FOR /4 IN. BOLT WAS SP 00 WASHER, SPRING, DOUBLE HELIX, FOR /4 IN. BOLT IV Page 5 of 7

6 DUC THREE-PHASE RISER 6.4kV (RUC 4kV, WUC.kV) OPTIONS: 0T, T, 5T, 0T, 5T, 0T, 40T, 50T, 65T, 80T, 00T 9 6 ARR LI *** ARRESTER, LIGHTNING, POLYMER, kv, 0kV, or 8kV BKT AC 00 BRACKET, ARRESTER AND CUTOUT, TRI-MOUNT CAI RH 00 5 CABLE, NO. 4 COVERED SOFT DRAWN COPPER, FT 4 CNN VG 00 CONNECTOR, VISE TYPE, 6- SOL. 0- SOL. 5 COB CO 08 5 CONDUCTOR, BARE COPPER, #4 SOFT DRAWN 6 CUT OT 004 CUTOUT, FUSED, 5kV BIL, 00 AMP, 7kV 7 FUS OH *** GENERAL CODE FOR T-LINK FUSES 8 GUA AN 00 GUARD, ANIMAL, FOR USE WITH TRANSFORMERS AND ARRESTERS 9 GUA AN 006 GUARD, ANIMAL, FOR USE WITH FUSE CUTOUTS, SILICONE RUBBER 0 WAS RD 005 WASHER, ROUND, IN. DIA., FOR /4 IN. BOLT WAS SF 00 WASHER, SQUARE, FLAT, IN., FOR /4 IN. BOLT WAS SP 00 WASHER, SPRING, DOUBLE HELIX, FOR /4 IN. BOLT IV Page 6 of 7

7 DUCF (FIBERGLASS CONSTRUCTION) THREE-PHASE RISER 6.4kV (RUCF 4kV, WUCF.kV) OPTIONS: 0T, T, 5T, 0T, 5T, 0T, 40T, 50T, 65T, 80T, 00T 7 5 ARR LI *** ARRESTER, LIGHTNING, POLYMER, kv, 0kV, or 8kV BKT AC 00 BRACKET, FIBERGLASS, ARRESTER AND CUTOUT, TRI-MOUNT CAI RH 00 0 CABLE, NO. 4 COVERED SOFT DRAWN COPPER, FT 4 CNN VG 00 CONNECTOR, VISE TYPE, 6- SOL. 0- SOL. 5 CUT OT 004 CUTOUT, FUSED, 5kV BIL, 00 AMP, 7kV 6 FUS OH *** GENERAL CODE FOR T-LINK FUSES 7 GUA AN 00 GUARD, ANIMAL, FOR USE WITH TRANSFORMERS AND ARRESTERS 8 GUA AN 006 GUARD, ANIMAL, FOR USE WITH FUSE CUTOUTS, SILICONE RUBBER 9 WAS RD 005 WASHER, ROUND, IN. DIA., FOR /4 IN. BOLT 0 WAS SF 00 WASHER, SQUARE, FLAT, IN., FOR /4 IN. BOLT WAS SP 00 WASHER, SPRING, DOUBLE HELIX, FOR /4 IN. BOLT IV Page 7 of 7