SCA(ALL)-HA3-EN SCA(ALL)-HA3. hardware START-CAN

Transcription

1 install guide S(LL)-H-EN firmware S(LL)-H hardware STRT-N Document number 00 Revision Date 000 NOTIE The manufacturer will accept no responsability for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill & knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work. utomotive Data Solutions Inc. 0

2 Page of 9 DO.: # vehile list - Of DIsaRm OEm alarm DOOR lok DOOR unlok TRuNK/haTh RElEasE DOOR stat OuTPuT TRuNK stat OuTPuT hood stat OuTPuT TahOmETER OuTPuT E-bRaKE OuTPuT brake PEDal stat OuTPuT ZDX Regular key 0- ccord 08- ccord rosstour Regular key 0- ivic ivic Hybrid R-V Odyssey - Pilot 09- utomotive Data Solutions Inc. 0 S(LL)-H-EN POwER sliding DOOR (R) arm OEm alarm 09- POwER sliding DOOR (l) DaTa ImmObIlIZER bypass 09- TSX POwER liftgate YEaR TL w/o push to start INsTall TYPE model honda aura make features

3 Page of 9 DO.: # TYPE - wire hart - Of aura TL w/o push to start TSX ZDX Regular key ccord honda ccord rosstour Regular key Odyssey Pilot utomotive Data Solutions Inc OmPONENT loator module loation POlaRITY wire OlOR POsITION TYPE OlOR NamE wire DEsRIPTION YEaR model make ONNETOR 0 Yellow 0 LtGreen 0 Pink 0 lue 0 Yellow 0 LtGreen 0 Pink 0 lue 0 Yellow 0 LtGreen 0 Pink 0 lue 0 Yellow 0 LtGreen 0 Pink 0 lue 0 Yellow 0 LtGreen 0 Pink 0 lue 0 Yellow 0 Purple 0 Pink 0 lue 0 rown 0 Pink 0 0 LtGreen S(LL)-H-EN

4 TYPE - WIRING DIGRM - OF Page of 9 DO.: # MODULE IGNITION SWITH IGNITION - 0 DT - 0 NL - 0 NH - 0 F D E 0 GRY/YELLOW (N) 0 GRY/RED - RKE STTUS OUTPUT 0 GREEN/YELLOW (N) 0 GREEN/RED (N) 0 LUE/YELLOW (N) 0 LUE/RED (N) 0 PINK - IGNITION INPUT 0 PINK/LK (N) 0 ORNGE - SW 0 ORNGE/WHITE (N) 0 ORNGE/LK - KEY DT 0 ROWN/YELLOW - NL 0 ROWN/RED - NH 0 YELLOW - HOOD STTUS (-) OUTPUT 0 YELLOW/RED - TRUNK STTUS (-) OUTPUT 0 YELLOW/LK - DOOR STTUS (-) OUTPUT 0 WHITE - GROUND (-) 0 WHITE/RED (N) 0 WHITE/LK (-) OUTPUT 0 LUE/WHITE - GWR (-) INPUT 0 WHITE (N) 0 LK - GROUND 0 RED - V NOTE SINE THE MODULE INLUDES DISRM INPUT FETURE, OTH UNLOK EFORE STRT ND LOK FTER STRT FETURES RE NOT REQUIRED. D ONNET TO DRIVER DOOR PIN TO TURN OFF HEDLMP ON VEHILES EQUIPPED WITH UTOMTI HEDLMP DRIVER DOOR PIN E REMOTE STRTER RKE STTUS INPUT HOOD STTUS (-) INPUT TRUNK STTUS (-) INPUT DOOR STTUS (-) INPUT GWR (-) OUTPUT GROUND (-) V LOK/RM (-) OUTPUT UNLOK (-) OUTPUT TRUNK/LIFTGTE (-) OUTPUT DISRM (-) OUTPUT LEFT SLIDING DOOR (-) OUTPUT RIGHT SLIDING DOOR OR TILGTE WINDOW (-) OUTPUT STRTER OUTPUT E-RKE STTUS (-) INPUT TH () INPUT F GREEN/LK - LOK/RM (-) INPUT 0 LUE/LK - UNLOK (-) INPUT 0 RED/WHITE - TRUNK/LIFTGTE (-) INPUT 0 ROWN - DISRM (-) INPUT 0 PURPLE/YELLOW - LEFT SLIDING DOOR (-) INPUT 0 PURPLE/LK - RIGHT SLIDING DOOR OR TILGTE WINDOW (-) INPUT 0 WHITE (N) 08 LK/WHITE - STRTER INPUT 09 GREEN - E-RKE STTUS (-) OUTPUT 0 PURPLE/WHITE - TH () OUTPUT utomotive Data Solutions Inc. 0 S(LL)-H-EN

