4-Way Mixing Panel Submittal - Page 1 of 6

Transcription

1 Submittal - Page 1 of 6 Job or Customer : Location : Engineer : Complies with Spec Alternate Notes : Contractor : Heat Rep : Submitted By : Date : Approved By : Date : P.O. Number : Date : Description These panels provide outdoor reset control with a secondary pump, 4-way rotary mixing valve, and -Point Floating Mixing Valve Motor. Qty Stk. # Circulator 4WMIX Ferrous, Grundfos UPS26-99FC 4WMIXHH Ferrous, Grundfos UPS26-150FC Technical Data Specifications Model Number 4WMIX 4WMIXHH Max ambient temperature 0ºF (49ºC) Max operating temperature 200ºF (9ºC) Max operating pressure 5 psi (862 kpa) Temperature Control Method 4-Way Mixing Valve w/motor Temperature Control Range ºF (10-82ºC) Mixing Control 155 Compact Mixing Reset Control* Power supply 0/24 V(ac) Pump Grundfos UPS Pump Grundfos UPS Piping 1 04SS Tubing, 1 Brass Piping connections 1½ MNPT Material - backplate 16 Gauge galvanized steel Material - enclosure Powder coated steel Standards / Listings CAN/CSA-C22 No.14, UL508 cetlus *See also SUB155

2 Heat Submittal - Page 2 of 6 Panel Configurations 7 7 UL MAX. FlUID TEMP Û) FOR INDOOR USE ONLY U LISTED L 99K4 1/1 (A) SOME UNION NUTS MAY BECOME LOOSE AND CONSEQUENTLY LEAK THROUGH TRANSPORTATION VIBRATION AND HANDLING. DO NOT OVERTIGHTEN UNION NUTS WHEN CORRECTING THIS. P 1 (w) WARRANTY ON PUMPS VOID IF RUN DRY! TYPE 2 Class H T H E R M A L LY PROTECTED FOR INDOOR USE ONLY MAX. FlUID TEMP Û) C WARRANTY ON PUMPS VOID IF RUN DRY! Heat Group Inc. 460E - 1th Street NE Calgary, Alberta, Canada T2E 6M Phone: (40) Fax: (40) WARNING!!! Consult Manual Before Use Heat Group Inc. 460E - 1th Street NE Calgary, Alberta, Canada T2E 6M Phone: (40) Fax: (40) AVERTISSEMENT!!! Consulter le manual avant l usage MODEL #: WMIX Serial #: XXX-XXXX Before servicing, disconnect power supply M A D E I N AVERTISSEMENT!!! Consulter le manual avant l usage Serial #: XXX-XXXX Phase/Freq: 1/60 Cycles D.O.M: Jun 9, 2017 Phase/Freq: 1/60 Cycles Max Temp: 100C/2F Max Pres: 5psi/862kPa Max Temp: 100C/2F Volts: 0/24 VAC Amps: Maximum 15 Volts: 0/24 VAC Amps: Maximum 15 Conforms to Std CAN/CSA C22.2 No. 14 Conforms to Standard UL MADE IN CANADA CAUTION WARNING!!! Consult Manual Before Use MODEL #: WMIX D.O.M: Jun 9, 2017 Max Pres: 5psi/862kPa Conforms to Std CAN/CSA C22.2 No. 14 Conforms to Standard UL WARNING HOT This product may have hot fluid circulating through it. DO NOT TOUCH! SOME UNION NUTS MAY BECOME LOOSE AND CONSEQUENTLY LEAK THROUGH TRANSPORTATION VIBRATION AND HANDLING. DO NOT OVERTIGHTEN UNION NUTS WHEN CORRECTING THIS. 2 ADJUST LIVE Outdoor Sensor P/N: PC:P1 099 ENC 2 US 5 GROUND NEUTRAL Heat Demand 1 Type UPS F 1 PH 5 V 60 Hz 40 uf CAUTION 5 VOLTS ONLY LIVE To Boiler IMPEDANCE PROTECTED 99K4 (Aux Contacts) US Class F C US LISTED 4 Heat Demand P/N: P1 PC: 099 1/1 (A) C Outdoor Sensor 1 Type UPS FC 5 V 1 PH 60 Hz 20 uf ADJUST NEUTRAL To Boiler CAUTION 5 VOLTS ONLY P 1 (w) GROUND (Aux Contacts) MADE IN CANADA Any alterations to electrical wiring and controls renders warranty null & void. Installation must conform to local codes. Check valve(s) if required are the installers responsibility. CAUTION Before servicing, disconnect power supply WARNING HOT This product may have hot fluid circulating through it. DO NOT TOUCH! C A N A D A M A D E I N Any alterations to electrical wiring and controls renders warranty null & void. Installation must conform to local codes. Check valve(s) if required are the installers responsibility. C A N A D A

