Restriction of the use of certain hazardous substances (RoHS) Summary Report

Transcription

1 JJ Electronic S.R.O A. Hlinku Čadca Slovak Republic Restriction of the use of certain hazardous substances (RoHS) Summary Report Test of: Vacuum Tube Model Number: EL34 Unique Identifier: None Supplied Applicant: JJ Electronic Test Type: XRF Scan Test Specification: IEC 62321:2008 Date of Receipt: 12 th July 2013 Date of Test(s): 17 th July 2013 Date of Issue: 17 th July 2013 Issue Number: 1 Conclusion: Based on the performed tests on submitted samples, the results indicate no conflict with the ROHS Directive 2011/65/EU and its subsequent amendments. See page 3 of the report for test results This document is issued by the Company subject to its General Conditions of Service available on request or accessible at and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company s findings at the time of its intervention only and within the limits of Client s instructions, if any. The Company s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 28 days only. Authorised Signatory Fred Huggins Principal Test Engineer Page 1 of 7 SGS United Kingdom Ltd Unit 12A & 12B Bowburn South Industrial Estate, Bowburn, Durham DH6 5AD Tel +44 (0) Fax +44 (0) Registered in England No Rossmore Business Park, Ellesmere Port Cheshire CH65 3EN Member of SGS Group (SGS SA)

2 Page 2 of 7 Notes on Findings When inconclusive levels are obtained this denotes that the element cannot be accurately measured due to the close proximity of a non restricted element with similar fluorescence characteristics. I/M denotes that insufficient material has been supplied to gain a useable measurement. XRF scanning indicates total Bromine presence, and cannot determine the presence of PBB or PBDEs. Only wet chemical analysis can confirm the level and presence of PBB or PBDEs. XRF scanning indicates total Chromium presence, and cannot isolate the presence of Chromium 6. Only wet chemical analysis can confirm the level and presence of Chromium 6. The maximum permitted limits are quoted from RoHS directive 2011/65/EU Rohs Restricted substances in Homogenous materials Maximum permissible Limit (mg/kg) Cadmium Cd 100 Lead Pb 1000 Mercury Hg 1000 Hexavalent Chromium (Cr VI ) 1000 Polybrominated biphenyls (PBBs) 1000 Polybrominated diphenylethers (PBDE s) 1000

3 Page 3 of 7 Test Results No. Sample Results Description Cd Pb Hg Cr Br 1 Glass Outer Casing BL BL BL BL BL 2 Metallic Pin BL BL BL BL BL 3 Metallic Ring BL BL BL BL BL 4 Plastic Film BL BL BL BL BL 5 Thin Metallic Film BL BL BL BL BL 6 Metallic Stop BL BL BL BL BL 7 Copper Support BL BL BL BL BL 8 Metallic Support BL BL BL BL BL 9 Metallic Tube BL BL BL BL BL 10 Thin Metallic Wire BL BL BL BL BL 11 Connector BL BL BL BL BL 12 Plastic Outer Casing BL BL BL BL BL 13 Thick Metallic Film BL BL BL BL BL Note: BL = Below Limit OL = Over Limit X = Further investigation needed All readings were below the limits. No further investigation needed

4 Page 4 of 7 Screening limits in mg/kg for regulated elements Element Polymer Materials Metallic Materials Composite Material Cd Pb Hg BL (70-3σ) < X < (130+3σ) OL BL (70-3σ) < X < (130+3σ) OL LOD < X < (150+3σ) OL BL (500-3σ) < X < (1500+3σ) OL BL (500-3σ) < X < (1500+3σ) OL Br BL (300-3σ) < X --- BL (250-3σ) < X Cr BL (700-3σ) < X BL (700-3σ) < X BL (500-3σ) < X Notes: BL/OL = A BELOW LIMIT (BL) or OVER LIMIT (OL) determination will be set at 30 % (50 % for composite materials) less than or greater than the limit, respectively. X = the symbol X marks the region where further investigation is necessary. LOD = Limit of Detection σ = standard deviation

5 th Issue date: 17 July 2013 TEST Page 5 of 7 Photograph of Samples Tested Glass Outer Casing 3. Metallic Ring 5. Thin Metallic Film 7. Copper Support 9. Metallic Tube 11. Connector 13. Thick Metallic Film 2. Metallic Pin 4. Plastic Film 6. Metallic Stop 8. Metallic Support 10. Thin Metallic Wire 12. Plastic Outer Casing

6 Page 6 of 7 Photographs

7 TEST Page 7 of 7 th Issue date: 17 July 2013