5 Page of 9 DO.: # TYPE - wire hart - Of honda ivic/ivic Hybrid R-V utomotive Data Solutions Inc. 0 OmPONENT loator module loation POlaRITY wire OlOR POsITION TYPE OlOR NamE wire DEsRIPTION YEaR model make ONNETOR 0 Yellow switch 0 Pink switch 0 lue switch 0 LtGreen switch Lock lue* (-) Driver door harness Unlock Gray (-) Driver door harness 0 Dklue switch 0 Pink switch 0 lue switch 0 Yellow switch Lock Green (-) Driver door harness Unlock Gray (-) Driver door harness S(LL)-H-EN

6 TYPE - WIRING DIGRM - OF Page of 9 DO.: # MODULE IGNITION SWITH IGNITION - 0 KEY DT - 0 NL - 0 NH - 0 F D E 0 GRY/YELLOW (N) 0 GRY/RED - RKE STTUS OUTPUT 0 GREEN/YELLOW (N) 0 GREEN/RED (N) 0 LUE/YELLOW - DOORLOK 0 LUE/RED - GROUND (-) INPUT 0 PINK - IGNITION INPUT 0 PINK/LK (N) 0 ORNGE (N) 0 ORNGE/WHITE (N) 0 ORNGE/LK - KEY DT 0 ROWN/YELLOW - NL 0 ROWN/RED - NH 0 YELLOW - HOOD STTUS (-) OUTPUT 0 YELLOW/RED - TRUNK STTUS (-) OUTPUT 0 YELLOW/LK - DOOR STTUS (-) OUTPUT 0 WHITE - LOK (-) 0 WHITE/RED - UNLOK (-) 0 WHITE/LK 0 LUE/WHITE - GWR (-) INPUT 0 WHITE (N) 0 LK - GROUND 0 RED - V D LOK (-) UNLOK (-) DRIVER DOOR HRNESS E REMOTE STRTER F GREEN/LK - LOK/RM (-) INPUT 0 LUE/LK - UNLOK (-) INPUT 0 RED/WHITE - TRUNK (-) INPUT 0 ROWN - DISRM (-) INPUT 0 PURPLE/YELLOW - GROUND (-) INPUT 0 PURPLE/LK (N) 0 WHITE (N) 08 LK/WHITE - STRTER INPUT 09 GREEN - E-RKE STTUS (-) OUTPUT 0 PURPLE/WHITE - TH () OUTPUT utomotive Data Solutions Inc. 0 RKE STTUS INPUT HOOD STTUS (-) INPUT TRUNK STTUS (-) INPUT DOOR STTUS (-) INPUT GWR (-) OUTPUT GROUND (-) V LOK/RM (-) OUTPUT UNLOK (-) OUTPUT TRUNK (-) OUTPUT DISRM (-) OUTPUT STRTER OUTPUT E-RKE STTUS (-) INPUT TH () INPUT ONNET TO GROUND TO ENLE UTOMTI RELOK FTER STRT S(LL)-H-EN

7 PROgRammINg PROEDuRE - Of 0 Page of 9 DO.: # Insert key into ignition. ON STRT OFF 0 Turn key to ON position. ON STRT OFF 0 Wait, LED will turn solid GREEN for seconds. 0 Turn key to OFF position. OFF ON STRT 0 Press UNLOK on the OEM remote. 0 Module Programming Procedure completed. utomotive Data Solutions Inc. 0 S(LL)-H-EN

8 Page 8 of 9 DO.: # module DIagNOsTIs - Of DURING PROGRMMING DURING REMOTE STRT WITH IGNITION OFF LED flashing RED: Missing/wrong information from firmware or vehicle. LED flashing RED: Module incorrectly programmed. LED flashing RED: Module incorrectly programmed or connected. LED solid RED: Module waiting for more vehicle information. LED solid RED: Module incorrectly programmed. LED solid RED: Module not programmed waiting for more vehicle information. LED flashing GREEN: dditional steps required to complete module programming. LED flashing GREEN: Module correctly programmed and operational. LED flashing GREEN: False ground when running status from remote starter. LED solid GREEN then OFF: Module correctly programmed. LED solid GREEN then OFF: Reset in progress. LED solid GREEN then OFF: Reset in progress. LED OFF: No activity or module already programmed. LED OFF: Invalid ground when running status from remote starter. LED OFF: Module at rest and ready for a remote start sequence. utomotive Data Solutions Inc. 0 S(LL)-H-EN

9 module REsET - Of 0 Disconnect all connectors from module except the black -PIN connector. 0 Reconnect all connectors. 0 Disconnect the black -PIN connector. 08 Repeat programming procedure. 0 PRESS ND HOLD programming button while connecting -PIN connector. >> Failure to follow procedure may result with a DT or a HEK ENGINE error message. 0 Wait, LED will flash RED. RELESE programming button. 0 LED will turn RED for seconds. 0 Module RESET completed. utomotive Data Solutions Inc. 0 S(LL)-H-EN Page 9 of 9 DO.: #00 000