3 Submittal - Page of 6 Panel Components # Components Component Description 1 pump 2 1¼ Mixing valve (hidden) -point Mixing Valve Motor 4 Mixing reset control 5 0V(ac) Terminal block Moves the heated fluid through the system when there is a call for heat from the system controller. 4-way brass mixing valve regulates the temperature in the hydronic system with the help of the electric motor actuator and system controller. Mounted to the control valve and moves the valve appropriately to allow the heated fluid to enter. Works in conjunction with the system controller. The system controller regulates the panel operation. Wiring input for 0V(ac) panel power supply. Part Number 4WMIX 4WMIXHH UPS26-99 UPS n/a 6 Heat demand terminal block Wiring input for heat demand. n/a 7 sensor 8 24V(ac) transformer Temperature sensor on the system supply piping. Converts power for the Mixing Reset Control n/a 9 Electrical Box Houses transformer wiring. n/a 10 Balancing valve Adjusts flow. n/a Thermometer Shows system temperature. n/a Isolation valve assemblies* Zone valve used to isolate the panel from the system during fill & purge, and maintenance. n/a *Packaged in accessory box for shipping.

4 Submittal - Page 4 of 6 Enclosure and Panel Dimensions 24" Heat 18-4 " 7-4 " 6" "

5 Submittal - Page 5 of 6 Pump Technical Data Material Inlet cone, bearing plate, bearing retainers, rotor can, rotor cladding, shaft retainer Stator housing Shaft, upper and lower radial bearings Thrust bearing Check valve Pump housing (volute) O-ring and gaskets Impeller Terminal box Model Number UPS 26-99FC UPS FC Stainless steel Aluminum Aluminum oxide ceramic Carbon bearing and EPDM retainer ACETA with 02 SS spring and nitrile rubber seats Cast iron EPDM PES composite (0% glass filled) Noryl with EPDM gasket Flow range 0- US gpm (0-7.5 m /h) 0-5 US gpm (0- m / h) Head range 0-29 ft(0-8.8 m) 0-46 ft (0-14 m) Motors 2-pole, single phase Max. liquid temperature 20ºF (0ºC) Min. liquid temperature 6ºF (2ºC) Max. system temperature 145 psi (10 bar) UPS26-99FC Pump Curve Head (feet) Speed Volts Amps Watts Hp Capacitor / /6 20 μf/180v / Flow (gpm) 1st Speed 2nd Speed rd Speed UPS Pump Curve 2 1 Speed Volts Amps Watts Hp Capacitor / /6 40 μf/180v /6

6 Submittal - Page 6 of 6 Technical Data - 4 Way Mixing Valve Mixing Valve Nominal Size: " Mixing Valve Cv: Material - Valve Body & Slide:...Brass DZR Material - Shaft & Bushing:...PPS composite Material - O-ring:...EPDM Max. Operating Temperature:...20 F (0 C) Min. Operating Temperature: F (-10 C) Max. Operating Pressure: psi (10 bar) Max. Differential Pressure: psi (1 bar) Leaking in % of flow*:...<1.0% Max. Torque:...<44lbf*in (<5Nm) Flow [%] Opening angle [ ] *based on diff. pressure of 14.5 psi (1 bar) Technical Data Ambient Temperature:...2 to F (-5 to 55 C) Power :...24Vac ± 10%, 50/60 Hz Enclosure Rating:...NEMA 1, IP41 Protection Class:...II Torque: lbf.in (6 Nm) Power Consumption:...2 VA Angle of Movement:...90 Running Time 90 :...96 sec Control Signal...-point SPDT The motor should be preceded by a multi-pole contact breaker in the fixed installation. M CCW bk CW bn N bu LVD 2006/95/EC EMC 2004/108/EC RoHS 2002/95/EC Installation Installation must follow all of Heat's instructions and guidelines. Maintenance Maintenance must follow all of Heat's instructions and guidelines. Related Documents Operation, Installation, and Maintenance Manual L6 4WMIX Snow Melt Control Submittal SUB155 Heat Limited Heating Warranty