AWRON Display E9xDGA. Installation Manual E90/E91/E92/E93. BMW E90 Limousine / LCI E91 Touring / LCI E92 Coupe / LCI E93- Cabrio / LCI

Size: px

Start display at page:

Download "AWRON Display E9xDGA. Installation Manual E90/E91/E92/E93. BMW E90 Limousine / LCI E91 Touring / LCI E92 Coupe / LCI E93- Cabrio / LCI"

Roy Robbins
5 years ago
Views:

1 Seite: 1 AWRON Display E9xDGA Installation Manual E90/E91/E92/E93 BMW E90 Limousine / LCI E91 Touring / LCI E92 Coupe / LCI E93- Cabrio / LCI

2 Seite: 2 Table of Contents Table of Contents 2 Scope of delivery 3 Toolkit 4 Cabel system 5 Schematic 6 Installation Guide Disassembly interior trim 7 Cable installation on passenger footwell side 8 Pin Belegung Junction-Box 12 Diesel sensor connection (ONLY FOR DIESEL ENGINES) 13 Mounting AWRON display 16 Support & FAQs 15

3 Seite: 3 Scope of delivery E9xDGA Display modul Power cord set

4 Screwdriver TORX T20 Socket wrench 8mm Flat screwdriver 2mm Installation Instr. : E9xDGA Seite: 4 Toolkit Mounting wedge 2mm Assembly tool

5 150cm USB Installation Instr. : E9xDGA Seite: 5 Schematic

6 Seite: 6 Schaltplan

Seite: 7 Disassembly interior trim Use mounting wedge

7 Seite: 7 Disassembly interior trim Use mounting wedge Solve with a plastic wedge the interior trim. Start from the right. Look for the connector at the start button and the control panel warning lights, etc. (see picture below right) Disconnect the connectors, then they can remove the bar. Use mounting wedge Use mounting wedge

Seite: 8 Cable installation on passenger footwell side Contact must be switched off or put the key in the

For this operation use Thorax T20 You can cover the now lower approx 20 cm - a remove is not necessary.

shaft down into the passenger footwell. For better moving the cable you can use the pulling rod.

8 Seite: 8 Cable installation on passenger footwell side Contact must be switched off or put the key in the ignition lock mandatory! Remove the screws marked in the picture of the footwell cover. For this operation use Thorax T20 You can cover the now lower approx 20 cm - a remove is not necessary. Screwdriver TORX T20 Now pull the cable (cable color red and blue / red + USB cable) from the ventilation shaft down into the passenger footwell. For better moving the cable you can use the pulling rod. No tools required Unlock now the blue plug of the junction box and disconnect it. Now remove the blue housing of the plug to get to the pins. No tools required

Seite: 9 Cable installation on passenger footwell side Contact must be switched off or put the key in the

Pin Now cable Red (PIN2) from the plug and replace it with red cable of the currently installed harness.

No tools required Now insert two pins of the vehicle wiring harness into connector housing.

9 Seite: 9 Cable installation on passenger footwell side Contact must be switched off or put the key in the ignition lock mandatory! Pin Now cable Red (PIN2) from the plug and replace it with red cable of the currently installed harness. No tools required Implement this step with cable blue / red (PIN 1). No tools required Now insert two pins of the vehicle wiring harness into connector housing. Orientate and pay attention on the color of the AWRON wire. Now connect the connector to the wire harness. Then the blue housing can be slid back on the connector. The blue plug and reconnect with latches to the junction box. The panel can now be reassembled. No tools required

10 Seite: 10 Cable installation on passenger footwell side Contact must be switched off or put the key in the ignition lock mandatory! When you pull the cable, the mains plug should be in the middle of the vent (see in the image above)

11 Seite: 11 Cable installation on passenger footwell side Junction box installation point Bil d 1 Power distribution 2 Junction box control unit

The blue plug is always the CAN, and the power supply to the black.

12 Seite: 12 Pin Belegung Junction-Box ATTENTION: The Blue connectors can be located on either the left or right side of the junction box depending on the year. Important! The blue plug is always the CAN, and the power supply to the black. Pin X blue pinpolig Cable color 1 PT-CAN_HIGH BL/RT 0.35mm² 2 PT-CAN_LOW RT 0.35mm² Pin X black pin Cable color 1 Kl. 30G GREEN/BROWN 0.35mm² 6 MASS BROWN 0.35mm²

13 Seite: 13 Diesel sensor connection (ONLY FOR DIESEL ENGINES) Connect help wire from cabine to motor space as you can see on picture Connect help wire from cabine to motor space as you can see on picture

14 Seite: 14 Diesel sensor connection (ONLY FOR DIESEL ENGINES) Attach diesel cabel on wire (use some duct tape) which have you install in previous step At this step you need to pull the wire from interior into motor space

15 Seite: 15 Diesel sensor connection (ONLY FOR DIESEL ENGINES) At final step you need to attach cable with oil temperature sensor. When you re finished with it u just need to wire a wire via engine space and attach sensor on oil carter (replace it with old one).

Unclip the air ventilation duct from the interiors of the bar.

16 Seite: 16 Mounting AWRON display Socket wrench 8mm With a socket wrench 8mm remove the socket wrench, and also remove the two marked nuts (see picture). Unclip the air ventilation duct from the interiors of the bar. For this purpose, can be re-used the plastic mounting wedge. No tools required Press the operating unit out of the front, now this is unplugged.

Seite: 17 Mounting AWRON display No tools required Clip the new ventilation duct with the AWRON display in your interior trim and carefully remove the nuts.

17 Seite: 17 Mounting AWRON display No tools required Clip the new ventilation duct with the AWRON display in your interior trim and carefully remove the nuts. The AWRON display can now be connected to the wiring harness and installed. Now close the Start button and run the cable out of the control element between the display and demister. Then, the interior trim are installed in reverse order. Now connect the two plugs to the control element and push it in from the front.

18 Seite: 18 Support & FAQ For all enquiries concerning your AWRON display system, or if you have problems with installation guide the AWRON support team at are at your service. Please also seen us and our another AWRON products on our website

AWRON Display E9xDGA. Installation Manual E90/E91/E92/E93. BMW E90 Limousine / LCI E91 Touring / LCI E92 Coupe / LCI E93- Cabrio / LCI

AWRON Display E9xDGA. Installation Manual E90/E91/E92/E93. BMW E90 Limousine / LCI E91 Touring / LCI E92 Coupe / LCI E93- Cabrio / LCI Seite: 1 AWRON Display E9xDGA Installation Manual E90/E91/E92/E93 BMW E90 Limousine / LCI E91 Touring / LCI E92 Coupe / LCI E93- Cabrio / LCI Seite: 2 Table of Contents Table of Contents 2 Scope of delivery