Page 1 of 5 TI-P328-01 CH Issue 1 PN9400 Series ISO 9001 Pneumatic Actuators for SPIRA-TROL K and L Series Control Valves Cert. No. LRQ 0963008 Description The PN9400 series actuators are a compact range of linear actuators that are available with a single operating diaphragm size for matching the requirements of DN125 to DN200 SPIRA-TROL valves at various differential pressures. Each actuator is fitted with a mechanical travel indicator and incorporates a fully-rolling diaphragm, which provides good linearity over the operating stroke. Technical data Temperature range -40 C to + 80 C Maximum operating inlet pressure Air supply connection Actuator travel 6 bar g ¾" NPT 80 mm Available types PN = Standard Optional extra Manual handwheel Suffix E = Spring-extend Suffix R = Spring-retract Suffix H J G H F Dimensions and weights (approximate) in mm and kg Actuator F G H J Actuator Weight with handwheel PN9400E and variants 719 520 1 144 400 120 144 PN9400R and variants 719 520 1 144 400 120 144 Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. Copyright 2009
Page 2 of 5 Materials No. Part Material 1 Upper / lower diaphragm housing 1.0335 / pulverbe 60 80 micron 2 Diaphragm plate Carbon steel 3 Spring position plate Carbon steel 4 Spindle Stainless steel 5 Spacer Carbon manganese steel 6 Support disc Carbon manganese steel 7 Guide bush Stainless steel 8 Guide pin Stainless steel 9 Guide roller Stainless steel 10 Adaptor Stainless steel 11 Cover Carbon manganese steel 12 Yoke Carbon manganese steel 14 Coupling Carbon manganese steel 15 Coupling Carbon manganese steel 16 Spring Spring steel 17 Diaphragm SONBR253 19 Rod seal 94AU925 20 'O' ring EPDM 70 EPDM291 21 'O' ring EPDM 70 EPDM291 22 Vent plug Polyamid 6.6 24 Thread cover PVC 25 Hex head short screw 26 Hex head long screw 28 Hex head screw 30 Hex head nut Hex head nut 32 Hex head nut 34 Tapping screw 36 Washer 39 Bearing TEF / B322D PN9400 Series Pneumatic Actuators for SPIRA-TROL K and L Series Control Valves TI-P328-01 CH Issue 1
Page 3 of 5 3 32 11 36 20 34 16 1 22 16 2 17 25 26 24 4 5 21 1 6 39 7 19 12 10 28 15 30 9 8 14 PN9400 Series Pneumatic Actuators for SPIRA-TROL K and L Series Control Valves TI-P328-01 CH Issue 1
Page 4 of 5 How to use the sizing data: The following tables supply guidance as to the sizing of the PN9400 when it is used on the SPIRA-TROL K and L series valves. Two conditions are illustrated in tabular form: Class IV shut-off - Providing shut-off of the valve to the requirements of BS 5793-4 (IEC 60534-4) Class IV. Class VI shut-off - Providing shut-off of the valve to the requirements of BS 5793-4 (IEC 60534-4) Class VI. To select a suitable actuator: - Identify the column containing the valve and gland material selected. - Identify the maximum operating pressure condition, including any transient pressures likely to occur, within the selected column. - Read back to the left hand side of the table to identify the suitable actuator for the application. For conditions outside of those illustrated please contact Spirax Sarco. PN9482E - Maximum differential pressures Class IV - Unbalanced valves Under 1.5 2.7 6 6 4 3 1 1 Over 1.5 2.7 39 39 26 26 15 15 Class VI - Unbalanced valves Under 1.5 2.7 13 12 9 9 5 5 Over 1.5 2.7 39 39 26 26 15 15 Class IV - Balanced valves Under 1.5 2.7 40 40 40 40 40 40 Over 1.5 2.7 40 40 40 40 40 40 PN9482R - Maximum differential pressures Class IV - Unbalanced valves Under 1.5 2.7 21 21 14 14 7 7 Over 1.5 2.7 22 21 14 14 7 7 Class VI - Unbalanced valves Under 1.5 2.7 28 27 19 19 11 11 Over 1.5 2.7 23 23 16 16 9 9 Class IV - Balanced valves Under 1.5 2.7 40 40 40 40 40 40 Over 1.5 2.7 40 40 40 40 40 40 PN9400 Series Pneumatic Actuators for SPIRA-TROL K and L Series Control Valves TI-P328-01 CH Issue 1
Page 5 of 5 PN9000 Selection guide Type PN = Enamel PN Series 9 = 9000 series 9 Actuator size 4 = 1 080 cm 2 4 Valve travel 8 = 80 mm 8 Spring rating 2 = 1.5 2.7 bar 2 Spring action E = Spring extend R = Spring retract E Manual override H = Handwheel (optional) H How to order / selection example: 1 off Spirax Sarco PN9482E pneumatic actuator Spare parts The only spare parts available are clearly indicated below and are common for both spring extend and spring retract versions. Available spares Diaphragm kit Spring kit A B A How to order spares Always order spares by using the description given in the column headed Available spares and state the model. B Example: 1 off Spring kit for a PN9482E pneumatic actuator. PN9400 Series Pneumatic Actuators for SPIRA-TROL K and L Series Control Valves TI-P328-01 CH Issue 1